RESUMO
Due to differences in actuation and design, active and passive industrial back exoskeletons could influence functional performance, i.e., work performance, perceived task difficulty, and discomfort, differently. Therefore, this study investigated and compared the impact of the active CrayX (7 kg) and passive Paexo Back (4.5 kg) on functional performance. Eighteen participants performed twelve work-related tasks with both types of exoskeletons and without (NoExo). The CrayX hindered work performance up to 22% in multiple tasks, compared to the Paexo Back and NoExo, while work performance between NoExo and the Paexo Back condition was more comparable, except for stair climbing (13% hindrance). Perceived task difficulty and discomfort seldomly varied between both exoskeletons. Although the CrayX shows promise to benefit workers, limitations in hindrance and comfort should first be addressed. The Paexo Back has demonstrated an advantage in certain static tasks. However, increasing its potential across a broader range of tasks seems warranted.Practitioner Summary: Differences between industrial back exoskeletons with regard to functional performance, i.e. work performance, discomfort and perceived task difficulty, were investigated by evaluating the active CrayX and passive Paexo Back back exoskeletons. The CrayX significantly hindered functional performance, while the Paexo Back seldomly affected functional performance.Abbreviations: WMSD: Work-related musculoskeletal disorder; NoExo: No Exoskeleton; GD: General discomfort; PTD: Perceived task difficulty; BMI: Body Mass Index.
Assuntos
Exoesqueleto Energizado , Doenças Musculoesqueléticas , Desempenho Profissional , Humanos , Índice de Massa Corporal , IndústriasRESUMO
OBJECTIVE: Over the course of the twenty-first century, work-related musculoskeletal disorders are still persisting among blue collar workers. At present, no epidemiological overview exists. Therefore, a systematic review and meta-analysis was performed on the epidemiology of work-related musculoskeletal disorders (WMSD) within Europe's secondary industries. METHODS: Five databases were screened, yielding 34 studies for the qualitative analysis and 17 for the quantitative analysis. Twelve subgroups of WMSDs were obtained for the meta-analysis by means of predefined inclusion criteria: back (overall), upper back, lower back, neck, shoulder, neck/shoulder, elbow, wrist/hand, leg (overall), hip, knee, and ankle/feet. RESULTS: The most prevalent WMSDs were located at the back (overall), shoulder/neck, neck, shoulder, lower back and wrist WMSDs with mean 12-month prevalence values of 60, 54, 51, 50, 47, and 42%, respectively. The food industry was in the majority of subgroups the most prominent researched sector and was frequently associated with high prevalence values of WMSDs. Incidence ratios of upper limb WMSDs ranged between 0.04 and 0.26. Incidence ratios could not be calculated for other anatomical regions due to the lack of sufficient articles. CONCLUSION: WMSDs are still highly present among blue collar workers. Relatively high prevalence values and low incidence ratios indicate a limited onset of WMSDs with however long-term complaints.
Assuntos
Doenças Musculoesqueléticas , Doenças Profissionais , Humanos , Incidência , Doenças Musculoesqueléticas/diagnóstico , Doenças Musculoesqueléticas/epidemiologia , Doenças Profissionais/diagnóstico , Doenças Profissionais/epidemiologia , Prevalência , Fatores de Risco , Inquéritos e QuestionáriosRESUMO
Occupational back-support exoskeletons, categorized as active or passive, hold promise for mitigating work-related musculoskeletal disorders. However, their impact on combined physical and cognitive aspects of industrial work performance remains inadequately understood, especially regarding potential differences between exoskeleton categories. A randomized, counterbalanced cross-over study was conducted, comparing the active CrayX, passive Paexo Back, and a no exoskeleton condition. A 15-min dual task was used to simulate both cognitive and physical aspects of industrial work performance. Cognitive workload parameters included reaction time, accuracy, and subjective measures. Physical workload included movement duration, segmented in three phases: (1) walking to and grabbing the box, (2) picking up, carrying, and putting down the box, and (3) returning to the starting point. Comfort of both devices was also surveyed. The Paexo significantly increased movement duration in the first segment compared to NoExo (Paexo = 1.55 ± 0.19 s; NoExo = 1.32 ± 0.17 s; p < .01). Moreover, both the Paexo and CrayX increased movement duration for the third segment compared to NoExo (CrayX = 1.70 ± 0.27 s; Paexo = 1.74 ± 0.27 s, NoExo = 1.54 ± 0.23 s; p < .01). No significant impact on cognitive outcomes was observed. Movement Time 2 was not significantly affected by both exoskeletons. Results of the first movement segment suggest the Paexo may hinder trunk bending, favoring the active device for dynamic movements. Both devices may have contributed to a higher workload as the movement duration in the third segment increased compared to NoExo.
RESUMO
Mental fatigue (MF) is likely to occur in the industrial working population. However, the link between MF and industrial work performance has not been investigated, nor how this interacts with a passive lower back exoskeleton used during industrial work. Therefore, to elucidate its potential effect(s), this study investigated the accuracy of work performance and movement duration through a dual task paradigm and compared results between mentally fatigued volunteers and controls, with and without the exoskeleton. No main effects of MF and the exoskeleton were found. However, when mentally fatigued and wearing the exoskeleton, movement duration significantly increased compared to the baseline condition (ßMF:Exo = 0.17, p = .02, ω2 = .03), suggesting an important interaction between the exoskeleton and one's psychobiological state. Importantly, presented data indicate a negative effect on production efficiency through increased performance time. Further research into the cognitive aspects of industrial work performance and human-exoskeleton interaction is therefore warranted.
