Miniaturized spectrometer with intrinsic long-term image memory.

Miniaturized spectrometers have great potential for use in portable optoelectronics and wearable sensors. However, current strategies for miniaturization rely on von Neumann architectures, which separate the spectral sensing, storage, and processing modules spatially, resulting in high energy consumption and limited processing speeds due to the storage-wall problem. Here, we present a miniaturized spectrometer that utilizes a single SnS2/ReSe2 van der Waals heterostructure, providing photodetection, spectrum reconstruction, spectral imaging, long-term image memory, and signal processing capabilities. Interface trap states are found to induce a gate-tunable and wavelength-dependent photogating effect and a non-volatile optoelectronic memory effect. Our approach achieves a footprint of 19 µm, a bandwidth from 400 to 800 nm, a spectral resolution of 5 nm, and a > 104 s long-term image memory. Our single-detector computational spectrometer represents a path beyond von Neumann architectures.

Enhanced NO2 Sensitivity of Vertically Stacked van der Waals Heterostructure Gas Sensor and Its Remarkable Electric and Mechanical Tunability.

Nanodevices based on van der Waals heterostructures have been predicted, and shown, to have unprecedented operational principles and functionalities that hold promise for highly sensitive and selective gas sensors with rapid response times and minimal power consumption. In this study, we fabricated gas sensors based on vertical MoS2/WS2 van der Waals heterostructures and investigated their gas sensing capabilities. Compared with individual MoS2 or WS2 gas sensors, the MoS2/WS2 van der Waals heterostructure gas sensors are shown to have enhanced sensitivity, faster response times, rapid recovery, and a notable selectivity, especially toward NO2. In combination with a theoretical model, we show that it is important to take into account created trapped states (flat bands) induced by the adsorption of gas molecules, which capture charges and alter the inherent built-in potential of van der Waals heterostructure gas sensors. Additionally, we note that the performance of these MoS2/WS2 heterostructure gas sensors could be further enhanced using electrical gating and mechanical strain. Our findings highlight the importance of understanding the effects of altered built-in potentials arising from gas molecule adsorption induced flat bands, thus offering a way to enhance the gas sensing performance of van der Waals heterostructure gas sensors.

Band Alignment Transition and Enhanced Performance in Vertical SnS2/MoS2 van der Waals Photodetectors.

The strong light-matter interaction and naturally passivated surfaces of van der Waals materials make heterojunctions of such materials ideal candidates for high-performance photodetectors. In this study, we fabricated SnS2/MoS2 van der Waals heterojunctions and investigated their photoelectric properties. Using an applied gate voltage, we can effectively alter the band arrangement and achieve a transition in type II and type I junctions. It is found that the SnS2/MoS2 van der Waals heterostructures are type II heterojunctions when the gate voltage is above -25 V. Below this gate voltage, the heterojunctions become type I. Photoelectric measurements under various wavelengths of incident light reveal enhanced sensitivity in the ultraviolet region and a broadband sensing range from 400 to 800 nm. Moreover, due to the transition from type II to type I band alignment, the measured photocurrent saturates at a specific gate voltage, and this value depends crucially on the bias voltage and light wavelength, providing a potential avenue for designing compact spectrometers.

Field Effect Transistor Gas Sensors Based on Mechanically Exfoliated Van der Waals Materials.

The high surface-to-volume ratio and flatness of mechanically exfoliated van der Waals (vdW) layered materials make them an ideal platform to investigate the Langmuir absorption model. In this work, we fabricated field effect transistor gas sensors, based on a variety of mechanically exfoliated vdW materials, and investigated their electrical field-dependent gas sensing properties. The good agreement between the experimentally extracted intrinsic parameters, such as equilibrium constant and adsorption energy, and theoretically predicted values suggests validity of the Langmuir absorption model for vdW materials. Moreover, we show that the device sensing behavior depends crucially on the availability of carriers, and giant sensitivities and strong selectivity can be achieved at the sensitivity singularity. Finally, we demonstrate that such features provide a fingerprint for different gases to quickly detect and differentiate between low concentrations of mixed hazardous gases using sensor arrays.

Light-Tunable Polarity and Erasable Physisorption-Induced Memory Effect in Vertically Stacked InSe/SnS2 Self-Powered Photodetector.

van der Waals heterojunctions with tunable polarity are being actively explored for more Moore and more-than-Moore device applications, as they can greatly simplify circuit design. However, inadequate control over the multifunctional operational states is still a challenge in their development. Here, we show that a vertically stacked InSe/SnS2 van der Waals heterojunction exhibits type-II band alignment, and its polarity can be tuned by an external electric field and by the wavelength and intensity of an illuminated light source. Moreover, such SnS2/InSe diodes are self-powered broadband photodetectors with good performance. The self-powered performance can be further enhanced significantly with gas adsorption, and the device can be quickly restored to the state before gas injection using a gate voltage pulse. Our results suggest a way to achieve and design multiple functions in a single device with multifield coupling of light, electrical field, gas, or other external stimulants.

Efficient Suppression of Charge Recombination in Self-Powered Photodetectors with Band-Aligned Transferred van der Waals Metal Electrodes.

