Brucine-Loaded Ethosomal Gel: Design, Optimization, and Anti-inflammatory Activity.

Brucine, one of the natural medications obtained from Nux vomica seeds, is used as an anti-inflammatory drug. Several investigations were performed to overcome its drawbacks, which will affect significantly its pharmaceutical formulation. The goal of the current investigation was to design, optimize, and evaluate the anti-inflammatory performance of BRU ethosomal gel. Brucineethosomal formulations were prepared using thin film hydration method and optimized by central composite design approach using three independent variables (lecithin concentration, cholesterol concentration, and ethanol percentage) and three response variables (vesicular size, encapsulation efficiency, and skin permeation). The optimized formulation was examined for its stability and then incorporated into HPMC gel to get BRU ethosomal gel. The obtained BRU-loaded ethosomal gel was evaluated for its physical properties, in vitro release, and ex vivo permeation and skin irritation. Finally, carrageenan-induced rat hind paw edema test was adopted for the anti-inflammatory activity. The developed BRU ethosomal gel exhibited good physical characteristics comparable with the conventional developed BRU gel. In vitro release of BRU from ethosomal gel was effectively extended for 6 h. Permeation of BRU from ethosomes was significantly higher than all formulations (p < 0.05), since it recorded steady state transdermal flux value 0.548 ± 0.03 µg/cm2 h with enhancement ratio 2.73 ± 0.23. Eventually, BRU ethosomal gel exhibited potent anti-inflammatory activity as manifested by a significant decrease in rat hind paw inflammation following 24 h. In conclusion, the study emphasized the prospective of ethosomal gel as a fortunate carrier for intensifying the anti-inflammatory effect of Brucine.

Buspirone Hydrochloride Loaded In Situ Nanovesicular Gel as an Anxiolytic Nasal Drug Delivery System: In Vitro and Animal Studies.

Nasal nanovesicular gels of buspirone hydrochloride (BH) were prepared and characterized aiming for sustained delivery and enhancing bioavailability. Buspirone hydrochloride has low bioavailability of about 4% after oral administration due to first pass metabolism. Buspirone hydrochloride nanovesicles were formulated by thin film hydration method (TFH). The selected nanovesicular formulation was incorporated into two types of in situ gels (pH-induced and thermoreversible) using carbopol 974P and poloxamer 407 (P407), respectively, together with different mucoadhesive polymers. The in situ gels were examined for pH, gelling capability, viscosity, content uniformity, mucoadhesiveness, and in vitro drug release. The ex vivo permeation performance of the in situ gel formulations that showed the most sustained release was also assessed. The in vivo study was done by the determination of BH blood level in albino rabbits after nasal administration. Results revealed that nanovesicles prepared using Span 60 and cholesterol in a ratio of 80:20 showed the highest EE% (70.57 ± 1.00%). The ex vivo permeation data confirmed higher permeability figures for carbopol formulation in comparison to poloxamer formulations. The in vivo study data showed an increase of 3.26 times in BH bioavailability when formulated into the carbopol nanovesicular in situ gel relative to control (nasal drug solution).

Development and Optimization of Erythromycin Loaded Transethosomes Cinnamon Oil Based Emulgel for Antimicrobial Efficiency.

Erythromycin (EM) is a macrolide antibiotic that is frequently used to treat skin bacterial infections. It has a short half-life (1-1.5 h), instability in stomach pH, and a low oral bioavailability. These foregoing factors limit its oral application; therefore, the development of topical formulations loaded with erythromycin is an essential point to maximize the drug's concentration at the skin. Accordingly, the current study's goal was to boost the antimicrobial activity of EM by utilizing the advantages of natural oils such as cinnamon oil. Erythromycin-loaded transethosomes (EM-TE) were generated and optimized using a Box-Behnken design employing, phospholipid concentration (A), surfactant concentration (B), and ethanol content (C) as independent variables. Their effects on entrapment efficiency, EE, (Y1) and the total amount of erythromycin that penetrated the skin after 6 h, Q6h (Y2), were assessed. The optimized transethosome showed a particle size of 256.2 nm, EE of 67.96 ± 0.59%, and Q6h of 665.96 ± 5.87 (µg/cm2) after 6 h. The TEM analysis revealed that, the vesicles are well-known packed structures with a spherical shape. The optimized transethosomes formulation was further transformed into a cinnamon oil-based emulgel system using HPMC as a gelling agent. The generated EM-TE-emulgel was characterized by its physical features, in vitro, ex vivo studies, and antimicrobial activities. The formulation showed sufficient characteristics for effective topical application, and demonstrated a great stability. Additionally, EM-TE-Emulgel had the highest transdermal flux (120.19 µg/cm2·h), and showed considerably (p < 0.05) greater antimicrobial activity, than EM-TE-gel and placebo TE-Emulgel. The action of EM was subsequently augmented with cinnamon oil, which eventually showed a notable effect against bacterial growth. Finally, these results demonstrate that the transethosomes-loaded cinnamon oil-based emulgel is an alternative way to deliver erythromycin for the treatment of topical bacterial infections.

