Toward Conductive Additive Free Organic Electrode for Lithium-Ion Battery Using Supramolecular Columnar Organization.

With the aim to meet the greatest challenge facing organic batteries, namely the low conductivity of the electrodes, the electrochemical properties of a series of substituted perylene diimides able to form semi-conductive columnar material are investigated. Depending on the substituent group, a strong influence of this group on the reversibility, redox potential but especially on the gravimetric capacity of the electrodes is observed. In the case of substitution by a simple propyl group, the corresponding diimide shows a complete electrochemical activity with only 10% by mass of conductive additive and even shows a half-capacity activity without any additive and without particular electrode engineering. Extensive research has highlighted the intrinsic reactivity of the columnar material but also its perpetual rearrangement during charge/discharge cycles. This study shows that the amount of conductive additive can be significantly reduced by adapting the design of the molecular material and favoring the assembly of redox units in the form of a conductive column.

Toxicological effects of CdSe nanocrystals on the marine diatom Phaeodactylum tricornutum: The first mass spectrometry-based proteomic approach.

In the marine environment, benthic diatoms from estuarine and coastal sediments are among the first targets of nanoparticle pollution whose potential toxicity on marine organisms is still largely unknown. It is therefore relevant to improve our knowledge of interactions between these new pollutants and microalgae, the key players in the control of marine resources. In this study, the response of P. tricornutum to CdSe nanocrystals (CdSe NPs) of 5 nm (NP5) and 12 nm (NP12) in diameter was evaluated through microscopic, physiological, biochemical and proteomic approaches. NP5 and NP12 affected cell growth but oxygen production was only slightly decreased by NP5 after 1-d incubation time. In our experimental conditions, a high CdSe NP dissolution was observed during the first day of culture, leading to Cd bioaccumulation and oxidative stress, particularly with NP12. However, after a 7-day incubation time, proteomic analysis highlighted that P. tricornutum responded to CdSe NP toxicity by regulating numerous proteins involved in protection against oxidative stress, cellular redox homeostasis, Ca2+ regulation and signalling, S-nitrosylation and S-glutathionylation processes and cell damage repair. These proteome changes allowed algae cells to regulate their intracellular ROS level in contaminated cultures. P. tricornutum was also capable to control its intracellular Cd concentration at a sufficiently low level to preserve its growth. To our knowledge, this is the first work allowing the identification of proteins differentially expressed by P. tricornutum subjected to NPs and thus the understanding of some molecular pathways involved in its cellular response to nanoparticles. SIGNIFICANCE: The microalgae play a key role in the control of marine resources. Moreover, they produce 50% of the atmospheric oxygen. CdSe NPs are extensively used in the industry of renewable energies and it is regrettably expected that these pollutants will sometime soon appear in the marine environment through surface runoff, urban effluents and rivers. Since estuarine and coastal sediments concentrate pollutants, benthic microalgae which live in superficial sediments will be among the first targets of nanoparticle pollution. Thus, it is relevant to improve our knowledge of interactions between diatoms and nanoparticles. Proteomics is a powerful tool for understanding the molecular mechanisms triggered by nanoparticle exposure, and our study is the first one to use this tool to identify proteins differentially expressed by P. tricornutum subjected to CdSe nanocrystals. This work is fundamental to improve our knowledge about the defence mechanisms developed by algae cells to counteract damage caused by CdSe NPs.

Use of qNMR for speciation of flaxseeds (Linum usitatissimum) and quantification of cyanogenic glycosides.

This report describes a routine method taking less than 20 min to quantify cyanogenic glycosides such as linustatin and neolinustatin from flaxseeds (Linum usitatissimum L.) using 1H nuclear magnetic resonance. After manual dehulling, a higher linustatin content was shown in the almond fraction, while neolinustatin and total cyanogenic glycoside contents were significantly higher in hulls. Linustatin and neolinustatin were quantified in seven cultivars grown in two locations in three different years. Linustatin, neolinustatin, and total cyanogenic glycosides ranged between 91 and 267 mg/100 g, 78-272 mg/100 g, and 198-513 mg/100 g dry weight flaxseeds, respectively. NMR revealed differences of up to 70% between samples with standard deviation variations lower than 6%. This study shows that NMR is a very suitable tool to perform flaxseed varietal selection for the cyanogenic glycoside content. Graphical abstract qNMR can be used to perform flaxseed varietal selection for the cyanogenic glycoside content.

Improved ACOM pattern matching in 4D-STEM through adaptive sub-pixel peak detection and image reconstruction.

