Hard beta and gamma emissions of 124I. Impact on occupational dose in PET/CT.

AIM: The hard beta and gamma radiation of 124I can cause high doses to PET/CT workers. In this study we tried to quantify this occupational exposure and to optimize radioprotection. METHODS: Thin MCP-Ns thermoluminescent dosimeters suitable for measuring beta and gamma radiation were used for extremity dosimetry, active personal dosimeters for whole-body dosimetry. Extremity doses were determined during dispensing of 124I and oral administration of the activity to the patient, the body dose during all phases of the PET/CT procedure. In addition, dose rates of vials and syringes as used in clinical practice were measured. The procedure for dispensing 124I was optimized using newly developed shielding. RESULTS: Skin dose rates up to 100 mSv/min were measured when in contact with the manufacturer's vial containing 370 MBq of 124I. For an unshielded 5 ml syringe the positron skin dose was about seven times the gamma dose. Before optimization of the preparation of 124I, using an already reasonably safe technique, the highest mean skin dose caused by handling 370 MBq was 1.9 mSv (max. 4.4 mSv). After optimization the skin dose was below 0.2 mSv. CONCLUSION: The highly energetic positrons emitted by 124I can cause high skin doses if radioprotection is poor. Under optimized conditions occupational doses are acceptable. Education of workers is of paramount importance.

Patient and occupational dosimetry in double contrast barium enema examinations.

A new and relatively simple method is presented to distribute total dose-area product (DAP) over a number of projections that model exposure during double contrast barium enema (DCBE) examinations. In addition, hitherto unavailable entrance and effective doses to the physician performing the DCBE examination have been determined. DAP, fluoroscopy time, number of images as well as some patient data were collected for 150 DCBE examinations. For a subset of 50 examinations, the distribution of DAP over 12 hypothetical but representative projections was estimated by measuring the entrance dose in the centre of each of these projections during the complete procedure. Effective dose to the patient was obtained using DAP to effective dose conversion coefficients calculated for each of the 12 projections. Exposure of the worker was quantified by measuring the entrance dose at the forehead, neck, arms, right hand and legs. The sex-averaged effective dose to the patient per examination was 6.4+/-2.1 mSv (mean+/-SD; n=50) and the corresponding DAP was 44+/-22 Gy cm(2). The effective dose to the worker per examination was 0.52 microGy (n=50), whereas the highest entrance dose of 30+/-25 microGy was found for the right arm. The proposed method for deriving the distribution of total DAP over a set of representative projections is much less time consuming than visual observation of patient exposure, whilst accuracy seems acceptable. Entrance and effective doses per examination for workers in DCBE examinations are very low. For a normal workload, doses remain far below the legally established dose limits.

The effect of equipment set up on patient radiation dose in conventional and CT angiography of the renal arteries.

Patient radiation dose in angiography of the renal arteries was assessed and optimized after installing new radiological equipment. In three separate studies (n=50, 25 and 20) patient exposure was monitored in detail. For the first study default factory settings were used, for the second the number of digital subtraction angiography (DSA) images was halved and the X-ray beam filtering during fluoroscopy was increased, and for the third study filtering during DSA was increased as well. Standard projections were derived and used in Monte Carlo simulations to derive dose conversion coefficients to calculate effective dose from the dose-area product (DAP). Dose conversion coefficients were also calculated for CT angiography (CTA). Using default factory settings on the new angiography system, DAP, number of images and effective dose were much higher than on the replaced unit. For the studies given above, DAP was reduced from 144 Gy cm(2) to 65 Gy cm(2) to 32 Gy cm(2), and effective dose from 22 mSv to 11 mSv to 9.1 mSv, respectively. Effective dose due to CTA was 5.2 mSv. It is concluded that modern angiography systems, resulting in high customer satisfaction, may readily cause much higher patient exposure than older systems. These doses may also be much higher than necessary. Optimization before putting such systems into use is absolutely essential. Internationally accepted recommendations for image quality and technique factors in angiography would be of great help.

Patient and occupational dose in neurointerventional procedures.

Neurointerventional procedures can involve very high doses of radiation to the patient. Our purpose was to quantify the exposure of patients and workers during such procedures, and to use the data for optimisation. We monitored the coiling of 27 aneurysms, and embolisation of four arteriovenous malformations. We measured entrance doses at the skull of the patient using thermoluminescent dosemeters. An observer logged the dose-area product (DAP), fluoroscopy time and characteristics of the digital angiographic and fluoroscopic projections. We also measured entrance doses to the workers at the glabella, neck, arms, hands and legs. The highest patient entrance dose was 2.3 Gy, the average maximum entrance dose 0.9+/-0.5 Gy. The effective dose to the patient was estimated as 14.0+/-8.1 mSv. Other average values were: DAP 228+/-131 Gy cm(2), fluoroscopy time 34.8+/-12.6 min, number of angiographic series 19.3+/-9.4 and number of frames 267+/-143. The highest operator entrance dose was observed on the left leg (235+/-174 microGy). The effective dose to the operator, wearing a 0.35 mm lead equivalent apron, was 6.7+/-4.6 microSv. Thus, even the highest patient entrance dose was in the lower part of the range in which nonstochastic effects might arise. Nevertheless, we are trying to reduce patient exposure by optimising machine settings and clinical protocols, and by informing the operator when the total DAP reaches a defined threshold. The contribution of neurointerventional procedures to occupational dose was very small.