RESUMO
BACKGROUND CONTEXT: Large annulus fibrosus (AF) defects often lead to a high rate of reherniation, particularly in the medial AF region, which has limited self-healing capabilities. The increasing prevalence of herniated discs underscores the need for effective repair strategies. PURPOSE: The objectives of this study were to design an AF repair technique to reduce solve the current problems of insufficient mechanical properties and poor sealing capacity. STUDY DESIGN: In vitro biomechanical experiments and finite element analysis. METHODS: The materials used in this study were patches and hydrogels with good biocompatibility and sufficient mechanical properties to withstand loading in the lumbar spine. Five repair techniques were assessed in this study: hydrogel filler (HF), AF patch medial barrier (MB), AF patch medial barrier and hydrogel filler (MB&HF), AF patch medial-lateral barrier (MLB), and AF patch medial-lateral barrier and hydrogel filler (MLB&HF). The repair techniques were subjected to in vitro testing (400 N axial compression and 0-500 N fatigue loading at 5Hz) and finite element analysis (400 N axial compression) to evaluate the effectiveness at repairing large AF defects. The evaluation included repair tightness, spinal stability, and fatigue resistance. RESULTS: From the in vitro testing, the failure load of the repair techniques was in the following order HF
RESUMO
STUDY DESIGN: Biomechanical testings and finite element analysis. OBJECTIVES: This study aims to investigate how annulus fibrosus (AF) incision size (RIS, Ratio of incision width to AF height) and shape affect intervertebral disc (IVD) biomechanics. METHODS: A validated finite element model of lumbar spines simulated various incisions in the middle-right posterior region of the AF, with different sizes and shapes. Simulations included axial compression, flexion, extension, bending, and rotation. Parameters assessed included stability, re-herniation, and IVD degeneration by analyzing stress, height, Intradiscal pressure (IDP), and the range of motion (ROM). RESULTS: Incision increased AF stress and ROM under 3 Nm moment, with values rising as RIS increased. RIS exceeding 40% resulted in a 20% AF stress increase during compression and extension, while RIS over 50% led to over 20% AF stress increase during other motions. Incision stress also increased with higher RIS, particularly surpassing 50% RIS. IDP rose across all incision shapes. Endplate stress increased (9.9%-48.9%) with larger incisions, with average increases of 12.8%, 12.7%, 30.5%, and 22.8% for circular, oval, square, and rectangular incisions. Compression and rotation minimally affected NP pressure (<15%), while flexion (19.8%-38.8%) and bending (18.5%-43.9%) had a more pronounced effect. ROM increased with RIS (20.0% â¼ 77.4%), especially with an incision RIS exceeding 40%. CONCLUSIONS: AF injury elevates AF stress, reduces spine stability, heightens degeneration risk with increasing RIS. Reherniation risk rises when RIS exceeds 40%. Circular or oval incisions maintain spine biomechanics better than square or rectangular ones.
RESUMO
AIM: To investigate the long-term effects of alendronate (Aln), a widely used oral bisphosphonate, on fracture healing and bone remodeling in ovariectomized rats. METHODS: Adult female SD rats underwent ovariectomy, and then bilateral femoral osteotomy at 12 weeks post-ovariectomy. From d 2 post-ovariectomy, the animals were divided into 3 groups, and treated with Aln (3 mg·kg(-1)·d(-1), po) for 28 weeks (Aln/Aln), Aln for 12 weeks and saline for 16 weeks (Aln/Saline) or saline for 28 weeks (Saline/Saline). At 6 and 16 weeks post-fracture, the fracture calluses were examined with X-ray radiography, and biomechanical testing and histological analysis were performed. The calluses were labeled with tetracycline and calcein to evaluate the mineral apposition rate (MAR). RESULTS: The fracture line was less distinct in the 2 Aln-treated groups at 6 weeks post-fracture, and disappeared in all the 3 groups at 16 weeks post-fracture. The size of the callus and radiographic density of the femora in the Aln/Aln group were the highest among the 3 groups at 6 and 16 weeks post-fracture. Similar results were observed in the ultimate load at failure and energy absorption. However, the treatment with Aln delayed endochondral ossification of the callus, and significantly increased the total sagittal-sectional area, percentage callus area and callus thickness, and decreased the MAR at 6 and 16 weeks post-fracture. CONCLUSION: In the ovariectomized rat model, Aln is beneficial for the mechanical properties of the callus, but delays callus remodeling by suppressing the remodeling of woven bone into lamellar bone.