Response Surface Methodology for Optimization of Buspirone Hydrochloride-Loaded In Situ Gel for Pediatric Anxiety.

The purpose of the current investigation was to formulate, assess, and optimize oral in situ gels of buspirone hydrochloride (BH) with the specific end goal of expanding the time the medication spends in the stomach, thereby ensuring an extended medication discharge. This would allow the use of a once-a-day dose of liquid BH formulations, which is ideal for the treatment of pediatric anxiety. In situ gels loaded with BH were prepared using various concentrations of sodium alginate (Na alg.), calcium chloride (CaCl2), and hydroxypropyl methylcellulose (HPMC K15M). The in situ gels exhibited the desired consistency, drug distribution, pH, ability to form gel, and prolonged drug release in vitro. The (33) full factorial design was utilized for the revealing of the ideal figures for the selected independent variables, Na alg. (X1), HPMC (X2), and CaCl2 (X3) based on measurements of the viscosity (Y1) and percentage drug release after 6 h (Y2). A pharmacokinetic study of the optimum formulation on rabbits was also performed. The formulation containing 2% of Na alg., 0.9% of HPMC-K15M, and 0.1125% of CaCl2 was selected as the ideal formulation, which gave the theoretical values of 269.2 cP and 44.9% for viscosity and percentage of drug released after 6 h, respectively. The pharmacokinetic study showed that the selected oral Na alg. in situ gel formulation displayed a prolonged release effect compared to BH solution and the marketed tablet (Buspar®), which was confirmed by the low Cmax and high Tmax values. The optimum oral Na alg. in situ gel showed a 1.5-fold increment in bioavailability compared with the drug solution.

Ginger Extract-Loaded Sesame Oil-Based Niosomal Emulgel: Quality by Design to Ameliorate Anti-Inflammatory Activity.

Ginger, a natural plant belonging to the Zingeberaceae family, has been reported to have reasonable anti-inflammatory effects. The current study aimed to examine ginger extract transdermal delivery by generating niosomal vesicles as a promising nano-carrier incorporated into emulgel prepared with sesame oil. Particle size, viscosity, in vitro release, and ex vivo drug penetration experiments were performed on the produced formulations (ginger extract loaded gel, ginger extract loaded emulgel, ginger extract niosomal gel, and ginger extract niosomal emulgel). Carrageenan-induced edema in rat hind paw was employed to estimate the in vivo anti-inflammatory activity. The generated ginger extract formulations showed good viscosity and particle size. The in vitro release of ginger extract from niosomal formulation surpassed other formulations. In addition, the niosomal emulgel formulation showed improved transdermal flux and increased drug permeability through rabbit skin compared to other preparations. Most importantly, carrageenan-induced rat hind paw edema test confirmed the potential anti-inflammatory efficacy of ginger extract niosomal emulgel, compared to other formulations, as manifested by a significant decrease in paw edema with a superior edema inhibition potency. Overall, our findings suggest that incorporating a niosomal formulation within sesame oil-based emulgel might represent a plausible strategy for effective transdermal delivery of anti-inflammatory drugs like ginger extract.

Quality by Design for Optimizing a Novel Liposomal Jojoba Oil-Based Emulgel to Ameliorate the Anti-Inflammatory Effect of Brucine.

One of the recent advancements in research is the application of natural products in developing newly effective formulations that have few drawbacks and that boost therapeutic effects. The goal of the current exploration is to investigate the effect of jojoba oil in augmenting the anti-inflammatory effect of Brucine natural alkaloid. This is first development of a formulation that applies Brucine and jojoba oil int a PEGylated liposomal emulgel proposed for topical application. Initially, various PEGylated Brucine liposomal formulations were fabricated using a thin-film hydration method. (22) Factorial design was assembled using two factors (egg Phosphatidylcholine and cholesterol concentrations) and three responses (particle size, encapsulation efficiency and in vitro release). The optimized formula was incorporated within jojoba oil emulgel. The PEGylated liposomal emulgel was inspected for its characteristics, in vitro, ex vivo and anti-inflammatory behaviors. Liposomal emulgel showed a pH of 6.63, a spreadability of 48.8 mm and a viscosity of 9310 cP. As much as 40.57% of Brucine was released after 6 h, and drug permeability exhibited a flux of 0.47 µg/cm2·h. Lastly, % of inflammation was lowered to 47.7, which was significant effect compared to other formulations. In conclusion, the anti-inflammatory influence of jojoba oil and Brucine was confirmed, supporting their integration into liposomal emulgel as a potential nanocarrier.

