Root canal preparation in mandibular premolars with TRUShape and Vortex Blue: A micro-computed tomography study.

A comparison of the preparation ability of two root canal instrumentation systems in oval-shaped canals using micro-computed tomography was undertaken. Thirty extracted, single-rooted, human mandibular premolars with radiographically similar canal morphology were selected, allocated to two groups (N = 15) and prepared with TRUShape or Vortex Blue (VB). Each sample was subjected to three scans (20 µm resolution): pre-preparation and after preparation to sizes #30 and #40. Three-dimensional data sets were evaluated for canal volume, surface area and surface treatment. Matched axial slices in apical, middle and coronal root thirds were evaluated for cross-sectional area, roundness and transportation. Preparation with both instruments increased canal volumes and surface areas similarly and significantly (P < 0.001) with no significant difference between groups. TRUShape significantly enhanced surface treatment at both apical sizes (P < 0.05). Transportation exceeded 100 µm in only eight out of 90 cross sections. Both instruments performed similarly during preparation. TRUShape, however, significantly enhanced surface treatment.

Comparison of Mechanical and Indirect Ultrasonic Placement Technique on Mineral Trioxide Aggregate Retrofill Density in Simulated Root-end Surgery.

INTRODUCTION: The objective of this study was to evaluate the density of mineral trioxide aggregate (MTA) root-end filling placed by either manual condensation or manual condensation with indirect ultrasonic activation under simulated root-end surgery conditions in vitro. METHODS: Extracted human molar teeth were obtained and sectioned to provide single-rooted samples (n = 50). Roots were instrumented to a size of 40 with a .04 taper and obturated with a warm vertical technique. The coronal end of each root was embedded in resin. A root-end resection and root-end preparation were completed on each root. Samples were randomly assigned to receive root-end fillings with ProRoot MTA (Dentsply, Tulsa, OK) by 1 of 2 techniques: manual condensation alone (group M, n = 25) or manual condensation with indirect ultrasonic activation (group U, n = 25). MTA was placed incrementally to the level of the root end using the enumerated technique. Samples were weighed immediately before and after filling placement. MTA was removed from all samples so as not to change the root-end preparation, rinsed, and dried. Each sample then underwent MTA placement by the opposite technique, and weight was again measured immediately before and after MTA placement. MTA filling weights for each technique were analyzed statistically using a technique for repeated measures analysis. Statistical analysis was conducted to account for any carryover or order effects. RESULTS: After adjustment for carryover effects, it was found that regardless of the order of placement, the mean fill weight of MTA produced by the indirect ultrasonic method was on average 4.42 mg heavier than that produced by manual condensation alone. This result was statistically significant (P < .0003). CONCLUSIONS: Under simulated root-end surgery conditions, indirect ultrasonic condensation of MTA root-end fillings was shown to produce a filling that was significantly denser than MTA placed by manual condensation alone.

A comparison of equivalent doses of lidocaine and articaine in maxillary posterior tooth extractions: case series.

OBJECTIVES: Local anaesthesia is the standard of care during dental extractions. With the advent of newer local anesthetic agents, it is often difficult for the clinician to decide which agent would be most efficacious in a given clinical scenario. This study assessed the efficacy of equal-milligram doses of lidocaine and articaine in achieving surgical anaesthesia of maxillary posterior teeth diagnosed with irreversible pulpitis. MATERIAL AND METHODS: This case-series evaluated a total of 41 patients diagnosed with irreversible pulpitis in a maxillary posterior tooth. Patients randomly received an infiltration of either 3.6 mL (72 mg) 2% lidocaine with 1:100,000 epinephrine or 1.8 mL (72 mg) 4% articaine with 1:100,000 epinephrine in the buccal fold and palatal soft tissue adjacent to the tooth. After 10 minutes, initial anaesthesia of the tooth was assessed by introducing a sterile 27-gauge needle into the gingival tissue adjacent to the tooth, followed by relief of the gingival cuff. Successful treatment was considered to have occurred when the tooth was extracted with no reported pain. Data was analyzed with the Fisher's exact test, unpaired t-test and normality test. RESULTS: Twenty-one patients received lidocaine and 20 received articaine. Forty of the 41 patients achieved initial anaesthesia 10 minutes after injection: 21 after lidocaine and 19 after articaine (P = 0.488). Pain-free extraction was accomplished in 33 patients: 19 after lidocaine and 14 after articaine buccal and palatal infiltrations (P = 0.226). CONCLUSIONS: There was no significant difference in efficacy between equivalent doses of lidocaine and articaine in the anaesthesia of maxillary posterior teeth with irreversible pulpitis.