Recombination of photogenerated electron-hole pairs dominates the photocarrier lifetime and then influences the performance of photodetectors and solar cells. In this work, we report the design and fabrication of band-aligned van der Waals-contacted photodetectors with atomically sharp and flat metal-semiconductor interfaces through transferred metal integration. A unity factor α is achieved, which is essentially independent of the wavelength of the light, from ultraviolet to near-infrared, indicating effective suppression of charge recombination by the device. The short-circuit current (0.16 µA) and open-circuit voltage (0.72 V) of the band-aligned van der Waals-contacted devices are at least 1 order of magnitude greater than those of band-aligned deposited devices and 2 orders of magnitude greater than those of non-band-aligned deposited devices. High responsivity, detectivity, and polarization sensitivity ratio of 283 mA/W, 6.89 × 1012 cm Hz1/2 W-1, and 3.05, respectively, are also obtained for the device at zero bias. Moreover, the efficient suppression of charge recombination in our air-stable self-powered photodetectors also results in a fast response speed and leads to polarization-sensitive performance.

Graphene/SnS2 van der Waals Photodetector with High Photoresponsivity and High Photodetectivity for Broadband 365-2240 nm Detection.

The fabrication of graphene/SnS2 van der Waals photodetectors and their photoelectrical properties are systematically investigated. It was found that a dry transferred graphene/SnS2 van der Waals heterostructure had a broadband sensing range from ultraviolet (365 nm) to near-infrared (2.24 µm) and respective improved responsivities and photodetectivities of 7.7 × 103 A/W and 8.9 × 1013 jones at 470 nm and 2 A/W and 1.8 × 1010 jones at 1064 nm. Moreover, positive and negative photoconductance effects were observed when the photodetectors were illuminated by photon sources with energies greater and smaller than the bandgap of SnS2, respectively. The photoresponsivity (R) versus incident power density (P) follows the empirical law R ∝ Pinß, with ß > -1 for positive photoconductance effects and ß < -1 for negative photoconductance effects. On the basis of the Fowler-Nordheim tunneling model and a Poisson and drift-diffusion simulation, we show quantitatively that the barrier height and barrier width of the heterostructure photodetector could be controlled by a laser and an external electrical field through a photogating effect generated by carriers trapped at the interface, which could be used to tune the separation and transport of photogenerated carriers. Our results may be useful for the design of high performance van der Waals heterojunction photodetectors.

Giant gauge factor of Van der Waals material based strain sensors.

There is an emergent demand for high-flexibility, high-sensitivity and low-power strain gauges capable of sensing small deformations and vibrations in extreme conditions. Enhancing the gauge factor remains one of the greatest challenges for strain sensors. This is typically limited to below 300 and set when the sensor is fabricated. We report a strategy to tune and enhance the gauge factor of strain sensors based on Van der Waals materials by tuning the carrier mobility and concentration through an interplay of piezoelectric and photoelectric effects. For a SnS2 sensor we report a gauge factor up to 3933, and the ability to tune it over a large range, from 23 to 3933. Results from SnS2, GaSe, GeSe, monolayer WSe2, and monolayer MoSe2 sensors suggest that this is a universal phenomenon for Van der Waals semiconductors. We also provide proof of concept demonstrations by detecting vibrations caused by sound and capturing body movements.

Enhanced NO2 Sensitivity in Schottky-Contacted n-Type SnS2 Gas Sensors.

Layered materials are highly attractive in gas sensor research due to their extraordinary electronic and physicochemical properties. The development of cheaper and faster room-temperature detectors with high sensitivities especially in the parts per billion level is the main challenge in this rapidly developing field. Here, we show that sensitivity to NO2 (S) can be greatly improved by at least two orders of magnitude using an n-type electrode metal. Unconventionally for such devices, the ln(S) follows the classic Langmuir isotherm model rather than S as is for a p-type electrode metal. Excellent device sensitivities, as high as 13,000% for 9 ppm and 97% for 1 ppb NO2, are achieved with Mn electrodes at room temperature, which can be further tuned and enhanced with the application of a bias. Long-term stability, fast recovery, and strong selectivity toward NO2 are also demonstrated. Such impressive features provide a real solution for designing a practical high-performance layered material-based gas sensor.

Electrical Contact Barriers between a Three-Dimensional Metal and Layered SnS2.

Field-effect transistors derived from traditional 3D semiconductors are rapidly approaching their fundamental limits. Layered semiconducting materials have emerged as promising candidates to replace restrictive 3D semiconductor materials. However, contacts between metals and layered materials deviate from Schottky-Mott behavior when determined by transport methods, while X-ray photoelectron spectroscopy measurements suggest that the contacts should be at the Schottky limit. Here, we present a systematic investigation on the influence of metal selection when electrically contacting SnS2, a layered metal dichalcogenide semiconductor with the potential to replace silicon. It is found that the electrically measured barrier height depends also weakly on the work function of the metal contacts with slopes of 0.09 and -0.34 for n-type and p-type Schottky contacts, respectively. Based on the Kirchhoff voltage law and considering a current path induced by metallic defects, we found that the Schottky barrier still follows the Schottky-Mott limits and the electrically measured barrier height mainly originates from the van der Waals gap between the metal and SnS2, and the slope depends on the magnitude of the van der Waals capacitance.