Assuntos
Alendronato/uso terapêutico , Conservadores da Densidade Óssea/uso terapêutico , Remodelação Óssea/efeitos dos fármacos , Fraturas do Fêmur/tratamento farmacológico , Fêmur/lesões , Consolidação da Fratura/efeitos dos fármacos , Alendronato/administração & dosagem , Animais , Conservadores da Densidade Óssea/administração & dosagem , Modelos Animais de Doenças , Esquema de Medicação , Feminino , Fraturas do Fêmur/metabolismo , Fraturas do Fêmur/patologia , Fêmur/metabolismo , Fêmur/patologia , Ovariectomia , Ratos , Ratos Sprague-Dawley , Fatores de TempoRESUMO
Objective: The purpose of this study was to analyze the feasibility of repairing a ruptured intervertebral disc using a patch secured to the inner surface of the annulus fibrosus (AF). Different material properties and geometries for the patch were evaluated. Methods: Using finite element analysis, this study created a large box-shaped rupture in the posterior-lateral region of the AF and then repaired it with a circular and square inner patch. The elastic modulus of the patches ranged from 1 to 50 MPa to determine the effect on the nucleus pulposus (NP) pressure, vertical displacement, disc bulge, AF stress, segmental range of motion (ROM), patch stress, and suture stress. The results were compared against the intact spine to determine the most suitable shape and properties for the repair patch. Results: The intervertebral height and ROM of the repaired lumbar spine was similar to the intact spine and was independent of the patch material properties and geometry. The patches with a modulus of 2-3 MPa resulted in an NP pressure and AF stresses closest to the healthy disc, and produced minimal contact pressure on the cleft surfaces and minimal stress on the suture and patch of all models. Circular patches caused lower NP pressure, AF stress and patch stress than the square patch, but also caused greater stress on the suture. Conclusion: A circular patch with an elastic modulus of 2-3 MPa secured to the inner region of the ruptured annulus fibrosus was able to immediately close the rupture and maintain an NP pressure and AF stress similar to the intact intervertebral disc. This patch had the lowest risk of complications and produced the greatest restorative effect of all patches simulated in this study.
RESUMO
OBJECTIVE: To compare the biomechanical properties of a novel annular incision technique, an oblique incision made approximately 60° to the spinal column, with the traditional transverse and longitudinal annular slit incision in an ex vivo sheep lumbar spine model. METHODS: Sixteen sheep lumbar spines were used for the current ex vivo biomechanical comparative study. Functional spine unit (FSU) specimens composed of two vertebrae and one disc in the middle was cut from the whole lumbar spine. Annular slit incisions of 5 mm were made in different directions with a 15-blade knife at the intervertebral disc, following which partial discectomy was performed to produce the following groups: control with no incision, transverse slit, longitudinal slit and oblique slit groups. The specimens were then subjected to flexion-extension, lateral bending, axial rotation and compression tests. RESULTS: As expected, the control group showed the least range of motion (ROM) in the flexion-extension test. The oblique slit group showed a trend toward a smaller ROM than the transverse and longitudinal groups in 1, 2, 3 and 5 Nm flexion-extension tests; these differences were not statistically significant (P > 0.05). In addition, the transverse (5.80° ± 0.20°), longitudinal (5.77° ± 0.67°) and oblique (5.47° ± 0.43°) slit groups showed a significantly larger ROM than the control group (3.22° ± 0.28°) in 2 Nm lateral bending tests (P < 0.05). Compared with the transverse and longitudinal groups, the oblique group also showed a trend toward a smaller ROM in lateral bending tests (P > 0.05). Following increments in the axial torsion force, the ROM was greater in all four experimental groups than the ROM with 1 Nm axial torsion. Furthermore, a significantly smaller axial rotational ROM was found in the oblique than the transverse group for 1 and 5 Nm force (P < 0.05). With increase in the axial force to 5 Nm, the ROM in the oblique slit group (4.71° ± 0.52°) was significantly smaller than that in the transverse group (7.25° ± 0.46°, P < 0.05), but not significantly different from that of the longitudinal slit group (5.84° ± 0.23°, P > 0.05). Comparable ultimate loads to failure were found in the oblique, transverse and longitudinal groups; the highest ultimate load to failure being in the control group (P > 0.05). CONCLUSION: The novel oblique slit annular incision to the intervertebral disc showed a trend toward better biomechanical properties than the traditional transverse and longitudinal slit incisions.
Assuntos
Discotomia/métodos , Disco Intervertebral/fisiologia , Disco Intervertebral/cirurgia , Vértebras Lombares/fisiologia , Vértebras Lombares/cirurgia , Animais , Fenômenos Biomecânicos , Distribuição Aleatória , Amplitude de Movimento Articular , OvinosRESUMO
BACKGROUND: Ovarian cancer is a cancerous growth arising from the ovary. OBJECTIVE: This study was aimed to explore the molecular mechanism of the development and progression of the ovarian cancer. METHODS: We first identified the differentially expressed genes (DEGs) between the ovarian cancer samples and the healthy controls by analyzing the GSE14407 affymetrix microarray data, and then the functional enrichments of the DEGs were investigated. Furthermore, we constructed the protein-protein interaction network of the DEGs using the STRING online tools to find the genes which might play important roles in the progression of ovarian cancer. In addition, we performed the enrichment analysis to the PPI network. RESULTS: Our study screened 659 DEGs, including 77 up- and 582 down-regulated genes. These DEGs were enriched in pathways such as Cell cycle, p53 signaling pathway, Pathways in cancer and Drug metabolism. CCNE1, CCNB2 and CYP3A5 were the significant genes identified from these pathways. Protein-protein interaction (PPI) network was constructed and network Module A was found closely associated with ovarian cancer. Hub nodes such as VEGFA, CALM1, BIRC5 and POLD1 were found in the PPI network. Module A was related to biological processes such as mitotic cell cycle, cell cycle, nuclear division, and pathways namely Cell cycle, Oocyte meiosis and p53 signaling pathway. CONCLUSIONS: It indicated that ovarian cancer was closely associated to the dysregulation of p53 signaling pathway, drug metabolism, tyrosine metabolism and cell cycle. Besides, we also predicted genes such as CCNE1, CCNB2, CYP3A5 and VEGFA might be target genes for diagnosing the ovarian cancer.