A study of the effect of testing for diversification of healthcare waste sterilization and crushing facilities.

This study conducted sterilization testing under different conditions using different strains for sterilization and crushing, the intermediate healthcare waste treatment phase, and proposed strategies for diversifying corresponding facilities in addition to promoting their installation. Five indicator microorganisms were selected to test the sterilization efficiency of steam, microwave, and chemical methods. Steam sterilization testing was conducted in accordance with legal and technological standards, microwave testing was carried out according to the legal standard, and chemical sterilization employed three typical compounds. Steam and microwave sterilization achieved 99.9999 % inactivation rates for all five strains under both conditions used; whereas under the chemical sterilization analyses, sodium hypochlorite (1000 ppm) failed to meet the inactivation requirement of the fungal strain Candida albicans, requiring further investigation. Based on these findings, this study presents strategies for diversifying sterilization·crushing facilities and promoting their installation.

Characteristics of mercury emission from linear type of spent fluorescent lamp.

In order to recycle the linear type of SFL (spent fluorescent lamp), mercury from SFL should be controlled to prevent leaking into the environment. For mercury emission from SFL, mercury concentration is estimated in the parts of SFL such as glass tube, phosphor powder, and base cap using the end-cutting unit. It is also evaluated mercury emission in the effluent gas in the end-cutting unit with changing flow rate. From the results of mercury emission from SFLs, phosphor powder has greater than 80% of mercury amount in SFL and about 15% of mercury amount contained in glass tube. The initial mercury concentration in vapor phase is almost decreased linearly with increasing airflow rate from 0.7 L/min to 1.3 L/min. It is desirable that airflow rate should be high until the concentration of mercury vapor will be stable because the stabilized concentration becomes to be low and the stabilized time goes to be short as increased airflow rate. From KET and TCLP results, finally, phosphor powder should be managed as a hazardous waste but base-cap and glass are not classified as hazardous wastes.

Auto-ignition of lubricating oil working at high pressures in a compressor for an air conditioner.

Auto-ignition of lubricating oil working in a compressor for an air conditioner is studied experimentally. The adopted lubricating oil is an unknown mixture with multi-components and known to have flash point temperature of 170 °C. First, its auto-ignition temperature is measured 365 °C at atmospheric pressure. The lubricating oil works under high-pressure condition up to 30 atm and it is heated and cooled down repeatedly. Accordingly, auto-ignition temperatures or flammable limits of lubricating oil are required at high pressures with respect to fire safety. Because there is not a standard test method for the purpose, a new ignition-test method is proposed in this study and thereby, auto-ignition temperatures are measured over the pressure range below 30 atm. The measured temperatures range from 215 °C to 255 °C and they strongly depend on pressure of gas mixture consisting of oil vapor, nitrogen, and oxygen. They are close to flash point temperature and the lubricating oil can be hazardous when it works for high-pressure operating condition and abundant air flows into a compressor.