Perpendicular Subcritical Shock Structure in a Collisional Plasma Experiment.

We present a study of perpendicular subcritical shocks in a collisional laboratory plasma. Shocks are produced by placing obstacles into the supermagnetosonic outflow from an inverse wire array z pinch. We demonstrate the existence of subcritical shocks in this regime and find that secondary shocks form in the downstream. Detailed measurements of the subcritical shock structure confirm the absence of a hydrodynamic jump. We calculate the classical (Spitzer) resistive diffusion length and show that it is approximately equal to the shock width. We measure little heating across the shock (<10% of the ion kinetic energy) which is consistent with an absence of viscous dissipation.

Experimentally Inferred Fusion Yield Dependencies of OMEGA Inertial Confinement Fusion Implosions.

Statistical modeling of experimental and simulation databases has enabled the development of an accurate predictive capability for deuterium-tritium layered cryogenic implosions at the OMEGA laser [V. Gopalaswamy et al.,Nature 565, 581 (2019)10.1038/s41586-019-0877-0]. In this letter, a physics-based statistical mapping framework is described and used to uncover the dependencies of the fusion yield. This model is used to identify and quantify the degradation mechanisms of the fusion yield in direct-drive implosions on OMEGA. The yield is found to be reduced by the ratio of laser beam to target radius, the asymmetry in inferred ion temperatures from the ℓ=1 mode, the time span over which tritium fuel has decayed, and parameters related to the implosion hydrodynamic stability. When adjusted for tritium decay and ℓ=1 mode, the highest yield in OMEGA cryogenic implosions is predicted to exceed 2×10^{14} fusion reactions.

Plasma Density Measurements of the Inner Shell Release.

The material release on the side opposite to the laser drive of a CH shell was probed at conditions relevant to inertial confinement fusion. The release was found to expand further with a longer scale length than that predicted by radiation-hydrodynamic simulations. The simulations show that a relaxation of the back side of the shell consistent with measurements explains the experimentally observed reduction in inertial confinement fusion implosion performance-specifically, reduced areal density at peak compression.

Implementing a microphysics model in hydrodynamic simulations to study the initial plasma formation in dielectric ablator materials for direct-drive implosions.

A microphysics model to describe the photoionization and impact ionization processes in dielectric ablator materials like plastic has been implemented into the one-dimensional hydrodynamic code LILAC for planar and spherical targets. At present, the initial plasma formation during the early stages of a laser drive are modeled in an ad hoc manner, until the formation of a critical surface. Implementation of the physics-based models predict higher values of electron temperature and pressure than the ad hoc model. Moreover, the numerical predictions are consistent with previous experimental observations of the shinethrough mechanism in plastic ablators. For planar targets, a decompression of the rear end of the target was observed that is similar to recent experiments. An application of this model is to understand the laser-imprint mechanism that is caused by nonuniform laser irradiation due to single beam speckle.

Shear wave dispersion behaviors of soft, vascularized tissues from the microchannel flow model.

The frequency dependent behavior of tissue stiffness and the dispersion of shear waves in tissue can be measured in a number of ways, using integrated imaging systems. The microchannel flow model, which considers the effects of fluid flow in the branching vasculature and microchannels of soft tissues, makes specific predictions about the nature of dispersion. In this paper we introduce a more general form of the 4 parameter equation for stress relaxation based on the microchannel flow model, and then derive the general frequency domain equation for the complex modulus. Dispersion measurements in liver (ex vivo) and whole perfused placenta (post-delivery) correspond to the predictions from theory, guided by independent stress relaxation measurements and consideration of the vascular tree structure.