Comparative Assessment of Methane Emissions from Onshore LNG Facilities Measured Using Differential Absorption Lidar.

This study provides results from measurements of methane emissions from three onshore LNG liquefaction facilities and two regasification facilities across different regions using the Differential Absorption Lidar (DIAL) technique. The measurement approach was to quantify, at each facility, emissions from the key functional elements (FEs), defined as spatially separable areas related to different identified processes. The DIAL technique enabled quantification of emissions at the FE level, allowing emission factors (EFs) to be determined for each FE using activity data. The comprehensive data set presented here should not be used for annualization, however shows the potential of what could be achieved with a larger sample size in terms of potential methane reduction and improving inventory accuracy. Among the benefits in obtaining data with this level of granularity is the possibility to compare the emissions of similar FEs on different plants including FEs present in both liquefaction and regasification facilities. Emissions from noncontinuous sources and superemitters can also be identified and quantified enabling more accurate inventory reporting and targeted maintenance and repair. Site throughput during the measurement periods was used to characterize total site EF; on average the methane losses were 0.018% and 0.070% of throughput at the regasification and liquefaction facilities, respectively.

Observation of a new channel, the production of CH3, in the abstraction reaction of OH radicals with acetaldehyde.

Using laser flash photolysis coupled to photo-ionization time-of-flight mass spectrometry (PIMS), methyl radicals (CH3) have been detected as primary products from the reaction of OH radicals with acetaldehyde (ethanal, CH3CHO) with a yield of ∼15% at 1-2 Torr of helium bath gas. Supporting measurements based on laser induced fluorescence studies of OH recycling in the OH/CH3CHO/O2 system are consistent with the PIMS study. Master equation calculations suggest that the origin of the methyl radicals is from prompt dissociation of chemically activated acetyl products and hence is consistent with previous studies which have shown that abstraction, rather than addition/elimination, is the sole route for the OH + acetaldehyde reaction. However, the observation of a significant methyl product yield suggests that energy partitioning in the reaction is different from the typical early barrier mechanism where reaction exothermicity is channeled preferentially into the newly formed bond. The master equation calculations predict atmospheric yields of methyl radicals of ∼9%. The implications of the observations in atmospheric and combustion chemistry are briefly discussed.

Kinetics of CH2OO reactions with SO2, NO2, NO, H2O and CH3CHO as a function of pressure.

Kinetics of CH2OO Criegee intermediate reactions with SO2, NO2, NO, H2O and CH3CHO and CH2I radical reactions with NO2 are reported as a function of pressure at 295 K. Measurements were made under pseudo-first-order conditions using flash photolysis of CH2I2-O2-N2 gas mixtures in the presence of excess co-reagent combined with monitoring of HCHO reaction products by laser-induced fluorescence (LIF) spectroscopy and, for the reaction with SO2, direct detection of CH2OO by photoionisation mass spectrometry (PIMS). Rate coefficients for CH2OO + SO2 and CH2OO + NO2 are independent of pressure in the ranges studied and are (3.42 ± 0.42) × 10(-11) cm(3) s(-1) (measured between 1.5 and 450 Torr) and (1.5 ± 0.5) × 10(-12) cm(3) s(-1) (measured between 25 and 300 Torr), respectively. The rate coefficient for CH2OO + CH3CHO is pressure dependent, with the yield of HCHO decreasing with increasing pressure. Upper limits of 2 × 10(-13) cm(3) s(-1) and 9 × 10(-17) cm(3) s(-1) are placed on the rate coefficients for CH2OO + NO and CH2OO + H2O, respectively. The upper limit for the rate coefficient for CH2OO + H2O is significantly lower than has been reported previously, with consequences for modelling of atmospheric impacts of CH2OO chemistry.

Diversity arrays technology (DArT) for high-throughput profiling of the hexaploid wheat genome.

Despite a substantial investment in the development of panels of single nucleotide polymorphism (SNP) markers, the simple sequence repeat (SSR) technology with a limited multiplexing capability remains a standard, even for applications requiring whole-genome information. Diversity arrays technology (DArT) types hundreds to thousands of genomic loci in parallel, as previously demonstrated in a number diploid plant species. Here we show that DArT performs similarly well for the hexaploid genome of bread wheat (Triticum aestivum L.). The methodology previously used to generate DArT fingerprints of barley also generated a large number of high-quality markers in wheat (99.8% allele-calling concordance and approximately 95% call rate). The genetic relationships among bread wheat cultivars revealed by DArT coincided with knowledge generated with other methods, and even closely related cultivars could be distinguished. To verify the Mendelian behaviour of DArT markers, we typed a set of 90 Cranbrook x Halberd doubled haploid lines for which a framework (FW) map comprising a total of 339 SSR, restriction fragment length polymorphism (RFLP) and amplified fragment length polymorphism (AFLP) markers was available. We added an equal number of DArT markers to this data set and also incorporated 71 sequence tagged microsatellite (STM) markers. A comparison of logarithm of the odds (LOD) scores, call rates and the degree of genome coverage indicated that the quality and information content of the DArT data set was comparable to that of the combined SSR/RFLP/AFLP data set of the FW map.