Preformed customized healing abutments in biologically oriented preparation technique procedure: a 3-year retrospective case-control study.

AIM: To determine the 3-year clinical and dimensional change of the soft tissue following implant placement in healed sites before and after loading with either customized or conventional healing abutments. MATERIALS AND METHODS: Premolar/molar implants were immediately loaded with either provisional and customized abutments without finishing lines according to principles of the Biologically Oriented Preparation Technique (BOPT), test group, or conventional healing abutments, control group. Three months later, the definitive crowns were fabricated. Primary outcomes (changes in the soft tissue) and secondary outcomes (adverse events) had been registered. RESULT: Fifty out of 87 subjects originally included were finally selected for this retrospective analysis: 23 in the test and 27 in the control group. During the first days after surgery 2 adverse events of mucositis, one for each group, occurred. A Few technical complications such as unscrewing 4 screw-retained crowns were recorded. A significant increase in the alveolar width was observed in both groups (test = +2.5±0.5mm, and control = +1.0±0.9mm). The widths appeared to not be merely changed from 3 months to 3 years in both groups. There were no significant differences regarding the width of the keratinized mucosa measured at baseline and after follow-up. Jemt papilla index showed a higher increase in the test group compared with that of the control group. CONCLUSION: Within 3 years of the follow-up period, peri-implant soft tissue outcomes of single, immediately loaded implants with customized healing abutments showed better results in terms of thickness and width when they were compared with those of the conventional group. Side effects count (mucositis and dehiscence) appeared to be very similar between the two groups. In addition, customized healing abutments led to significant augmentation of the alveolar width more than twice that registered in the conventional group.

Treatment decision-making for a post-traumatic malocclusion in an elderly patient: A case report.

Traumatic dental injuries in elderly patients are a rising trend due to demographic and social changes of the population. Older dentulous patients in good health have become increasingly common. The development of a post-traumatic malocclusion is a common sequela resulting from mandibular condyle fracture, as in the case reported in this paper. The decision-making process led the authors to rule out conservative treatment options and to perform orthognathic surgery on an 81-year-old patient, an unprecedented report in the literature. At one-year follow-up, prophylactic therapy, a specific surgical technique, and osteotomy fixation have restored the occlusion to the pre-traumatic condition.

Standardization of three-dimensional pose of cylindrical implants from intraoral radiographs: a preliminary study.

BACKGROUND: To introduce a theoretical solution to a posteriori describe the pose of a cylindrical dental fixture as appearing on radiographs; to experimentally validate the method described. METHODS: The pose of a conventional dental implant was described by a triplet of angles (phi-pitch, theta-roll, and psi-yaw) which was calculated throughout vector analysis. Radiographic- and simulated-image obtained with an algorithm were compared to test effectiveness, reproducibility, and accuracy of the method. The length of the dental implant as appearing on the simulated image was calculated by the trigonometric function and then compared with real length as it appeared on a two-dimensional radiograph. RESULTS: Twenty radiographs were analyzed for the present in silico and retrospective study. Among 40 fittings, 37 resulted as resolved with residuals ≤ 1 mm. Similar results were obtained for radiographic and simulated implants with absolute errors of - 1.1° ± 3.9° for phi; - 0.9° ± 4.1° for theta; 0° ± 1.1° for psi. The real and simulated length of the implants appeared to be heavily correlated. Linear dependence was verified by the results of the robust linear regression: 0.9757 (slope), + 0.1344 mm (intercept), and an adjusted coefficient of determination of 0.9054. CONCLUSIONS: The method allowed clinicians to calculate, a posteriori, a single real triplet of angles (phi, theta, psi) by analyzing a two-dimensional radiograph and to identify cases where standardization of repeated intraoral radiographies was not achieved. The a posteriori standardization of two-dimensional radiographs could allowed the clinicians to minimize the patient's exposure to ionizing radiations for the measurement of marginal bone levels around dental implants.

Bilateral Harvesting of a Fibula Free Flap: Assessment of Morbidity.

