RESUMO
A variety of (diphosphine)platinum(II) carbonate complexes, (LL)Pt(CO(3)), are readily prepared from the corresponding (diphosphine)platinum dichlorides by treatment with silver carbonate in dichoromethane solution provided that water is present. This reaction also permits facile preparation of analogous (13)C-labeled complexes. The carbonate ligands in these complexes have been characterized by IR and (13)C NMR spectroscopy. Alternative preparative routes involve conversion of the precursor dichlorides to the corresponding dialkoxides or diphenoxides, followed by treatment with water and carbon dioxide. Various reaction intermediates have been spectroscopically observed in the latter syntheses. Two crystalline modifications of (Ph(2)PCH(2)CH(2)CH(2)PPh(2))Pt(CO(3)), one with and one without a dichloromethane of solvation, have been studied by single-crystal X-ray diffraction. Crystal data for PtP(2)O(3)C(28)H(26): P2(1)/c, Z = 4, T = 200 K, a = 10.362(8) Å, b = 14.743(6) Å, c = 19.183(10) Å, beta = 122.69(6) degrees. Crystal data for PtP(2)O(3)C(28)H(26).CH(2)Cl(2): P2(1)/c, Z = 4, T approximately 298 K, a = 11.744(2) Å, b = 15.526(3) Å, c = 15.866(3) Å, beta = 101.58(1) degrees.
RESUMO
Cross-linking silica aerogels with organic groups has been shown to improve the strength over un-cross-linked aerogels by as much as 2 orders of magnitude. Previous cross-linking chemistry has been developed using solvents specifically chosen to dissolve the monomers and accommodate the reaction temperature. Because the process of making the aerogels requires so much solvent, it is of interest to consider less toxic solvents such as ethanol to increase safety and enhance scale up. To this end, two different epoxy precursors with suitable solubility in ethanol were evaluated as cross-linkers for silica gels prepared from (3-aminopropyl)triethoxysilane and tetraethylorthosilicate. In addition, 1,6-bis(trimethoxysilyl)hexane (BTMSH) was used as an additive in the underlying silica structure to add flexibility to the aerogels. It was found that the ethanol-derived aerogels exhibited more shrinkage than those prepared from other solvents but that including BTMSH in the aerogels significantly reduced this shrinkage. Inclusion of BTMSH also imparted the ability of the aerogel monoliths to recover elastically when compressed up to 50% strain. In addition, optimized cross-linked aerogels prepared in this study have mechanical properties comparable to those using other more undesirable solvents and cross-linkers.