Composite metal substrate for thin film AlGaInP LED applications.

The fabrication and feasibility assessment of n-side up, thin-epilayer, AlGaInP-based vertical light-emitting-diodes (LEDs; emitting area: 1 mm × 1 mm) with a copper-invar-copper-composite metal (CIC) substrate was obtained by wafer bonding and epilayer transferring technologies. The structure of CIC substrate is a top Cu layer of 20 µm, a middle Invar layer of 64 µm, and a bottom Cu layer of 20 µm. The invar layer consists of Fe and Ni at a ratio of 70% to 30%. The coefficient of thermal expansion for CIC is about 6.1 × 10-6 /K, which is similar to that of the GaAs substrate (5.7 × 10-6 /K) and AlGaInP epilayers. Due to the high thermal conductivity (160 W/m-K) of 104-µm-thick CIC, the high performances of the packaged LEDs are obtained. They present a low red shift phenomenon (from 623 to 642 nm for 100 mA to 1 A) and a high output power 212 mW at 800 mA. The CIC substrate can be extended to fabricate high-efficiency thin film LEDs with conventional vertical electrodes.

Use of historical uranium air sampling data to estimate worker exposure potential to airborne radioactive particulate in a uranium processing facility.

Historical industrial hygiene monitoring records from a uranium processing plant were collected and analyzed to characterize exposure potential to airborne radioactive particulate. More than 2,100 samples were collected during the period of 1954-1968. The data was organized by job title, plant number, and year of measurement. Laboratory analysis of air samples indicated a wide range of potential exposures to the alpha-emitting particulate. Logarithmic transformation of the data was necessary to approximate Gaussian distributions. Geometric Mean (GM) values were used as the measure of central tendency within years. GM values ranged from 23-49 disintegrations per minute per cubic meter of air sampled (dpm/m3) with the years 1963 and 1964 being significantly higher than other years (ANOVA: p < 0.05). When comparing exposure potential across plants, GM ranged from 20-68 dpm/m3, with plants 5 and 8 being significantly higher than the others (ANOVA: p < 0.05). Exposure potential for specific job titles across the plants varied widely. GM for clerks was the lowest (11 dpm/m3) while furnace operators were the highest (235 dpm/m3). Other job titles with potentially high exposures were chemical operators, forklift operators, machine operators, and furnace operators. This analysis indicates the magnitude and distributions of worker exposure to alpha-emitting airborne particulate. Additional analysis and epidemiologic studies are planned for this facility.

Interlaboratory and intralaboratory variabilities in the Environmental Lead Proficiency Analytical Testing (ELPAT) Program.

The Environmental Lead Proficiency Analytical Testing (ELPAT) Program evaluates over 400 laboratories that perform lead measurements in paints, soils, and dusts. A previous National Institute for Occupational Safety and Health study, based on the ELPAT data over a 3-year period (1992-1995), found no large biases among common hotplate and microwave digestion techniques, but did detect small consistent bias between two common instrumental methods. This study expands on the earlier study by examining the total sample variability and its variation components (interlaboratory and intralaboratory). A correlation model was used to separate the variation components by estimating a variation ratio. The correlation model leads to a more general approach than a sample pairing technique developed by Youden. This study found no significant evidence that the relative contribution of intralaboratory and interlaboratory variability to total variability changes with lead loading levels. There were no significant differences in the relative contribution of variation components among three most commonly used analytical methods (combinations of sample preparation techniques and instrumental methods). The interlaboratory relative standard deviation is about 1.7 times the intralaboratory relative standard deviation. Both variation components are important parts of total variation although the laboratory-to-laboratory (including analyst-to-analyst) difference is greater than the within laboratory (including sample-to-sample) variation.

Perinatal toxicity associated with nickel chloride exposure.

Several reports have suggested that soluble nickel salts may affect development. In this study female Long-Evans rats drank nickel chloride solutions (0, 10, 50, or 250 ppm Ni) for 11 weeks prior to mating and then during two successive gestation (G1, G2) and lactation (L1, L2) periods. Pups were observed until weaning; breeder males were unexposed. Dams drinking 250 ppm consumed less liquid and more food per kilogram body weight than did controls (liquid: prebreeding, G1, and G2; food: prebreeding, G2 and L2). Maternal weight gain was reduced during G1 in the high- and middle-dose groups; indices of reproductive performance were comparable across groups. Pup birth weight was unaltered by treatment and weight gain was reduced only in male pups exposed to 50 ppm Ni during L1. The frequency of perinatal death is the most significant toxicologic finding of the study. The proportion of dead pups per litter was significantly elevated at the high dose in L1 and at 10 and 250 ppm in L2 (50 ppm, P = 0.076), with a dose-related response in both experimental segments. The number of dead pups per litter was significantly increased at each dose in L2. Prolactin levels in pups were unchanged by treatment and were reduced in dams at the high dose. We conclude that 10 ppm Ni represents the lowest observed adverse effect level (LOAEL) in this study.