The technique known as 4D-STEM has recently emerged as a powerful tool for the local characterization of crystalline structures in materials, such as cathode materials for Li-ion batteries or perovskite materials for photovoltaics. However, the use of new detectors optimized for electron diffraction patterns and other advanced techniques requires constant adaptation of methodologies to address the challenges associated with crystalline materials. In this study, we present a novel image-processing method to improve pattern matching in the determination of crystalline orientations and phases. Our approach uses sub-pixel adaptive image processing to register and reconstruct electron diffraction signals in large 4D-STEM datasets. By using adaptive prominence and linear filters, we can improve the quality of the diffraction pattern registration. The resulting data compression rate of 103 is well-suited for the era of big data and provides a significant enhancement in the performance of the entire ACOM data processing method. Our approach is evaluated using dedicated metrics, which demonstrate a high improvement in phase recognition. Several features are extracted from the registered data to map properties such as the spot count, and various virtual dark fields, which are used to enhance the handling of the results maps. Our results demonstrate that this data preparation method not only enhances the quality of the resulting image but also boosts the confidence level in the analysis of the outcomes related to determining crystal orientation and phase. Additionally, it mitigates the impact of user bias that may occur during the application of the method through the manipulation of parameters.

The Impact of Intergrain Phases on the Ionic Conductivity of the LAGP Solid Electrolyte Material Prepared by Spark Plasma Sintering.

Li1.5Al0.5Ge1.5(PO4)3 (LAGP) is a promising oxide solid electrolyte for all-solid-state batteries due to its excellent air stability, acceptable electrochemical stability window, and cost-effective precursor materials. However, further improvement in the ionic conductivity performance of oxide solid-state electrolytes is hindered by the presence of grain boundaries and their associated morphologies and composition. These key factors thus represent a major obstacle to the improved design of modern oxide based solid-state electrolytes. This study establishes a correlation between the influence of the grain boundary phases, their 3D morphology, and compositions formed under different sintering conditions on the overall LAGP ionic conductivity. Spark plasma sintering has been employed to sinter oxide solid electrolyte material at different temperatures with high compacity values, whereas a combined potentiostatic electrochemical impedance spectroscopy, 3D FIB-SEM tomography, XRD, and solid-state NMR/materials modeling approach provides an in-depth analysis of the influence of the morphology, structure, and composition of the grain boundary phases that impact the total ionic conductivity. This work establishes the first 3D FIB-SEM tomography analysis of the LAGP morphology and the secondary phases formed in the grain boundaries at the nanoscale level, whereas the associated 31P and 27Al MAS NMR study coupled with materials modeling reveals that the grain boundary material is composed of Li4P2O7 and disordered Li9Al3(P2O7)3(PO4)2 phases. Quantitative 31P MAS NMR measurements demonstrate that optimal ionic conductivity for the LAGP system is achieved for the 680 °C SPS preparation when the disordered Li9Al3(P2O7)3(PO4)2 phase dominates the grain boundary composition with reduced contributions from the highly ordered Li4P2O7 phases, whereas the 27Al MAS NMR data reveal that minimal structural change is experienced by each phase throughout this suite of sintering temperatures.

In situ ESEM using 3-D printed and adapted accessories to observe living plantlets and their interaction with enzyme and fungus.

This paper describes an innovative way of using environmental scanning electron microscopy (ESEM) and the development of a suitable accessory to perform in situ observation of living seedlings in the ESEM. We provide details on fabrication of an accessory that proved to be essential for such experiments but inexpensive and easy to build in the laboratory, and present our in situ observations of the tissue and cell surfaces. Sample-specific configurations and optimized tuning of the ESEM were defined to maintain Arabidopsis and flax seedlings viable throughout repetitive exposure to the imaging conditions in the microscope chamber. This method permitted us to identify cells and tissues of the live plantlets and characterize their surface morphology during their early stage of growth and development. We could extend the application of this technique, to visualize the response of living cells and tissues to exogenous enzymatic treatments with polygalacturonase in Arabidopsis, and their interaction with hyphae of the wilt fungus Verticillium dahliae during artificial infection in flax plantlets. Our results provide an incentive to the use of the ESEM for in situ studies in plant science and a guide for researchers to optimize their electron microscopy observation in the relevant fields.

IL versus DES: Impact on chitin pretreatment to afford high quality and highly functionalizable chitosan.

Chitin is mainly extracted from crustaceans, but this resource is seasonally dependent and can represent a major drawback to satisfy the traceability criterion for high valuable applications. Insect resources are valuable alternatives due to their lower mineral content. However, the deacetylation of chitin into chitosan is still an expensive process. Therefore, we herein compare the impact of both DES/IL-pretreatments on the efficiency of the chemical deacetylation of chitin carried out over two insect sources (Bombyx eri, BE and Hermetia illucens, HI) and shrimp shells (S). The results showed that chitosans obtained from IL-pretreated chitins from BE larva, present lower acetylation degrees (13-17%) than DES-pretreated samples (18-27%). A selective N-acylation reaction with oleic acid has also been performed on the purest and most deacetylated chitosans leading to high substitution degrees (up to 27%). The overall approach validates the proper chitin source and processing methodology to achieve high quality and highly functionalizable chitosan.

