Suicidal ideation and mental health disorders in young school children across Europe.

INTRODUCTION: The aim of this study is to measure the prevalence of suicidal ideation and thoughts of death in elementary school children in a European survey and to determine the associated socio-demographic and clinical factors. METHODS: Data refer to children aged 6-12 (N=7062) from Italy, Turkey, Romania, Bulgaria, Lithuania, Germany, and the Netherlands randomly selected in primary schools. Suicidal thoughts and death ideation were measured using a computerized pictorial diagnostic tool from the Dominic Interactive (DI) completed by the children. The Strengths and Difficulties Questionnaire (SDQ) was administrated to teachers and parents along with a socio-demographic questionnaire. RESULTS: Suicidal ideation was present in 16.96% of the sample (from 9.9 in Italy to 26.84 in Germany), death thoughts by 21.93% (from 7.71% in Italy to 32.78 in Germany). SI and DT were more frequent in single-parent families and large families. Externalizing disorders were strongly correlated with SI and DT after controlling for other factors and this was true for internalizing disorders only when reported by the children. CONCLUSION: Recognizing suicidal ideation in young children may be recommended as part of preventive strategies such as screening in the context of the presence of any mental health problems whether externalizing or internalizing.

Scrape-off layer reflectometer for Alcator C-Mod.

A swept-frequency X-mode reflectometer is being built for Alcator C-Mod to measure the scrape-off layer density profiles at the top, middle, and bottom locations in front of both the new lower hybrid launcher and the new ion cyclotron range of frequencies antenna. The system is planned to operate between 100 and 146 GHz at sweep rates from 10 µs to 1 ms, and will cover a density range of approximately 10(16)-10(20) m(-3) at B(0)=5-5.4 T. To minimize the effects of density fluctuations, both differential phase and full phase reflectometry will be employed. Design, test data, and calibration results of this electronics system will be discussed. To reduce attenuation losses, tallguide (TE(01)) will be used for most of the transmission line system. Simulations of high mode conversion in tallguide components, such as e-plane hyperbolic secant radius of curvature bends, tapers, and horn antennas will be shown. Experimental measurements of the total attenuation losses of these components in the lower hybrid waveguide run will also be presented.