Sugarcane Light-Colored Lignin: A Renewable Resource for Sustainable Beauty.

Lignin has emerged as a promising eco-friendly multifunctional ingredient for cosmetic applications, due to its ability to protect against ultraviolet radiation and its antioxidant and antimicrobial properties. However, its typical dark color and low water solubility limit its application in cosmetics. This study presents a simple process for obtaining light-colored lignin (LCLig) from sugarcane bagasse (SCB) alkaline black liquor, involving an oxidation treatment with hydrogen peroxide, followed by precipitation with sulfuric acid. The physico-chemical characterization, antioxidant and emulsifying potential of LCLig, and determination of its safety and stability in an oil-in-water emulsion were performed. A high-purity lignin (81.6%) with improved water solubility was obtained, as a result of the balance between the total aromatic phenolic units and the carboxylic acids. In addition, the antioxidant and emulsifying capacities of the obtained LCLig were demonstrated. The color reduction treatment did not compromise the safety of lignin for topical cosmetic applications. The emulsion was stable in terms of organoleptic properties (color, pH, and viscosity) and antioxidant activity over 3 months at 4, 25, and 40 °C.

First Insight into Lignin Valorization as a Promising Biopolymer for the Modulation of the Physicochemical Properties of Port Wine.

Lignosulfonate (LS), kraft lignin (KL), and organosolv lignin (OL) were evaluated as potential modulating agents of the physicochemical properties of Port wine at two different concentrations for 7 and 30 days. KL and LS demonstrated the ability to remove proteins and potentiate the anthocyanin concentration. LS reduced the tannin content and the interaction of salivary acidic proline-rich proteins with wine phenolic compounds. None of the lignin promoted a perceptible color change; however, the yellowish color of KL and OL at 100 g/hL contributed to an increase in the yellow tones of wines. Lignin improved wine aroma by reducing the amount of unwanted volatiles by 30% and increasing the content of ethyl esters associated with fruity aromas by up to 60%. The results suggest that lignin, especially LS, can be employed as a modulating agent, positively impacting wine's physicochemical properties. This valorization of a byproduct opens up new opportunities for the wine industry.

Hardwood and softwood lignins from sulfite liquors: Structural characterization and valorization through depolymerization.

This work aims to evaluate the structural characteristics and study the oxidative depolymerization of lignins obtained from hardwood and softwood sulfite liquors. Lignins were obtained after ultrafiltration and freeze-drying of the sulfite liquors and characterized based on inorganic content, nitrobenzene oxidation, 13C NMR, and molecular weight determination. The structural characteristics achieved allow evaluating the potential of each lignin through oxidative depolymerization to produce added-value phenolic monomers. Hardwood and softwood lignins were submitted to alkaline oxidation with oxygen and the reaction conditions optimized to obtain a final oxidation mixture with the maximum yield of phenolic monomers. Through oxidation with O2, hardwood lignin generates mostly syringaldehyde while lignin from softwood biomass mainly produces vanillin; moreover, a lower reaction time and the interruption of O2 admission avoid the degradation of the oxidation products in the final mixture for both lignins, more evidenced to hardwood lignin due to its higher reactivity. From the results, it is possible to conclude that a phenolic aldehyde-rich oxidation mixture could be obtained, confirming the viability of lignin as raw material to produce added-value products as vanillin and syringaldehyde.

On the Oxidative Valorization of Lignin to High-Value Chemicals: A Critical Review of Opportunities and Challenges.

The efficient valorization of lignin is crucial if we are to replace current petroleum-based feedstock and establish more sustainable and competitive lignocellulosic biorefineries. Pulp and paper mills and second-generation biorefineries produce large quantities of low-value technical lignin as a by-product, which is often combusted on-site for energy recovery. This Review focuses on the conversion of technical lignins by oxidative depolymerization employing heterogeneous catalysts. It scrutinizes the current literature describing the use of various heterogeneous catalysts in the oxidative depolymerization of lignin and includes a comparison of the methods, catalyst loadings, reaction media, and types of catalyst applied, as well as the reaction products and yields. Furthermore, current techniques for the determination of product yields and product recovery are discussed. Finally, challenges and suggestions for future approaches are outlined.

