RESUMO
The interactions between light and plasmonic charge oscillations in conducting materials are important venues for realizing nanoscale light manipulations. Conventional metal-based plasmonic devices lack tunability due to the fixed material permittivities. Here, we show that reconfigurable plasmonic functionalities can be achieved using the spatially controlled phase transitions in strongly correlated oxide films. The experimental results discussed here are enabled by a recently developed scanning probe-based technique that allows a nonvolatile, monoclinic-metal VO2 phase to be reversibly patterned at the nanoscale in ambient conditions. Using this technique, rewritable waveguides, spatially modulated plasmonic resonators, and reconfigurable wire-grid polarizers are successfully demonstrated. These structures, effectively controlling infrared lights through spatially confined mobile carriers, showcase a great potential for building programmable nanoplasmonic devices on correlated oxide platforms.
RESUMO
We report on carrier recombination within self-catalyzed InAs/InAlAs core-shell nanowires (NWs), disentangling recombination rates at the ends, sidewalls, and interior of the NWs. Ultrafast optical pump-probe spectroscopy measurements were performed from 77-293 K on the free-standing, variable-sized NWs grown on lattice-mismatched Si(111) substrates, independently varying NW length and diameter. We found NW carrier recombination in the interior is nontrivial compared to the surface recombination, especially at 293 K. Surface recombination is dominated by carrier recombination at the NW sidewall, while contributions from the highly strained, impure NW base are negligible.
RESUMO
To maximize the photovoltaic efficiency, it is highly desirable to enable the electricity conversion from low energy photons and to extract the excessive energy from hot carriers. Here we report a large photovoltage generation at the LaAlO3/SrTiO3 interfaces from infrared photons with energies far below the oxide bandgaps. This effect is a result of the photoexcitation of hot carriers in metasurface electrical contacts and the subsequent thermoelectric charge separations by the interfacial two-dimensional electron gas (2DEG). Reaching a room-temperature responsivity of 4.4 V/W, such light-to-charge conversion can be spatially controlled and reconfigured through the patterning of 2DEG using conducting atomic force microscope. Compatible for broadband applications, our results demonstrate a new path toward efficient and programmable light sensing using oxide-based low-dimensional electron systems.
RESUMO
Here, we demonstrate the nanoscale manipulations of two types of charge transfer to the LaAlO3/SrTiO3 interfaces: one from surface adsorbates and another from oxygen vacancies inside LaAlO3 films. This method can be used to produce multiple insulating and metallic interface states with distinct carrier properties that are highly stable in air. By reconfiguring the patterning and comparing interface structures formed from different doping sources, effects of extrinsic and intrinsic material characters on the transport properties can be distinguished. In particular, a multisubband to single-subband transition controlled by the structural phases in SrTiO3 was revealed. In addition, the transient behaviors of nanostructures also provided a unique opportunity to study the nanoscale diffusions of adsorbates and oxygen vacancies in oxide heterostructures. Knowledge of such dynamic processes is important for nanodevice implementations.
RESUMO
We report an oxygen surface adsorbates induced metal-insulator transition at the LaAlO3/SrTiO3 interfaces. The observed effects were attributed to the terminations of surface Al sites and the resultant electron-accepting surface states. By controlling the local oxygen adsorptions, we successfully demonstrated the nondestructive patterning of the interface two-dimensional electron gas (2DEG). The obtained 2DEG structures are stable in air and also robust against general solvent treatments. This study provides new insights into the metal-insulator transition mechanism at the complex oxide interfaces and also a highly efficient technique for tailoring the interface properties.
RESUMO
Efficient trapping of the light in a photon absorber or a photodetector can improve its performance and reduce its cost. In this paper we investigate two designs for light-trapping in application to infrared absorption. Our numerical simulations demonstrate that nonabsorptive pyramids either located on top of an absorbing film or having embedded absorbing rods can efficiently enhance the absorption in the absorbing material. A spectrally averaged absorptance of 83% is achieved compared to an average absorptance of 28% for the optimized multilayer structure that has the same amount of absorbing material. This enhancement is explained by the coupled-mode theory. Similar designs can also be applied to solar cells.
RESUMO
In the original publication [...].
RESUMO
Conductive hydrogels (CHs) have shown promising potential applied as wearable or epidermal sensors owing to their mechanical adaptability and similarity to natural tissues. However, it remains a great challenge to develop an integrated hydrogel combining outstanding conductive, self-healing and biocompatible performances with simple approaches. In this work, we propose a "one-pot" strategy to synthesize multifunctional CHs by incorporating two-dimensional (2D) transition metal carbides/nitrides (MXenes) multi-layer nano-flakes as nanofillers into oxidized alginate and gelatin hydrogels to form the composite CHs with various MXene contents. The presence of MXene with abundant surface groups and outstanding conductivity could improve the mechanical property and electroactivity of the composite hydrogels compared to pure oxidized alginate dialdehyde-gelatin (ADA-GEL). MXene-ADA-GELs kept good self-healing properties due to the dynamic imine linkage of the ADA-GEL network and have a promoting effect on mouse fibroblast (NH3T3s) attachment and spreading, which could be a result of the integration of MXenes with stimulating conductivity and hydrophily surface. This study suggests that the electroactive MXene-ADA-GELs can serve as an appealing candidate for skin wound healing and flexible bio-electronics.