PURPOSE: To investigate morbidity related to harversting of bilateral fibula free flap for head and neck reconstruction using subjective and functional tests. METHODS: Patients were retrospectively evaluated using point evaluation system (PES) and balance evaluation systems test (BESTest) questionnaires to assess morbidity related to surgery. RESULTS: Five patients were enrolled in the study. Mean PES scores was 22.2 over 24. Mean overall function assessed with BESTest was 77.6%, and the results were poorest for section I. Sections V and VI had scores of 88% and 83%, respectively, indicating that the sensory balance and gait stability of the patients were compromised only minimally. CONCLUSION: Bilateral harvesting of the fibula free flap is not associated with an increase in long-term morbidity and does not lead to significant functional impairments. Therefore, this procedure should be considered safe, and can be performed without concern regarding morbidity, when bone reconstruction with a fibula free flap is indicated.

Neonatal mandibular distraction in a patient with Treacher Collins syndrome.

The purpose of this study was to analyze a case of mandibular distraction in a case of Treacher Collins syndrome. Mandibular distraction is an adequate surgical treatment of patients with Pierre Robin sequence and represents an alternative to tracheostomy. In severe hypoplastic cases or when three-dimensional vector control or gonial angle control is necessary, extraoral bidirectional or multidirectional devices have an advantage over intraoral devices. The anchorage obtained with transfixing Kirschner wires fixed in the mandibular distal segment and symphysis is crucial in neonates for the stability of the devices. Moreover, with the use of a second pin for each bone segment, the extraoral devices allow to modify the vector orientation and consequently the shape of the newly formed mandible.

Clinical and radiographic evaluation of transalveolar two-step osteotome-mediated sinus floor elevation versus sinus augmentation with displacement of the palatal wall in lateral direction coupled to alveolar ridge split technique: A 3-year retrospective study.

INTRODUCTION: The present study aimed to examine the middle-term effects of transcrestal double-sinus elevation (TSFE) versus alveolar/palatal split expansion technique (APS) and simultaneous implant placement in the augmented sinus. NULL HYPOTHESIS: there were no differences between groups. MATERIAL & METHODS: Magnetoelectric device was used for bone augmentation and expansion techniques in long-standing edentulous patients with a deficiency in vertical height in the posterior maxilla (3mm to 4mm residual bone height): TSFE group, or two-stage process with a first transcrestal sinus floor augmentation and a second sinus floor elevation with immediate implant placement; APS group, or "dual split and dislocation" of the two cortical bony plates towards the sinus and palatal side. Volumetric and linear analyses were performed on the superimposed preoperative and postoperative 3-year computed tomography scans. The level of significance was set at 0.05. RESULTS: Thirty patients were selected for the present analysis. For both groups significant differences were found in the volume outcomes between baseline and 3-year follow-up, showing a gain of about +0.28±0.06cm3 for the TSFE group, and +0.43±0.12cm3 for the APS group, with p-values < 0.0001. However, an effective increase of the volume of the alveolar crest was registered just in the APS group (+0.22±0.09cm3). A significant increase in bone width was found in the APS group (+1.45±0.56mm with p-value < 0.0001); on the contrary, a slight width reduction of the alveolar crest was observed in the TSFE group (-0.63±0.21mm). DISCUSSION: TSFE procedure seemed to not affect the shape of the alveolar crest. APS procedures led to a higher increase of the volume available for dental implant placement and could be used in horizontal bone defects too.

Resonance Frequency Analysis to Assess the Stability of Immediate Implants: A Retrospective Clinical Trial.

Adequate implant primary stability is a key factor to obtain osseointegration and can be measured at insertion by insertion torque (IT) and at different timepoints with resonance frequency analysis (RFA), expressed as an implant stability quotient (ISQ). This retrospective study investigated the correlation between ISQ and IT at implant insertion. All patients who were eligible for this single-cohort retrospective clinical trial were treated with an immediate implant. IT parameters were recorded at implant insertion, and ISQ values were recorded at insertion and at 2-, 4-, and 12-month follow-ups. The study comprised 23 patients who received 32 implants. The mean IT value was 46.87 ± 9.66 Ncm (range: 25 to 65 Ncm), and the mean ISQ value at implant insertion was 71.45 ± 4.24 (range: 63 to 78); these values showed a statistically significant correlation (P < .0001). According to the present data and considering the implant design used in this trial, there is a statistically significant and positive correlation between IT and ISQ values. Thus, ISQ can be used as a reliable method to measure implant stability over time.

Lateral Displacement of Maxillary Sinus Palatal Wall: A 1-Year Retrospective Computerized Tomography Study.

