RESUMO
In this work, the photovoltaic performance and stability of perovskite solar cells (PSCs) based on a dopant-free hole transport layer (HTL) are efficiently improved by inserting a two-dimensional (2D) interfacial layer. The benzyl ammonium lead iodide (BA2PbI4) 2D perovskite is used as an interfacial layer between the 3D CH3NH3PbI3 perovskite and two moisture-resistant dopant-free HTLs including poly[[2,3-bis(3-octyloxyphenyl)-5,8-quinoxalinediyl]-2,5-thiophenediyl] (TQ1) and poly(3-hexylthiophene) (P3HT). TQ1 with a facile synthesis procedure has a higher moisture resistivity compared to P3HT which can improve the stability of PSCs. The 2D BA2PbI4 perovskite with a less-volatile bulkier organic cation efficiently passivates the defects at the perovskite/HTL interface, leading to 11.95% and 15.04% efficiency for the modified TQ1 and P3HT based cells, respectively. For a better understanding, the structural, optical, and electrical properties of PSCs comprising P3HT and TQ1 HTLs with and without interface modification are studied. The interface modified PSCs show slower open-circuit voltage decay and longer carrier lifetimes compared to unmodified cells. In addition, impedance spectroscopy reveals lower charge transport resistance and higher recombination resistance for the modified devices, which could be associated with the modification of the interface between the 3D CH3NH3PbI3 perovskite and HTL caused by the 2D interfacial layer. Also after aging under ambient conditions for about 800 hours, the modified PCSs retain more than 80% of their initial PCEs. These results give us the hope of achieving simpler, cheaper, and more stable PSCs with dopant-free HTLs through 2D interfacial layers, which have great potential for commercialization.
RESUMO
Although the power conversion efficiency of perovskite solar cells (PSCs) reached up to 25% that made them comparable to the commercial solar cells, they are facing issues toward commercialization, especially their short lifetime. Remarkably, the most important key factors that regulate the durability of the devices are moisture, light, and heat. In this work, prolonging the device lifetime is focused by designing a flexible moisture-blocked and temperature-controlled encapsulation system. In this regard, a thermally adjusted phase change material is embedded in a polymer encapsulation layer to avoid the moisture diffusion, rapid temperature fluctuation, and undesired crystalline phase change of the perovskite layer in the PSCs under the operation condition. As a result, a 2 year stable device is achieved, whereas the reference device loses more than 50% of its performance after 10 days. Surprisingly, the charge transport resistance and recombination rate show no significant change during 450 days of storage, which confirms no increase in the defect density.
RESUMO
Although the power conversion efficiency (PCE) of perovskite solar cells (PSCs) reached up to 23%, their short lifetime and fast degradation still remain as the main challenges. In this work, a new facile optical method based on the high power UV-irradiation is presented for the recovery of the degraded PSCs. Addition to the full recovery of the performance, about 20% PCE enhancement and hystersis reduction are also achieved by UV-irradiation. UV-treatment causes modifications in both the bulk properties of the perovskite layer and the energy equilibrium at the interfaces. It is shown that UV-treatment effectively passivates the surface and grain boundaries defects in different types of the devices comprising normal and inverted configurations that is confirmed by the reduction of the density of defect states (DOS). It is proposed that UV-light passivates the shallow and deep defects by dissociation of adsorbed hydroxyl groups and water molecules during the device storage.