Influence of soil copper content on the kinetics of thiram adsorption and on thiram leachability from soils.

This work aimed to assess the influence of soil copper content on the sorption processes of thiram, a fungicide widely used in agriculture, most of the times together with copper. Two different types of studies were performed: (1) desorption studies of thiram with acetonitrile after batch adsorption equilibration, and ageing of the wet soil for a variable period of time; (2) kinetic studies of thiram adsorption performed using the soil in its original form and after fortification with copper ions. In the desorption studies, with the increase of the ageing time, a decrease of the thiram peak and a simultaneous increase of a new peak, assigned to a copper complex, were observed in the chromatograms. This new peak increases sharply until an ageing period of about 4d and then this area is maintained approximately constant until 18 d, the maximum ageing period studied. These results indicate that thiram reacts with copper ions along time giving rise to the formation of relatively persistent copper complexes in soil. Desorption studies with CaCl(2) 0.01 M solution showed that this complex is not extracted. Thus, it is not easily leached to ground and surface waters and copper may contribute to thiram immobilization in soil. The kinetic studies of thiram adsorption were performed in both soils and for two initial thiram concentrations (~7 and 20 mg L(-1)). For the soil fortified with copper the percentage of adsorbed thiram is higher than observed for the original soil at the same initial concentrations and equilibration times and 100% of adsorption is attained in 15 h or 48 h, depending on the thiram initial concentration. Four kinetic equations, the pseudo first- and second-order equations, the Elovich and the intraparticle diffusion equations were selected to fit the kinetic data of the adsorption process of thiram onto both original and fortified soil. The best model to describe the kinetics of thiram adsorption onto the original soil is the intraparticle diffusion model. For the soil fortified with copper ions we verified that for the highest initial thiram concentration, the best model is also the intraparticle diffusion model, however, for the lower initial thiram concentration the best model is the pseudo second-order kinetic equation, suggesting that, for a high Cu:Thi ratio, a chemical reaction of thiram with copper ions on the soil surface can occur, and it may be the rate controlling step. Since the kinetics of adsorption depends on both soil copper content and the initial thiram concentration in solution, i.e. depends on Cu:Thi ratio, it is difficult to choose a fixed batch equilibration time for adsorption studies of thiram.

Influence of different organic amendments on the potential availability of metals from soil: a study on metal fractionation and extraction kinetics by EDTA.

The effects of long-term application of different organic amendments, as compared to mineral fertilizer, on Zn, Cu and Pb content and leachability in a luvisol derived from loess were assessed. The organic fertilizers, applied since 1962, were compost (COM) - from green organic household waste, sewage sludge (SLU) - from municipal water treatment facilities, farmyard manure (FYM) and the doses applied since 1997 were 90tha(-1), 10tha(-1) and 9tha(-1), once in 3years, respectively. The kinetics of metals extraction with 0.05moldm(-3) EDTA at pH 6.0 has been studied. The two first-order reactions model was fitted to the kinetic data and allowed to distinguish two pools for each metal: a "labile" fraction (Q(1)), quickly extracted with a rate constant k(1), and a "moderately labile" fraction (Q(2)), more slowly extracted, with a rate constant k(2). Simultaneously, the pseudo-total metal contents in the soil samples were determined after digestion with aqua regia (3:1 HCl+HNO(3)). The obtained parameters Q(1), k(1), Q(2), k(2), for the kinetics of extraction of each metal in the three replicates of each fertilization mode, as well as the pseudo-total metal contents, were statistically analysed. COM and SLU application resulted in an increase of the total contents of Pb, Zn and Cu in soil. Further, the percentage of labile Zn and Pb also increased in consequence of the application of those amendments, particularly COM. The increase was more noticeable for Zn. FYM, despite not increasing the total content of Pb, Zn or Cu, did also have an effect on the leachability of Zn and Pb, increasing their labile fraction in soil. These results point to a potential risk of increasing metals mobility in soil, mainly Zn, associated to the use of organic amendments, particularly COM or SLU.