PURPOSE: To examine the short-term outcomes of maxillary sinus augmentations consisting of laterally and apically displacing the palatal wall through a transcrestal approach. MATERIALS AND METHODS: The maxillary sinus floor was fractured in its palatal aspect by allowing a displacement in the buccal and apical direction with a magnetoelectric system. A medial displacement of the alveolar crest in its palatal bony plate was performed at the same time. Crestal bone change was investigated using superimposed preoperative and postsurgical computed tomography scans. Clinical and radiologic outcomes over 1 year were evaluated. RESULTS: A total of 18 implants were selected for retrospective volumetric and linear analyses. Sinus floor and alveolar bone augmentation surgery led to a significant increase in the bone volume (P = .0002) from 0.134 ± 0.060 cm3 to 0.639 ± 0.166 cm3, with an overall gain of +0.504 ± 0.139 cm3. No part of the implant apices appeared to protrude into the maxillary sinus at the 1-year follow-up. The width of the alveolar crest changed from 5.1 ± 0.5 mm to 6.5 ± 0.7 mm, with a significant increase of +1.4 ± 0.6 mm registered at 1 year. However, a marginal bone loss of 1.0 ± 0.8 mm was observed. When tooth positions were investigated, no significant differences between the two groups (premolars versus molars) were found. CONCLUSION: Significant and effective bone gains allowed proper placement of the dental implants but with a minimal loss of peri-implant bone volume.

Neck dissection with harmonic instruments and electrocautery: a prospective comparative study.

BACKGROUND: Harmonic instruments are becoming popular in head and neck surgeries. In this prospective, randomized study, the efficacy of the harmonic instruments and electrosurgical technique is compared. MATERIALS AND METHODS: A total of 48 patients undergoing unilateral neck dissection were divided into two groups. In one group, surgery was performed using conventional hemostatic instruments while in the other, only harmonic instruments were used. The two techniques were then compared with regard to intra- and post-operative blood loss, complications in operating time, drain, tracheotomy and nasogastric tube duration, and post-operative hospital stay. RESULTS: Differences in operative time (P = 0.647), total suction drainage (P = 0.362) and time that drains (P = 0.404), nasogastric tube (P = 0.378), and tracheotomy (P = 0.052) were kept in place and proved not significant. The average blood loss during surgery was significantly greater in the CH group (P = 0.003) as the number of hemoclips and resorbable ligature used (P = 0.002). CONCLUSIONS: In contrast to what has been reported up to now, our study did not reveal a net advantage in the use of harmonic instruments with respect to classical instruments in terms of surgical outcome. On the contrary, harmonic tools had a higher complication rate (i.e., salivary fistula and lymphatic leak) probably due to the decreased ability of this instruments to permanently close glandular structures and lymphatic ducts. In these cases, a closure technique such as electrocautery or classic knot-tying should be used.

Improving laboratory test ordering can reduce costs in surgical wards.

Background and Aim Laboratory blood tests for hospitalized patients are often overused. Excessive costs and no proof of benefit suggest re-evaluating the current approach to laboratory test ordering. The aim of the study is to improve the decision-making process of test ordering and to investigate what effect a rational, evidence-based use of laboratory test ordering in surgical wards would have on costs and healthcare resources. Methods Three-phase experimental prospective study carried out at the tertiary referral teaching hospital of Parma. Phase 1 (baseline status). The baseline status of laboratory test ordering was evaluated by recording the number of biochemical tests requested for patients undergoing elective surgery. Laboratory tests were grouped in "recommended" (RT) and "non recommended" (nRT) tests on the basis of pertinent literature. Phase 2 (improvement action): new guidelines were introduced into clinical practice. Phase 3 (feedback): Prospective data collection for first and second feedback was performed with no advance notice. Results A highly significant reduction in test ordering was found on occasion of the phases 2 and 3 of the study. The overall number of tests decreased, largely due to a decrease in the use of nRT. Conclusions Analysis was justified by the fact that most test requests proved not to be supported by clinical evidence. Inappropriate ordering of laboratory tests results in an unnecessarily high number of requests, which do not in turn improve patient management. Moreover, more appropriate, evidence-based laboratory test ordering for patients undergoing elective surgery may produce a significant reduction in costs, particularly in high-cost settings. (www.actabiomedica.it).