No microplastics in benthic eelpout (Zoarces viviparus): An urgent need for spectroscopic analyses in microplastic detection.

Monitoring the ingestion of microplastics is challenging and suitable detection techniques are insufficiently used. Thus, misidentifying natural for synthetic microfibres cannot be avoided. As part of a framework to monitor the ingestion of microplastics in eelpout, this short report addresses the accurate identification of microfibres. We show that, following visual inspections, putatively synthetic microfibres are indeed of natural origin, as ascertained by spectrometric analyses. Consequently, we call for an inclusion of spectroscopic techniques in standardized microplastic monitoring schemes.

Breast milk as a possible route of vertical transmission of dengue virus?

We report a case of vertical transmission of dengue infection. The virus was detected and quantified by reverse-transcription polymerase chain reaction in sequential blood samples from mother and child as well as in breast milk, but not in cord blood. This case poses questions about the risk of breastfeeding transmission of dengue virus.

A fast and robust method for the extraction and analysis of quaternary alkyl ammonium compounds from soil and sewage sludge.

Alkyltrimethylammonium compounds (ATMACs), dialkyldimethylammonium compounds (DADMACs) and benzylalkyldimethylethylammonium compounds (BACs) are quaternary alkylammonium compounds (QAAC), which are released into the environment in large quantities after their use in cleaning agents and disinfectants. Despite their potential role as selective agents promoting resistance against QAACs as well as antibiotics, there is a lack of data for QAACs in soil due to the lack of sensitive analytical methods. Therefore, we present a robust and fast method for the extraction and quantification of concentrations of these compounds in soil and sewage sludge. The method is based on ultrasonic extraction (USE) with a mixture of acetonitrile and HCl followed by a solid phase extraction (SPE) cleaning step and a subsequent quantification of concentrations with high performance liquid chromatography with mass spectrometry (HPLC-MS/MS) in multi mass reaction mode (MRM). The proposed method is suitable for the quantification of ATMACs (chain length C-8 to C-16), BACs (C-8 to C-18) and DADMACs (C-8 to C-16). The achieved limits of quantification (LOQ) range from 0.1 µg kg-1 to 2.1 µg kg-1. The recovery rates of spiked soil samples for non-deuterated homologues were between 47% and 57%. The analysis of sewage sludge samples and soil samples revealed that BAC-C12 was the most abundant QAAC with concentrations up to 38600 µg kg-1 in sewage sludge and up to 81 µg kg-1 in a Mexican soil that was irrigated with wastewater. Overall, the presented methods open perspectives for effectively studying fate and effects of QAACs in soils.

Development and testing of a fractionated filtration for sampling of microplastics in water.

A harmonization of sampling, sample preparation and detection is pivotal in order to obtain comparable data on microplastics (MP) in the environment. This paper develops and proposes a suitable sampling concept for waterbodies that considers different plastic specific properties and influencing factors in the environment. Both artificial water including defined MP fractions and the discharge of a wastewater treatment plant were used to verify the derived sampling procedure, sample preparation and the subsequent analysis of MP using thermal extraction-desorption gas chromatography - mass spectrometry (TED-GC-MS). A major finding of this paper is that an application of various particle size classes greatly improves the practical handling of the sampling equipment. Size classes also enable the TED-GC-MS to provide any data on the MP size distribution, a substantial sampling property affecting both the necessary sampling volume and the optimal sampling depth. In the artificial water with defined MP fractions, the recovery rates ranged from 80 to 110%, depending on the different MP types and MP size classes. In the treated wastewater, we found both polyethylene and polystyrene in different size classes and quantities.

[Cefazolin and coagulation disorders: a case report]. / Céfazoline et troubles de la coagulation : à propos d'un cas.

We report the case of a 79-year-old patient, admitted to the department of infectious diseases at Bretagne Sud Hospital Center for a right calcaneal osteitis, complicated by a pacemaker leads infectious endocarditis. Meticillin sensitive Staphylococcus aureus was documented by blood culture. Antibiotic treatment was established using intravenous cefazolin for an initial 6 weeks period. Prothrombin time (PT) decreased as well as vitamin K dependent factors, without anticoagulation therapy, at day 7 of cefazolin treatment. After bleeding occurred on calcaneal osteitis, the VAC® therapy system was removed and intravenous vitamin K 10 mg (then 5 mg per day for 5 days per os) was administered. Vitamin K allowed PT and vitamin K dependent factors to return to normal values. Literature review does not explicitly mention the effects on vitamin K dependent factors after cefazolin administration. Four severe haemorrhagic episodes under cefazolin have been declared in France so far since February 2017. The goal of this article is to alert clinicians and clinical pathologists from the potential appearance of coagulation disorders in patients treated by cefazolin.

Fast identification of microplastics in complex environmental samples by a thermal degradation method.

