RESUMO
The forsterite zone of the Ubehebe Peak contact aureole, Death Valley, USA consists of an outer zone of tabular/jack-straw olivine and an inner zone of subequant polyhedral olivine. Subequant polyhedral forsterite crystals close to the intrusion are small and tabular forsterite crystals farther away are larger. To investigate the formation of the two morphologies, forsterite growth experiments were conducted in cold seal pressure vessels in the CaO-MgO-SiO2-CO2-H2O system. Forsterite precipitation follows a disequilibrium reaction pathway made of three reactions: [1] tabular forsterite growth from quartz and dolomite, [2] forsterite growth from tremolite dissolution, and [3] subequant polyhedral forsterite growth from tabular forsterite dissolution. Initially, quartz reacts with dolomite to simultaneously form twinned tabular forsterite and tremolite. As quartz reacts away, forsterite precipitation continues at a slower rate through tremolite dissolution. A second generation of forsterite then precipitates on top of some tabular forsterite but has different habit and tracht. Once all the tremolite reacts away, subequant polyhedral forsterite precipitation continues at an even slower rate through dissolution of tabular forsterite. The tabular morphology of jack-straw olivine is a consequence of twin-mediated unidirectional growth; the abundance of twins being due to rapid nucleation and growth at initially high reaction affinities. Twin junctions are preferential nucleation centers for steps, so faceted growth is enhanced on {100}. This phenomenon is the twin plane re-entrant effect. Subequant polyhedral forsterite in the Ubehebe Peak inner contact aureole recrystallized and ripened from tabular forsterite. In the outer contact aureole, conditions were not conducive to recrystallization and ripening so well-developed tabular forsterite persists.
RESUMO
The volcanic rocks of the Chon Aike Silicic Large Igneous Province (CASP) are recognized as magmas dominantly produced by crustal anatexis. Investigating the zircon of the CASP provides an opportunity to gain further insight into geochemical and isotopic differences of the potential magmatic sources (i.e., crust versus mantle), to identify crustal reservoirs that contributed to the felsic magmas during anatexis, and to quantify the contributions of the respective sources. We present a combined zircon oxygen and hafnium isotope and trace element dataset for 16 volcanic units of the two youngest volcanic phases in Patagonia, dated here with LA-ICP-MS U-Pb geochronology at ca. 148-153 Ma (El Quemado Complex, EQC) and ca. 159 Ma (western Chon Aike Formation, WCA). The EQC zircon have 18O-enriched values (δ18O from 7 to 9.5) with correspondingly negative initial εHf values (- 2.0 to - 8.0). The WCA zircon have δ18O values between 6 and 7 and εHf values ranging between - 4.0 and + 1.5. Binary δ18O-εHf mixing models require an average of 70 and 60% melt derived from partial melting of isotopically distinct metasedimentary basements for the EQC and WCA, respectively. Zircon trace element compositions are consistent with anatexis of sedimentary protoliths derived from LIL-depleted upper continental crustal sources. The overlap between a high heat flux environment (i.e., widespread extension and lithospheric thinning) during supercontinental breakup and a fertile metasedimentary crust was key in producing voluminous felsic volcanism via anatexis following the injection and emplacement of basaltic magmas into the lower crust. Supplementary Information: The online version contains supplementary material available at 10.1007/s00410-023-02065-1.
RESUMO
The oxygen isotopic compositions of fossil foraminifera tests constitute a continuous proxy record of deep-ocean and sea-surface temperatures spanning the last 120 million years. Here, by incubating foraminifera tests in 18O-enriched artificial seawater analogues, we demonstrate that the oxygen isotopic composition of optically translucent, i.e., glassy, fossil foraminifera calcite tests can be measurably altered at low temperatures through rapid oxygen grain-boundary diffusion without any visible ultrastructural changes. Oxygen grain boundary diffusion occurs sufficiently fast in foraminifera tests that, under normal upper oceanic sediment conditions, their grain boundaries will be in oxygen isotopic equilibrium with the surrounding pore fluids on a time scale of <100 years, resulting in a notable but correctable bias of the paleotemperature record. When applied to paleotemperatures from 38,400 foraminifera tests used in paleoclimate reconstructions, grain boundary diffusion can be shown to bias prior paleotemperature estimates by as much as +0.86 to -0.46 °C. The process is general and grain boundary diffusion corrections can be applied to other polycrystalline biocarbonates composed of small nanocrystallites (<100 nm), such as those produced by corals, brachiopods, belemnites, and molluscs, the fossils of which are all highly susceptible to the effects of grain boundary diffusion.