An artificial lung reduces pulmonary impedance and improves right ventricular efficiency in pulmonary hypertension.

OBJECTIVE: Artificial lungs may have a role in supporting patients with end-stage lung disease as a bridge or alternative to lung transplantation. This investigation was performed to determine the effect of an artificial lung, perfused by the right ventricle in parallel with the pulmonary circulation, on indices of right ventricular load in a model of pulmonary hypertension. METHODS: Seven adult male sheep were connected to a low-resistance membrane oxygenator through conduits anastomosed end to side to the pulmonary artery and left atrium. Banding of the distal pulmonary artery generated acute pulmonary hypertension. Data were obtained with and without flow through the device conduits. Outcome measures of right ventricular load included hemodynamic parameters, as well as analysis of impedance, power consumption, wave reflections, cardiac efficiency, and the tension-time index. RESULTS: The model of pulmonary hypertension increased all indices of right ventricular load and decreased ventricular efficiency. Allowing flow through the artificial lung significantly reduced mean pulmonary artery pressure, zero harmonic impedance, right ventricular power consumption, amplitude of reflected waves, and the tension-time index. Cardiac efficiency was significantly increased. CONCLUSIONS: An artificial lung perfused by the right ventricle and applied in parallel with the pulmonary circulation reduces ventricular load and improves cardiac efficiency in the setting of pulmonary hypertension. These data suggest that an artificial lung in this configuration may benefit patients with end-stage lung disease and pulmonary hypertension with right ventricular strain.

Distribution dynamics of perfluorocarbon delivery to the lungs: an intact rabbit model.

Motivated by the goal of understanding how to most homogeneously fill the lungs with perfluorocarbon for liquid ventilation, we investigate the transport of liquid instilled into the lungs using an intact rabbit model. Perfluorocarbon is instilled into the trachea of the ventilated animal. Radiographic images of the perfluorocarbon distribution are obtained at a rate of 30 frames/s during the filling process. Image analysis is used to quantify the liquid distribution (center of mass, spatial standard deviation, skewness, kurtosis, and indicators of homogeneity) as time progresses. We compare the distribution dynamics in supine animals to those in upright animals for three constant infusion rates of perfluorocarbon: 15, 40, and 60 ml/min. It is found that formation of liquid plugs in large airways, which is affected by posture and infusion rate, can result in a more homogeneous liquid distribution than gravity drainage alone. The supine posture resulted in more homogeneous filling of the lungs than did upright posture, in which the lungs tend to fill in the inferior regions first. Faster instillation of perfluorocarbon results in liquid plugs forming in large airways and, consequently, more uniform distribution of perfluorocarbon than slower instillation rates in the upright animals.

A rat lung model of instilled liquid transport in the pulmonary airways.

When a liquid is instilled in the pulmonary airways during medical therapy, the method of instillation affects the liquid distribution throughout the lung. To investigate the fluid transport dynamics, exogenous surfactant (Survanta) mixed with a radiopaque tracer is instilled into tracheae of vertical, excised rat lungs (ventilation 40 breaths/min, 4 ml tidal volume). Two methods are compared: For case A, the liquid drains by gravity into the upper airways followed by inspiration; for case B, the liquid initially forms a plug in the trachea, followed by inspiration. Experiments are continuously recorded using a microfocal X-ray source and an image-intensifier, charge-coupled device image train. Video images recorded at 30 images/s are digitized and analyzed. Transport dynamics during the first few breaths are quantified statistically and follow trends for liquid plug propagation theory. A plug of liquid driven by forced air can reach alveolar regions within the first few breaths. Homogeneity of distribution measured at end inspiration for several breaths demonstrates that case B is twice as homogeneous as case A. The formation of a liquid plug in the trachea, before inspiration, is important in creating a more uniform liquid distribution throughout the lungs.

Bioimpedance of soft tissue under compression.

In this paper compression-dependent bioimpedance measurements of porcine spleen tissue are presented. Using a Cole-Cole model, nonlinear compositional changes in extracellular and intracellular makeup; related to a loss of fluid from the tissue, are identified during compression. Bioimpedance measurements were made using a custom tetrapolar probe and bioimpedance circuitry. As the tissue is increasingly compressed up to 50%, both intracellular and extracellular resistances increase while bulk membrane capacitance decreases. Increasing compression to 80% results in an increase in intracellular resistance and bulk membrane capacitance while extracellular resistance decreases. Tissues compressed incrementally to 80% show a decreased extracellular resistance of 32%, an increased intracellular resistance of 107%, and an increased bulk membrane capacitance of 64% compared to their uncompressed values. Intracellular resistance exhibits double asymptotic curves when plotted against the peak tissue pressure during compression, possibly indicating two distinct phases of mechanical change in the tissue during compression. Based on these findings, differing theories as to what is happening at a cellular level during high tissue compression are discussed, including the possibility of cell rupture and mass exudation of cellular material.

The effect of airway wall motion on surfactant delivery.

Soluble surfactant and airway surface liquid transport are examined using a mathematical model of Marangoni flows which accounts for airway branching and for cyclic airway stretching. Both radial and longitudinal wall strains are considered. The model allows for variation of the amplitude and frequency of the motion, as may occur under a variety of ventilatory situations occurring during surfactant replacement therapy. The soluble surfactant dynamics of the thin fluid film are modeled by linear sorption. The delivery of surfactants into the lung is handled by setting the proximal boundary condition to a higher concentration compared to the distal boundary condition. Starting with a steady-state, nonuniform, surfactant distribution, we find that transport of surfactant into the lung is enhanced for increasing strain amplitudes. However, for fixed amplitude, increasing frequency has a smaller effect. At small strain amplitudes, increasing frequency enhances transport, but at large strain amplitudes, increasing cycling frequency has the opposite effect.

Surfactant-spreading and surface-compression disturbance on a thin viscous film.

Spreading of a new surfactant in the presence of a pre-existing surfactant distribution is investigated both experimentally and theoretically for a thin viscous substrate. The experiments are designed to provide a better understanding of the fundamental interfacial and fluid dynamics for spreading of surfactants instilled into the lung. Quantitative measurements of spreading rates were conducted using a fluorescent new surfactant that was excited by argon laser light as it spread on an air-glycerin interface in a petri dish. It is found that pre-existing surfactant impedes surfactant spreading. However, fluorescent microspheres used as surface markers show that pre-existing surfactant facilitates the propagation of a surface-compression disturbance, which travels faster than the leading edge of the new surfactant. The experimental results compare well with the theory developed using lubrication approximations. An effective diffusivity of the thin film system is found to be Deff = (E*gamma)/(mu/H), which indicates that the surface-compression disturbance propagates faster for larger background surfactant concentration, gamma, larger constant slope of the sigma*-gamma* relation, -E*, and smaller viscous resistance, mu/H. Note that sigma* and gamma* are the dimensional surface tension and concentration, respectively, mu is fluid viscosity, and H is the unperturbed film thickness.