High-density polyethylene (HDPE)-degrading potential bacteria from marine ecosystem of Gulf of Mannar, India.

AIMS: Assessment of high-density polyethylene (HDPE)-degrading bacteria isolated from plastic waste dumpsites of Gulf of Mannar. METHODS AND RESULTS: Rationally, 15 bacteria (GMB1-GMB15) were isolated by enrichment technique. GMB5 and GMB7 were selected for further studies based on their efficiency to degrade the HDPE and identified as Arthrobacter sp. and Pseudomonas sp., respectively. Assessed weight loss of HDPE after 30 days of incubation was nearly 12% for Arthrobacter sp. and 15% for Pseudomonas sp. The bacterial adhesion to hydrocarbon (BATH) assay showed that the cell surface hydrophobicity of Pseudomonas sp. was higher than Arthrobacter sp. Both fluorescein diacetate hydrolysis and protein content of the biofilm were used to test the viability and protein density of the biomass. Acute peak elevation was observed between 2 and 5 days of inoculation for both bacteria. Fourier transform infrared (FT-IR) spectrum showed that keto carbonyl bond index (KCBI), Ester carbonyl bond index (ECBI) and Vinyl bond index (VBI) were increased indicating changes in functional group(s) and/or side chain modification confirming the biodegradation. CONCLUSION: The results pose us to suggest that both Pseudomonas sp. and Arthrobacter sp. were proven efficient to degrade HDPE, albeit the former was more efficacious, yet the ability of latter cannot be neglected. SIGNIFICANCE AND IMPACT OF THE STUDY: Recent alarm on ecological threats to marine system is dumping plastic waste in the marine ecosystem and coastal arena by anthropogenic activity. In maintenance phase of the plastic-derived polyethylene waste, the microbial degradation plays a major role; the information accomplished in this work will be the initiating point for the degradation of polyethylene by indigenous bacterial population in the marine ecosystem and provides a novel eco-friendly solution in eco-management.

Intrinsic characteristics of Cr6⁺-resistant bacteria isolated from an electroplating industry polluted soils for plant growth-promoting activities.

The Cr(6+)-resistant plant growth-promoting bacteria was isolated from soil samples that were collected from an electroplating industry at Coimbatore, India, that had tolerated chromium concentrations up to 500 mg Cr(6+)/L in Luria-Bertani medium. Based on morphology, physiology, and biochemical characteristics, the strain was identified as Bacillus sp. following the Bergey's manual of determinative bacteriology. Evaluation of plant growth-promoting parameters has revealed the intrinsic ability of the strain for the production of indole-3-acetic acid (IAA), siderophore, and solubilization of insoluble phosphate. Bacillus sp. have utilized tryptophan as a precursor for their growth and produced IAA (122 µg/mL). Bacillus sp. also exhibited the production of siderophore that was tested qualitatively using Chrome Azurol S (CAS) assay solution and utilized the insoluble tricalcium phosphate as the sole source of phosphate exhibiting higher rate of phosphate solubilization after 72 h of incubation (1.45 µg/mL). Extent of Cr(6+) uptake and accumulation of Cr(6+) in the cell wall of Bacillus sp. was investigated using atomic absorption spectrophotometer and scanning electron microscope-energy dispersive spectroscopy, respectively. The congenital capability of this Cr(6+)-resistant plant growth-promoting Bacillus sp. could be employed as bacterial inoculum for the improvement of phytoremediation in heavy metal contaminated soils.