Assuntos
Exoesqueleto Energizado , Desempenho Profissional , Humanos , Movimento , Fadiga Mental/psicologia , Fenômenos Biomecânicos , EletromiografiaRESUMO
Back support soft exosuits are promising solutions to reduce risk of musculoskeletal injuries at workplaces resulting from physically demanding and repetitive lifting tasks. Design of novel active exosuits address the impact on the muscle activity and metabolic costs but do not consider other critical aspects such as comfort and user perception during the intended tasks. Thus, in this study, we describe a novel soft active exosuit in line with its impact on physiological and subjective measures during lifting. We tested four healthy participants who performed repetitive lifting tasks with and without this exosuit. The exosuit provided assistance proportional to the lumbar flexion angle measured using an inertial measurement unit. We measured the participant's multimodal physiological measures including surface electromyography, metabolic cost, heart rate, and skin temperature. We also measured subjective scores on user exertion, task load, and device acceptability. All participants perceived a reduction in task load when using the exosuit. Three participants showed reduction of muscle activity for the erector spinae muscles. The metabolic costs and heart rate reserve reduced for two participants, with similar trends for skin temperature. For future development of workplace exosuits, we recommend incorporating assessments of both physiological and subjective measures, considering the user-dependent response to the exosuit.
Assuntos
Exoesqueleto Energizado , Humanos , Eletromiografia , Região Lombossacral , Amplitude de Movimento Articular/fisiologia , PercepçãoRESUMO
OBJECTIVES: To provide an overview of protocols assessing the effect of occupational exoskeletons on users and to formulate recommendations towards a literature-based assessment framework to benchmark the effect of occupational exoskeletons on the user. METHODS: PubMed (MEDLINE), Web of Science database and Scopus were searched (March 2, 2021). Studies were included if they investigated the effect of one or more occupational exoskeletons on the user. RESULTS: In total, 139 eligible studies were identified, encompassing 33, 25 and 18 unique back, shoulder and other exoskeletons, respectively. Device validation was most frequently conducted using controlled tasks while collecting muscle activity and biomechanical data. As the exoskeleton concept matures, tasks became more applied and the experimental design more representative. With that change towards realistic testing environments came a trade-off with experimental control, and user experience data became more valuable. DISCUSSION: This evidence mapping systematic review reveals that the assessment of occupational exoskeletons is a dynamic process, and provides literature-based assessment recommendations. The homogeneity and repeatability of future exoskeleton assessment experiments will increase following these recommendations. The current review recognises the value of variability in evaluation protocols in order to obtain an overall overview of the effect of exoskeletons on the users, but the presented framework strives to facilitate benchmarking the effect of occupational exoskeletons on the users across this variety of assessment protocols.
Assuntos
Benchmarking , Exoesqueleto Energizado , Humanos , OmbroRESUMO
Shoulder exoskeletons potentially reduce overuse injuries in industrial settings including overhead work or lifting tasks. Previous studies evaluated these devices primarily in laboratory setting, but evidence of their effectiveness outside the lab is lacking. The present study aimed to evaluate the effectiveness of two passive shoulder exoskeletons and explore the transfer of laboratory-based results to the field. Four industrial workers performed controlled and in-field evaluations without and with two exoskeletons, ShoulderX and Skelex in a randomized order. The exoskeletons decreased upper trapezius activity (up to 46%) and heart rate in isolated tasks. In the field, the effects of both exoskeletons were less prominent (up to 26% upper trapezius activity reduction) while lifting windscreens weighing 13.1 and 17.0 kg. ShoulderX received high discomfort scores in the shoulder region and usability of both exoskeletons was moderate. Overall, both exoskeletons positively affected the isolated tasks, but in the field the support of both exoskeletons was limited. Skelex, which performed worse in the isolated tasks compared to ShoulderX, seemed to provide the most support during the in-field situations. Exoskeleton interface improvements are required to improve comfort and usability. Laboratory-based evaluations of exoskeletons should be interpreted with caution, since the effect of an exoskeleton is task specific and not all in-field situations with high-level lifting will equally benefit from the use of an exoskeleton. Before considering passive exoskeleton implementation, we recommend analyzing joint angles in the field, because the support is inherently dependent on these angles, and to perform in-field pilot tests. This paper is the first thorough evaluation of two shoulder exoskeletons in a controlled and in-field situation.
Assuntos
Exoesqueleto Energizado , Fenômenos Biomecânicos , Humanos , Laboratórios , OmbroRESUMO
Background: The CYBERLEGs-gamma (CLs-É£) prosthesis has been developed to investigate the possibilities of powerful active prosthetics in restoring human gait capabilities after lower limb amputation. Objective: The objective of this study was to determine the performance of the CLs-É£ prosthesis during simulated daily activities. Methods: Eight participants with a transfemoral amputation (age: 55 ± 15 years, K-level 3, registered under: NCT03376919) performed a familiarization session, an experimental session with their current prosthesis, three training sessions with the CLs-É£ prosthesis and another experimental session with the CLs-É£ prosthesis. Participants completed a stair-climbing-test, a timed-up-and-go-test, a sit-to stand-test, a 2-min dual-task and a 6-min treadmill walk test. Results: Comparisons between the two experimental sessions showed that stride length significantly increased during walking with the CLs-É£ prosthesis (p = .012) due to a greater step length of the amputated leg (p = .035). Although a training period with the prototype was included, preferred walking speed was significantly slower (p = .018), the metabolic cost of transport was significantly higher (p = .028) and reaction times significantly worsened (p = .012) when walking with the CLs-É£ compared to the current prosthesis. Conclusions: It can be stated that a higher physical and cognitive effort were required when wearing the CLs-É£ prosthesis. Positive outcomes were observed regarding stride length and stair ambulation. Future prosthetics development should minimize the weight of the device and integrate customized control systems. A recommendation for future research is to include several shorter training periods or a prolonged adaptation period.