Combining synchrotron radiation techniques for the analysis of gold coins from the Roman Empire.

Four gold coins minted in the V century have been studied with non-destructive synchrotron radiation techniques, namely X-Ray Fluorescence (XRF) and X-ray Absorption Near Edge Spectroscopy (XANES). XRF data analyzed coupling standard and statistical methods were used to distinguish the composition of the alloy constituting the coins from that of successive deposits processes. Our analysis presents a quantification of the trace elements present in the metallic alloy providing interesting details for historical insight. Furthermore, on the basis of the XRF maps, some regions of interest were selected for XANES at the K-edge of Fe. Our analysis of the Fe spectra points out two main phases which can be related to Fe oxides naturally present in soil. From the relative abundance of these oxides, information on the site where the coins were found can be obtained, providing additional information on their fate across the centuries.

Optical particle counter data collected in two inhabited sites close to an industrial hot spot during a three months survey.

Data on this paper describe the monitoring of different size ranges of particulate matter on dwellings positioned close to an integral cycle steel plant. Data were collected by eight channel (PM0.3, PM0.5, PM0.7, PM1, PM2, PM3, PM5, PM10) optical particle counters positioned in two sites. The data were recorded as counts-per-minute for every size channel in a three months survey from June to September 2015. Basic statistical elaboration and boxplot graphs as well as raw data are included. The data are related to "Characterization of variability of air particulate matter size profiles recorded by Optical Particle Counters near a complex emissive source by use of Self-Organizing Map algorithm" Licen et al.,2019, in which a statistical elaboration by Self-Organizing Map algorithm is proposed.

[In vitro percutaneous absorption of silver nanoparticles]. / Assorbimento percutaneo di nanoparticelle di argento in un sistema in vitro.

There is a growing interest in the debate on nanoparticle safety for topical use. The benefits of nanoparticles have been shown in several scientific fields, but little is known about their potential to penetrate the skin lies. This study aims at evaluating in vitro silver nanoparticles skin penetration. Experiments were performed using the Franz diffusion cell method with intact and damaged human skin. Physiological solution was used as receiving phase and 70 microg/cm2 of silver nanoparticles dispersed in synthetic sweat were applied as donor phase to the outer surface of the skin for 24h. The receptor fluid measurements were performed by Electro Thermal Atomic Absorption Spectroscopy (ETAAS). Silver concentration of 0.2 microg/L was found in the receiving solutions of two cells, in which damaged skin membranes were set up. In the other tests, we obtained a silver concentration below the limit of detection in the receiving cells. Our experimental data show that silver nanoparticles permeation through intact and damaged skin is negligible. These findings are consistent with previously published results. Further researches are necessary to explore skin absorption of silver nanoparticles.

[In vitro percutaneous absorption of chromium powder and the effect of skin cleanser]. / Assorbimento percutaneo di polvere di cromo ed effetti della detersione: risultati di una indagine in vitro.

Occupational chromium dermatitis occurs frequently among cement and metal workers, workers dealing with leather tanning and employees in the ceramic industry. The present study, using an in-vitro system, evaluated percutaneous absorption of chromium powder and the effect of rapid skin decontamination with a common detergent. Experiments were performed using the Franz diffusion cell method with human skin. Physiological solution was used as receiving phase and a suspension of chromium powder in synthetic sweat was used as donor phase. The tests were performed without or with decontamination using the cleanser 30 minutes after the start of exposure. The amount of chromium permeated through the skin was analysed by Inductively Coupled Plasma Atomic Emission Spectroscopy and Electro Thermal Atomic Absorption Spectroscopy. Speciation analysis and measurements of chromium skin content were also performed. We calculated a permeation flux of 0.843 +/- 0.25 ng cm(-2) h(-1) and a lag time of 1.1 +/- 0.7 h. The cleaning procedure significantly increased chromium skin content, whereas skin passage was not increased. These results showed that chromium powder can pass through the skin and that skin decontamination did not decrease skin absorption. Therefore, it is necessary to prevent skin contamination when using toxic agents.

Silver percutaneous absorption after exposure to silver nanoparticles: a comparison study of three human skin graft samples used for clinical applications.

Silver nanoparticles (AgNPs) are increasingly applied to a wide range of materials for biomedical use. These enable a close contact with human skin, thanks to the large release of silver ions that is responsible for a broad spectrum of antimicrobial activity. Silver can permeate the skin; however, there are no data available on silver permeation through skin grafts commonly used in burns recovery. The aim of our study was to evaluate silver penetration using fresh, cryopreserved, and glycerolized human skin grafts after exposure to a suspension of AgNPs in synthetic sweat using a Franz diffusion cell apparatus for 24 h. Silver permeation profiles revealed a significantly higher permeation through glycerolized skin compared with both fresh and cryopreserved skin: 24-h silver flux penetration was 0.2 ng cm(-2) h(-1) (lag time: 8.2 h) for fresh skin, 0.3 ng cm(-2) h(-1) (lag time: 10.9 h) for cryopreserved skin, and 3.8 ng cm(-2) h(-1) (lag time: 6.3 h) for glycerolized skin. Permeation through glycerolized skin is significantly higher compared to both fresh and cryopreserved skin. This result can generate relevant clinical implications for burns treatment with products containing AgNPs.

Biological responses of silver-coated thermosets: an in vitro and in vivo study.

Bisphenol A glycidylmethacrylate (BisGMA)/triethyleneglycol dimethacrylate (TEGDMA) thermosets are biomaterials commonly employed for orthopedic and dental applications; for both these fields, bacterial adhesion to the surface of the implant represents a major issue for the outcome of the surgical procedures. In this study, the antimicrobial properties of a nanocomposite coating formed by polysaccharide 1-deoxylactit-1-yl chitosan (Chitlac) and silver nanoparticles (nAg) on methacrylate thermosets were studied. The Chitlac-nAg system showed good anti-bacterial and anti-biofilm activity although its biocidal properties can be moderately, albeit significantly, inhibited by serum proteins. In vitro studies on the silver release kinetic in physiological conditions showed a steady metal release associated with a gradual loss of antimicrobial activity. However, after 3weeks there was still effective protection against bacterial colonization which could be accounted for by the residual silver. This time-span could be considered adequate to confer short-term protection from early peri-implant infections. Preliminary in vivo tests in a mini-pig animal model showed good biological compatibility of Chitlac-nAg-coated materials when implanted in bony tissue. The comparison was made with implants of titanium Ti6Al4V alloy and with a Chitlac-coated thermoset. Bone healing patterns and biocompatibility parameters observed for nAg-treated material were comparable with those observed for control implants.