Preparation, characterization and evaluation of anti-inflammatory and anti-nociceptive effects of brucine-loaded nanoemulgel.

Brucine (BRU) is a natural product derived from nux-vomica seeds. It is commonly used as an anti-inflammatory and anti-nociceptive drug to relieve arthritis and traumatic pain. Nevertheless, its use is significantly limited by its low aqueous solubility, as well as the gastrointestinal problems and systemic toxicity that may occur following oral administration. The goal of this study, therefore, was to formulate and evaluate a nanoemulgel formulation of BRU for enhanced topical anti-inflammatory and anti-nociceptive activities. Different formulations were developed (BRU gel, emulgel and nanoemulgel) using 1% w/w NaCMC as a gelling agent. The formulated preparations were assessed for their physical appearance, spreadability, viscosity, particle size, in vitro drug release and ex vivo permeation studies. In addition, the carrageenan-induced rat hind paw edema method was adopted to scrutinize the anti-inflammatory activity, while the hot plate method and acetic acid-induced writhing test were used to assess the anti-nociceptive activity of different formulations in male BALB/c mice. The formulated BRU-loaded preparations showed good physical characteristics. Cumulative drug release from BRU-loaded nanoemulgel was remarkably higher than that of the other formulations. Ex vivo drug permeation of the nanoemulgel formulation across rat skin showed enhanced drug permeation and higher transdermal flux as compared to BRU-loaded gel or emulgel. Most importantly, the carrageenan-induced rat hind paw edema model verified the efficient anti-inflammatory potential of BRU-loaded nanoemulgel. In addition, BRU-loaded nanoemulgel exhibited significant protective effects against thermal stimulation in the hot plate test and remarkably inhibited acetic acid-induced abdominal writhing in mice. Furthermore, a skin irritation test indicated that BRU-loaded nanoemulgel elicited neither edema nor erythema upon application to rat skin. Collectively, our results suggest that myrrh oil-based nanoemulgel might represent a promising delivery vehicle for potentiating the anti-inflammatory and anti-nociceptive actions of brucine.

Alpha 1 Antitrypsin Inhibits Dendritic Cell Activation and Attenuates Nephritis in a Mouse Model of Lupus.

Systemic lupus erythematosus (SLE) is an autoimmune disorder with a worldwide distribution and considerable mortality and morbidity. Although the pathogenesis of this disease remains elusive, over-reactive dendritic cells (DCs) play a critical role in the disease development. It has been shown that human alpha-1 antitrypsin (hAAT) has protective effects in type 1 diabetes and rheumatoid arthritis mouse models. In the present study, we tested the effect of AAT on DC differentiation and functions, as well as its protective effect in a lupus-prone mouse model. We showed that hAAT treatment significantly inhibited LPS (TLR4 agonist) and CpG (TLR9 agonist) -induced bone-marrow (BM)-derived conventional and plasmacytoid DC (cDC and pDC) activation and reduced the production of inflammatory cytokines including IFN-I, TNF-α and IL-1ß. In MRL/lpr mice, hAAT treatment significantly reduced BM-derived DC differentiation, serum autoantibody levels, and importantly attenuated renal pathology. Our results for the first time demonstrate that hAAT inhibits DC activation and function, and it also attenuates autoimmunity and renal damage in the MRL/lpr lupus model. These results imply that hAAT has a therapeutic potential for the treatment of SLE in humans.

Nicotinamide pelletization by fluidized hot melt granulation: L18 Hunter design to screen high risk variables.

L18 Hunter design was used to investigate the practicability of applying QbD approaches to fluidized hot melt granulation (FHMG) in preparing oral controlled release systems. Eight high-risk variables obtained from risk analysis were classified into chemical factors (type and percentage of meltable binder, matrix viscosity and percentage and filler type) and process variables (size fraction of meltable binder, inlet air volume and fluidization time). The variables were screened for their impacts on pellets characteristics. The obtained results showed that the meltable binder percentage was the significant variable affecting most responses. Flow properties, size distribution, bulk, and tapped densities were significantly (P<0.05) affected by the filler type, inlet air volume, and fluidization time. On the other hand, the matrix variables were non-significant to the dissolution parameters. Out of eight critical variables, it was found that the meltable binder percentage and size fraction, inlet air volume had the most significant effects and will be optimized in the second part of the study. In conclusion, QbD paradigm not only offered a robust FHMG technique to formulate controlled release formulations of hydrophilic drugs but also provided a time and cost saving advantage to pharmaceutical industry.