Characterization of methane oxidation in a simulated landfill cover system by comparing molecular and stable isotope mass balances.

Biological methane oxidation may be regarded as a method of aftercare treatment for landfills to reduce climate relevant methane emissions. It is of social and economic interest to estimate the behavior of bacterial methane oxidation in aged landfill covers due to an adequate long-term treatment of the gas emissions. Different approaches assessing methane oxidation in laboratory column studies have been investigated by other authors recently. However, this work represents the first study in which three independent approaches, ((i) mass balance, (ii) stable isotope analysis, and (iii) stoichiometric balance of product (CO2) and reactant (CH4) by CO2/CH4-ratio) have been compared for the estimation of the biodegradation by a robust statistical validation on a rectangular, wide soil column. Additionally, an evaluation by thermal imaging as a potential technique for the localization of the active zone of bacterial methane oxidation has been addressed in connection with stable isotope analysis and CO2/CH4-ratios. Although landfills can be considered as open systems the results for stable isotope analysis based on a closed system correlated better with the mass balance than calculations based on an open system. CO2/CH4-ratios were also in good agreement with mass balance. In general, highest values for biodegradation were determined from mass balance, followed by CO2/CH4-ratio, and stable isotope analysis. The investigated topsoil proved to be very suitable as a potential cover layer by removing up to 99% of methane for CH4 loads of 35-65gm-2d-1 that are typical in the aftercare phase of landfills. Finally, data from stable isotope analysis and the CO2/CH4-ratios were used to trace microbial activity within the reactor system. It was shown that methane consumption and temperature increase, as a cause of high microbial activity, correlated very well.

Characterization of the Korotkoff sounds using joint time-frequency analysis.

The sounds associated with the five classical Korotkoff phases are clinically important for measuring systolic and diastolic blood pressures. The frequency ranges of the sounds have already been described simply using the overall peak frequencies within each phase by Fourier methods. However, such analysis may be missing potentially useful clinical information. The aim of this study was to compare features associated with the different phases of the Korotkoff sounds obtained during blood pressure measurement using a joint time-frequency analysis (JTFA) technique. A single operator recorded Korotkoff sounds from 25 healthy subjects using a measurement system comprising cardiology stethoscope, microphone, amplifier and recording system for computer sound digitization, and a MiniDisc system for playback to the cardiologist for Korotkoff phase classification. We have shown that using this system the phase classification by the cardiologist is repeatable, with no significant differences found in the number of sounds allocated to phases on two separate recording assessments. The digitized sounds were processed using a MATLAB-based short-time Fourier transform JTFA technique and differences in time, frequency and amplitude characteristics between the phases compared. It was found that on average, phase III had the largest overall amplitude and high frequency energy. Phase II had the greatest high frequency component and longest murmur, and was visibly the most complex phase in terms of time and frequency content. In contrast, phases IV and V had the lowest amplitude and frequency components. Overall, the statistically significant transitions between phases were: phase I to II with increases in high frequency (224 to 275 Hz) (p < 0.01) and sound duration (49 to 98 ms) (p < 0.0001), II to III with a significant decrease in sound duration (to 37 ms) (p < 0.0001), III to IV with decreases in maximum amplitude (0.95 to 0.25), highest frequency (262 to 95 Hz), and relative high frequency energy of the sounds (0.61 to 0.10) (all p < 0.0001), and IV to V with decreases in the maximum amplitude (0.25 to 0.13) (p < 0.0002) and high frequency energy (0.10 to 0.03) (p < 0.005). This study has demonstrated that joint time-frequency analysis of Korotkoff sounds was able to identify characteristic differences associated with the different phases classified by the expert cardiologist. Ultimately, exploiting the joint time and frequency characteristics of the sounds may improve blood pressure measurement and help to assess the stiffness of the peripheral arteries.