In order to determine the relevance of microplastic particles in various environmental media, comprehensive investigations are needed. However, no analytical method exists for fast identification and quantification. At present, optical spectroscopy methods like IR and RAMAN imaging are used. Due to their time consuming procedures and uncertain extrapolation, reliable monitoring is difficult. For analyzing polymers Py-GC-MS is a standard method. However, due to a limited sample amount of about 0.5 mg it is not suited for analysis of complex sample mixtures like environmental samples. Therefore, we developed a new thermoanalytical method as a first step for identifying microplastics in environmental samples. A sample amount of about 20 mg, which assures the homogeneity of the sample, is subjected to complete thermal decomposition. The specific degradation products of the respective polymer are adsorbed on a solid-phase adsorber and subsequently analyzed by thermal desorption gas chromatography mass spectrometry. For certain identification, the specific degradation products for the respective polymer were selected first. Afterwards real environmental samples from the aquatic (three different rivers) and the terrestrial (bio gas plant) systems were screened for microplastics. Mainly polypropylene (PP), polyethylene (PE) and polystyrene (PS) were identified for the samples from the bio gas plant and PE and PS from the rivers. However, this was only the first step and quantification measurements will follow.

Release of (14)C-labelled carbon nanotubes from polycarbonate composites.

Waste disposal of carbon nanotube (CNT) containing products is expected to be the most important pathway for release of CNTs into the environment. In the present work, the use of radiolabelled CNTs ((14)C-CNT) for polycarbonate polymer nanocomposites with 1 wt% (14)C-CNT content allowed for the first time to quantify and differentiate the CNT release according to the type of impact along the materials' ageing history. After an initial exposure of the nanocomposite by solar-like irradiation, further environmental impacts were applied to composite material. They aimed at mimicking disposal site conditions that may induce further ageing effects and CNT release. This study included shaking in water, rapid temperature changes, soaking in humic acid solution as well as waste water effluent, and, finally, gentle mechanical abrasion. All ageing impacts were applied sequentially, both on pristine (control) and on solar-irradiated nanocomposites. All experiments were accompanied by absolute quantification of radioactive release as well as chemical and morphological analyses of the nanocomposite surfaces using infra-red (IR) spectroscopy, X-ray photoelectron spectroscopy (XPS) and scanning electron microscopy (SEM). The morphological analysis showed that spectral irradiation can uncover CNT networks on the outer nanocomposite surface layers by polymer degradation. After having subjected the solar-irradiated nanocomposite to all studied disposal site effect, the total radioactive release was quantified to amount to 64 mg CNT/m(2), whereas only 0.8 mg CNT/m(2) were found for the un-irradiated control sample. Solar degradation of polymers was thus found to significantly increase the propensity of the studied polymer nanocomposites to release CNTs during ageing effects at the product's end-of-life typical for disposal sites.

Analysis of polyethylene microplastics in environmental samples, using a thermal decomposition method.

Small polymer particles with a diameter of less than 5 mm called microplastics find their way into the environment from polymer debris and industrial production. Therefore a method is needed to identify and quantify microplastics in various environmental samples to generate reliable concentration values. Such concentration values, i.e. quantitative results, are necessary for an assessment of microplastic in environmental media. This was achieved by thermal extraction in thermogravimetric analysis (TGA), connected to a solid-phase adsorber. These adsorbers were subsequently analysed by thermal desorption gas chromatography mass spectrometry (TDS-GC-MS). In comparison to other chromatographic methods, like pyrolyse gas chromatography mass spectrometry (Py-GC-MS), the relatively high sample masses in TGA (about 200 times higher than used in Py-GC-MS) analysed here enable the measurement of complex matrices that are not homogenous on a small scale. Through the characteristic decomposition products known for every kind of polymer it is possible to identify and even to quantify polymer particles in various matrices. Polyethylene (PE), one of the most important representatives for microplastics, was chosen as an example for identification and quantification.

Imaging the intracellular degradation of biodegradable polymer nanoparticles.

In recent years, the development of smart drug delivery systems based on biodegradable polymeric nanoparticles has become of great interest. Drug-loaded nanoparticles can be introduced into the cell interior via endocytotic processes followed by the slow release of the drug due to degradation of the nanoparticle. In this work, poly(L-lactic acid) (PLLA) was chosen as the biodegradable polymer. Although common degradation of PLLA has been studied in various biological environments, intracellular degradation processes have been examined only to a very limited extent. PLLA nanoparticles with an average diameter of approximately 120 nm were decorated with magnetite nanocrystals and introduced into mesenchymal stem cells (MSCs). The release of the magnetite particles from the surface of the PLLA nanoparticles during the intracellular residence was monitored by transmission electron microscopy (TEM) over a period of 14 days. It was demonstrated by the release of the magnetite nanocrystals from the PLLA surface that the PLLA nanoparticles do in fact undergo degradation within the cell. Furthermore, even after 14 days of residence, the PLLA nanoparticles were found in the MSCs. Additionally, the ultrastructural TEM examinations yield insight into the long term intercellular fate of these nanoparticles. From the statistical analysis of ultrastructural details (e.g., number of detached magnetite crystals, and the number of nanoparticles in one endosome), we demonstrate the importance of TEM studies for such applications in addition to fluorescence studies (flow cytometry and confocal laser scanning microscopy).