Relationships between dairy powder surface composition and wetting properties during storage: importance of residual lipids.

The relationships between powder surface composition and powder rehydration properties under variable conditions of storage are investigated in this paper. A rheological approach was used to evaluate the modifications induced by storage on the rehydration properties of native phosphocaseinate powder. Concurrently, the powder surface composition (i.e., lactose, proteins, and lipids) was evaluated by X-ray photoelectron spectroscopy (XPS). A strong correlation was found between the powder wetting time lengthening and the migration of lipids on the powder surface during storage. XPS studies indicated also an over-representation of lipids on the powder surface (6%) in comparison with total lipids (0.4%) even on fresh powder before storage. Detailed investigation of powder lipids revealed the presence of high levels of polar lipids (66% compared with <1% in milk lipids). Their amphiphilic nature and their melting points could explain the extensive enrichment of lipids observed at the powder surface during processing and storage.

Sorption of silicates on goethite, hematite, and magnetite: experiments and modelling.

Sorption of H(4)SiO(4) (including experiments as a function of time, K(d) measurement with different m/v ratios and sorption edges) onto different iron (hydro)oxides as goethite (alpha-FeOOH), hematite (alpha-Fe(2)O(3)), and magnetite (Fe(3)O(4)) has been studied with concentration of silicates under solubility limit. A surface complexation model has been used to account for sorption edge of silicates onto these iron oxide surfaces. It reveals that two types of surface complex namely FeH(3)SiO(4) and FeH(2)SiO(4)(-), are needed to describe properly the experimental observations.

Sorption of tributyltin onto a natural quartz sand.

The aim of this study is to understand the sorption of tributyltin (TBT) onto natural quartz sand by classical batch experiments and spectroscopic surface analyses. At pH<6, the major species of TBT is the cation TBT(+). Due to the presence of both the cationic part and the butyl chains, TBT should present amphiphilic properties. For concentrations lower than 40 microM, TBT sorption occurs as a homovalent 1:1 cation exchange between either H(+) or Na(+) and TBT(+). The increasing affinity of TBT with respect to the different materials follows the series kaolinite<

Morphology and surface heterogeneities in synthetic goethites.

In the framework on a study of the acido-basic and sorption properties of iron oxides, a thorough characterization of two types of goethite powders was performed in several laboratories joined in a common project. Chemical analysis by ICPAES; high-resolution SEM, TEM, and AFM observations; XRD with line width analysis; and argon and nitrogen sorption isotherms were used for that purpose. The main crystallographic faces of goethite particles could be identified as {001}, {101}, and {121}, and their abundance correlated with the distribution of low-pressure argon adsorption local isotherms. These results will be very useful for further studies on the relationship between surface reactivity in aqueous solution and orientation of solid surfaces.

Immobilization of iodide on copper(I) sulfide minerals.

In the goal of finding efficient scavengers for radioiodide in conditions (pH, pE) close to those encountered in deep geological sites, sorption of iodide ions on cuprous sulfide minerals (especially roxbyite, Cu(1.75)S) has been studied. Surface analysis by X-ray photoelectron spectroscopy has shown that commercial cuprous sulfides are covered by an oxidized overlayer (mainly in the form of CuSO(4)). Therefore, a synthetic procedure to get roxbyite (typically by mixing Na(2)S with an aqueous suspension of commercial Cu(2)O) was applied to produce pure samples with clean surfaces. Batch equilibration of cuprous sulfide particles suspended in aqueous solutions containing iodide species has revealed significant consumption of iodide. The sorption mechanism involves the formation of a surface complex via the exchange of surface hydroxyl groups by iodide anions, as highlighted by a transient pH increase during the immobilization process. Other copper and mixed copper-iron sulfides (e.g. CuS, CuFeS(2)), which are stable over wide pH and potential ranges are also likely to accumulate iodide species. Because of the specific interaction between iodide and copper(I) centers on the minerals, high distribution coefficients (>1000 ml/g) were observed.

U(VI) sorption and reduction by Fe(II) sorbed on montmorillonite.

