Degradation of decabromodiphenyl ether (BDE-209) in microcosms mimicking sediment environment subjected to comparative bioremediation strategies.

The aim of this study was to examine bioremediation strategies for BDE-209 contaminated sediments. Sediment microcosms were established to observe anaerobic debromination of BDE-209 under conditions representing three bioremediation strategies: biostimulation, bioaugmentation and natural attenuation. To simulate biostimulation, a defined mineral medium containing both a carbon source (sodium formate) and electron donor (ethanol) was added into sediments. Bioaugmentation was established by enrichment of the sediments using a culture of Dehalobium chlorocoercia strain DF-1, previously shown to dechlorinate polychlorinated biphenyls, to sediments. No amendments were made to the third set in order to represent natural attenuation. The biostimulation, bioaugmentation and natural attenuation strategies resulted in 55.3%, 40.2% and 30.9% reductions in BDE-209, respectively, after 180 days. Nona- through tri-BDEs were observed as products, with 17 PBDE congeners detected in 25 different proposed debromination pathways. At the end of the 180 day incubation period, the products for bioaugmentation, biostimulation and natural attenuation were tri-BDEs, tetra-BDEs and penta-BDEs, respectively. The proposed pathways revealed that meta- and ortho-Br removal were favored in sediments, and that debromination regiospecificity varied with each bioremediation strategy applied. Lastly, pseudo-first-order rate constants for BDE-209 reduction were calculated as 0.0049 d-1, 0.0028 d-1, 0.0025 d-1 for biostimulation, bioaugmentation and natural attenuation, respectively.

Toxicity to bronchial cells and endocrine disruptive potentials of indoor air and dust extracts and their association with multiple chemical classes.

Pollution of indoor environment, where people spend much of their time, comprises complex mixtures of compounds with vastly understudied hazard potential. This study examined several important specific toxic effects and pollutant levels (177 compounds) of indoor samples (air gas phase, PM10 and dust) from different microenvironments after two extractions with focus on their gas/particle/dust distribution and polarity. The endocrine disruptive (ED) potential was assessed by human cell-based in vitro bioassays addressing anti-/estrogenicity, anti-/androgenicity, aryl hydrocarbon, thyroid and peroxisome proliferator-activated receptor-mediated activities. Potential toxicity to respiratory tract tissue was assessed using human bronchial cell line. The toxicological analyses pointed out the relevance of both inhalation and ingestion exposure, with significant effects detected after exposure to extracts from all three studied matrices with distinct gas/particle distribution patterns. Chemical analyses document the high complexity of indoor pollutant mixtures with greatest levels of phthalates, their emerging alternatives, and PAHs in dust. Despite the detection of up to 108 chemicals, effects were explained only to low extent. This emphasizes data gaps regarding ED potencies of many detected abundant indoor contaminants, but also potential presence of other unidentified ED compounds. The omnipresent ED potentials in indoor environment rise concern regarding associated human health risk.

Targeted and suspect screening of plasticizers in house dust to assess cumulative human exposure risk.

Indoor dust is an important exposure route to anthropogenic chemicals used in consumer products. Plasticizers are common product additives and can easily leach out of the product and partition to dust. Investigations of plasticizers typically focus on a subset of phthalate esters (PEs), but there are many more PEs in use, and alternative plasticizers (APs) are seeing greater use after recognition of adverse health effects of PEs. In this study we use full scan high resolution mass spectrometry for targeted and suspect screening of PEs and APs in house dust and to assess the potential risk of human exposure. House dust samples from Eastern Slovakia were investigated and concentrations of ∑12PEs and ∑5APs ranged 12-2765 µg/g and 45-13,260 µg/g, respectively. APs were at similar levels to PEs, indicating common usage of these compounds in products in homes. Evaluation of individual compound toxicity combined with human intake via dust ingestion suggested PEs are of lower priority compared to semivolatile organic compounds such as polychlorinated biphenyls due to their lower toxicity. However, cumulative risk assessment (CRA) is a more appropriate evaluation of risk, considering the presences of many PEs in dust and their similar toxic mode of action. CRA based on median toxicity reference values (TRVs) suggested acceptable risks for dust ingestion, however, the wide range of literature-derived TRVs is a large uncertainty, especially for the APs. Use of newer TRVs suggest risk from dust ingestion alone, i.e. not even considering diet, inhalation, and dermal contact. Additionally, screening of full-scan instrumental spectra identified a further 40 suspect PE compounds, suggesting the CRA based on the 12 target PEs underestimates the risk.

Levels of polybrominated diphenyl ethers and hexabromocyclododecane in treatment plant sludge: Implications on sludge management.