The influence of surface-bound Fe(II) on uranium oxidation state and speciation was studied as a function of time (6 min-72 h) and pH (6.1-8.5) in a U(VI)-Fe(II)-montmorillonite (Ca-montmorillonite, MONT) system under CO(2)-free, anoxic (O(2) <1 ppmv) conditions. The results show a rapid removal of U(VI) from the aqueous solution within 1 h under all pH conditions. U L(III)-edge X-ray absorption near-edge structure spectroscopy shows that 96% of the total sorbed U(VI) is reduced at pH 8.5. However, the extent of reduction significantly decreases at lower pH values as specifically sorbed Fe(II) concentration decreases. The reduction kinetics followed by X-ray photoelectron spectroscopy during 24 h at pH 7.5 demonstrates the presence of partially reduced surface species containing U(VI) and U(IV). Thermodynamically predicted mixed valence solids like U(3)O(8)/beta-U(3)O(7)/U(4)O(9) do not precipitate as verified by transmission electron microscopy and extended X-ray absorption fine-structure spectroscopy. This is also supported by the bicarbonate extraction results. The measured redox potentials of Fe(II)/Fe(III)-MONT suspensions are controlled by the Fe(II)/hydrous ferric oxide [HFO(s)] couple at pH 6.2 and by the Fe(II)/lepidocrocite [gamma-FeOOH(s)] couple at pH 7.5. The key finding of our study is the formation of a sorbed molecular form of U(IV) in abiotic reduction of U(VI) by sorbed Fe(II) at the surface of montmorillonite.

Sorption of selenium(IV) onto magnetite in the presence of silicic acid.

Sorption of selenium(IV) and silicic acid onto magnetite (Fe(3)O(4)) was investigated in binary systems, with concentrations of silicic acid under the solubility limit of amorphous silica. Using the double diffuse layer model (DDLM), surface complexation constants of selenium(IV) and H(4)SiO(4) onto magnetite were extracted using Fiteql 4.0. Then, prediction curves of the sorption of selenium(IV) in the presence of silicic acid onto magnetite were obtained, using the calculated surface complexation constants. Finally, laboratory experiments were performed and showed a competition between selenium(IV) and silicic acid for the surface sites of magnetite. Experimental results matched the model predictions, confirming its ability to model qualitatively and quantitatively the ternary system.

Competition between selenium (IV) and silicic acid on the hematite surface.

Competition between selenium (IV) and silicic acid for the hematite (alpha-Fe(2)O(3)) surface has been studied during this work. Single batch experiments have been performed to study separately the sorption of selenium (IV) and silicic acid as a function of the pH. With the help of the 2-pK surface complexation model, experimental data have been fitted using the FITEQL 4.0 program. Two monodentate inner-sphere surface complexes have been used to fit selenite ions retention, triple bond FeSeO(3)(-) and triple bond FeHSeO(3). In order to fit sorption of silicic acid, the two following surface complexes, namely triple bond FeH(3)SiO(4), and triple bond FeH(2)SiO(4)(-), have been used. Using the surface complexation constants coming from these two binary systems, prediction curves of the effect of silicic acid on the retention of selenium (IV) onto hematite have been obtained. Finally, performed experiments showed a competition between selenium (IV) and silicic acid for the surface sites of hematite. Experimental data matched DDLM predictions, confirming the ability of the surface complexation model to predict quantitatively and qualitatively the ternary system selenium (IV)/H(4)SiO(4)/hematite.

Adsorption studies of methylene blue and phenol onto vetiver roots activated carbon prepared by chemical activation.

Vetiver roots have been utilized for the preparation of activated carbon (AC) by chemical activation with different impregnation ratios of phosphoric acid, X(P) (gH(3)PO(4)/g precursor): 0.5:1; 1:1 and 1.5:1. Textural characterization, determined by nitrogen adsorption at 77K shows that mixed microporous and mesoporous structures activated carbons (ACs) with high surface area (>1000 m(2)/g) and high pore volume (up to 1.19 cm(3)/g) can be obtained. The surface chemical properties of these ACs were investigated by X-ray photoelectron spectroscopy (XPS) and Boehm titration. Their textural and chemical characteristics were compared to those of an AC sample obtained by steam activation of vetiver roots. Classical molecules used for characterizing liquid phase adsorption, phenol and methylene blue (MB), were used. Adsorption kinetics of MB and phenol have been studied using commonly used kinetic models, i.e., the pseudo-first-order model, the pseudo-second-order model, the intraparticle diffusion model and as well the fractal, BWS (Brouers, Weron and Sotolongo) kinetic equation. The correlation coefficients (R(2)) and the normalized standard deviation Deltaq (%) were determined showing globally, that the recently derived fractal kinetic equation could best describe the adsorption kinetics for the adsorbates tested here, indicating a complex adsorption mechanism. The experimental adsorption isotherms of these molecules on the activated carbon were as well analysed using four isotherms: the classical Freundlich, Langmuir, Redlich-Peterson equations, but as well the newly published deformed Weibull Brouers-Sotolongo isotherm. The results obtained from the application of the equations show that the best fits were achieved with the Brouers-Sotolongo equation and with the Redlich-Peterson equation. Influence of surface functional groups towards MB adsorption is as well studied using various ACs prepared from vetiver roots and sugar cane bagasse. Opposite effects governing MB and phenol adsorption mechanism on ACs are demonstrated. The various effects involved in adsorption mechanisms of each molecule are demonstrated.