Past usage of polybrominated diphenyl ethers (PBDEs) and hexabromocyclododecane (HBCDD) in commercial products resulted in their continuous emission from sources. Wastewater treatment plants (WWTP) are the main sinks resulting from their industrial and domestic usage as well as atmospheric deposition. This preliminary study examined levels of PBDEs and HBCDD in urban and industrial WWTP sludge samples for the first time from Turkey. PBDE concentrations (sum of 26 congeners) of eight samples collected from four WWTPs were between 300 and 655 ng g-1 dw and 67-2.5*107 ng g-1 dw, and HBCDD concentrations (sum of α-, ß-, and γ- diastereoisomers) ranged 75-616 ng g-1 dw and 13-416 ng g-1 dw, for urban and industrial WWTP samples, respectively. Although PBDEs have never been produced in Turkey, the highest PBDE concentration in sewage sludge worldwide was identified in one of the WWTPs. PBDE and HBCDD levels in other sludge samples were comparable to those reported in the literature. Application of a chemical mass balance model (CMB) suggested: (i) the main source of PBDEs as deca-BDE mixture; (ii) influence of a background air PBDE profile for one of the industrial WWTPs, having low contamination; (iii) indoor dust PBDE contamination as another source for urban WWTPs. The preliminary results for BFR levels in Turkey were discussed in terms of sludge disposal methods used worldwide, and the need for regulatory limits for BFRs in sludge management.

Assessment of PCB contamination, the potential for in situ microbial dechlorination and natural attenuation in an urban watershed at the East Coast of the United States.

Sediment contamination is a major environmental issue in many urban watersheds and coastal areas due to the potential toxic effects of contaminants on biota and human health. Characterizing and delineating areas of sediment contamination and toxicity are important goals of coastal resource management in terms of ecological and economical perspectives. Core and surficial sediment samples were collected from an industrialized urban watershed at the East Coast of the United Stated and analyzed to evaluate the PCB contamination profile and toxicity resulting from dioxin-like PCBs as well as reductive dechlorination potential of indigenous PCB halorespiring bacteria through dechlorination activity assays. To support the experimental results an anaerobic dechlorination model was applied to identify microbial dechlorination pathways. The total PCB concentration in core samples ranged from 3.9 to 225.6 ng/g·dry weight (dw) decreasing with depth compared to 353.2 to 1213.7 ng/g·dw in surficial samples. The results of this study indicated an increase in PCB contamination over the last century as the industrial activity intensified. The toxicity resulting from dioxin-like PCBs was reduced up to 94% in core samples via 21 pathways resulting from the dechlorination model. Dechlorination rates in surficial sediment were between 1.8 and 13.2 ·â€¯10-3 mol% PCB116/day, while lower rates occurred in the core sediment samples. Dechlorination was achieved mainly through meta followed by para dechlorination. However, the rarer ortho dechlorination was also observed. Detection of indigenous PCB dechlorinating bacteria in the sediments and reduction of toxicity indicated potential for natural attenuation when point and nonpoint source PCBs in the urban watershed are controlled and PCB loading reduced.

Linking past uses of legacy SVOCs with today's indoor levels and human exposure.

Semivolatile organic compounds (SVOCs) emitted from consumer products, building materials, and indoor and outdoor activities can be highly persistent in indoor environments. Human exposure to and environmental contamination with polychlorinated biphenyls (PCBs) was previously reported in a region near a former PCB production facility in Slovakia. However, we found that the indoor residential PCB levels did not correlate with the distance from the facility. Rather, indoor levels in this region and those reported in the literature were related to the historic PCB use on a national scale and the inferred presence of primary sources of PCBs in the homes. Other SVOCs had levels linked with either the activities in the home, e.g., polycyclic aromatic hydrocarbons (PAHs) with wood heating; or outdoor activities, e.g., organochlorine pesticides (OCPs) with agricultural land use and building age. We propose a classification framework to prioritize SVOCs for monitoring in indoor environments and to evaluate risks from indoor SVOC exposures. Application of this framework to 88 measured SVOCs identified several PCB congeners (CB-11, -28, -52), hexachlorobenzene (HCB), benzo(a)pyrene, and γ-HCH as priority compounds based on high exposure and toxicity assessed by means of toxicity reference values (TRVs). Application of the framework to many emerging compounds such as novel flame retardants was not possible because of either no or outdated TRVs. Concurrent identification of seven SVOC groups in indoor environments provided information on their comparative levels and distributions, their sources, and informed our assessment of associated risks.

Evaluation of PCB dechlorination pathways in anaerobic sediment microcosms using an anaerobic dechlorination model.

A detailed quantitative analysis of anaerobic dechlorination (AD) pathways of polychlorinated biphenyls (PCBs) in sediment microcosms was performed by applying an anaerobic dechlorination model (ADM). The purpose of ADM is to systematically analyze changes in a contaminant profile that result from microbial reductive dechlorination according to empirically determined dechlorination pathways. In contrast to prior studies that utilized modeling tools to predict dechlorination pathways, ADM also provides quantification of individual pathways. As only microbial reductive dechlorination of PCBs occurred in the modeled laboratory microcosms, extensive analysis of AD pathways was possible without the complicating effect of concurrent physico-chemical or other weathering mechanisms. The results from this study showed: (1) ninety three AD pathways are active; (2) tetra- to hepta-chlorobiphenyl (CB) congeners were common intermediates in several AD pathways, penta-CBs being the most frequently observed; (3) the highest rates of dechlorination were for penta-CB homologs during the initial 185 days; (4) the dominant terminal products of AD were PCB 32(26-4), 49(24-25), 51(24-26), 52(25-25), 72(25-35), 73(26-35) and 100(246-24), (5) potential toxicity of the sediment was reduced. ADM serves as a powerful tool not only for a thorough analysis of AD pathways, but also for providing necessary input for numerical fate models (as a degradation term) that investigate dechlorination products or outcome of natural attenuation, or bioremediation/bioaugmentation of PCB-impacted sediments.