Straightforward extraction and selective bioconversion of high purity chitin from Bombyx eri larva: Toward an integrated insect biorefinery.

Chitins of different purity grades (45%, 89.7% and 93.3%) were efficiently extracted from Bombyx eri larva and fully physico-chemically characterized. Compared to commercially available and extracted α-chitin from shrimp shell, the collected data showed that insect chitins had similar characteristics in terms of crystallographic structures (α-chitin), thermal stability and degree of acetylation (>87%). The major differences lay in the crystallinity indexes (66% vs 75% for shrimp chitin) and in the morphological structures. Furthermore, low ash contents were determined for the insect chitins (1.90% vs 21.73% for shrimp chitin), making this chitin extraction and purification easier, which is highly valuable for an industrial application. Indeed, after only one step (deproteinization), the obtained chitin from Bombyx eri showed higher purity grade than the one extracted from shrimp shells under the same conditions. Insect chitins were then subjected to room temperature ionic liquid (RTIL) pretreatment prior to enzymatic degradation and presented a higher enzymatic digestibility compared to commercial one whatever their purity grade and would be thus a more relevant source for the selective production of N-acetyl-D-glucosamine (899.2 mg/g of chitin-2 stepsvs 760 mg/g of chitin com). Moreover, for the first time, the fermentescibility of chitin hydrolysates was demonstrated with Scheffersomyces stipitis used as ethanologenic microorganism.

Phenylpropanoid profiling reveals a class of hydroxycinnamoyl glucaric acid conjugates in Isatis tinctoria leaves.

The brassicaceous herb, Isatis tinctoria, is an ancient medicinal plant whose rosette leaf extracts have anti-inflammatory and anti-allergic activity. Brassicaceae are known to accumulate a variety of phenylpropanoids in their rosette leaves acting as antioxidants and a UV-B shield, and these compounds often have pharmacological potential. Nevertheless, knowledge about the phenylpropanoid content of I. tinctoria leaves remains limited to the characterization of a number of flavonoids. In this research, we profiled the methanol extracts of I. tinctoria fresh leaf extracts by liquid chromatography - mass spectrometry (LC-MS) and focused on the phenylpropanoid derivatives. We report the structural characterization of 99 compounds including 18 flavonoids, 21 mono- or oligolignols, 2 benzenoids, and a wide spectrum of 58 hydroxycinnamic acid esters. Besides the sinapate esters of malate, glucose and gentiobiose, which are typical of brassicaceous plants, these conjugates comprised a large variety of glucaric acid esters that have not previously been reported in plants. Feeding with 13C6-glucaric acid showed that glucaric acid is an acyl acceptor of an as yet unknown acyltransferase activity in I. tinctoria rosette leaves. The large amount of hydroxycinnamic acid derivatives changes radically our view of the woad metabolite profile and potentially contributes to the pharmacological activity of I. tinctoria leaf extracts.

Unravelling the architecture and dynamics of tropane alkaloid biosynthesis pathways using metabolite correlation networks.

The tropane alkaloid spectrum in Solanaceae is highly variable within and between species. Little is known about the topology and the coordination of the biosynthetic pathways leading to the variety of tropine and pseudotropine derived esters in the alkaloid spectrum, or about the metabolic dynamics induced by tropane alkaloid biosynthesis stimulating conditions. A good understanding of the metabolism, including all ramifications, is however necessary for the development of strategies to increase the abundance of pharmacologically interesting compounds such as hyoscyamine and scopolamine. The present study explores the tropane alkaloid metabolic pathways in an untargeted approach involving a correlation-based network analysis. Using GC-MS metabolite profiling, the variation and co-variation among tropane alkaloids and primary metabolites was monitored in 60 Datura innoxia Mill. individuals, of which half were exposed to tropane alkaloid biosynthesis stimulating conditions by co-culture with Agrobacterium rhizogenes. Considerable variation was evident in the relative proportions of the tropane alkaloids. Remodeling of the tropane alkaloid spectrum under co-culture with A. rhizogenes involved a specific and strong increase of hyoscyamine production and revealed that the accumulation of hyoscyamine, 3-tigloyloxy-6,7-epoxytropane, and 3-methylbutyryloxytropane was controlled independently of the majority of tropane alkaloids. Based on correlations between metabolites, we propose a biosynthetic origin of hygrine, the order of esterification of certain di-oxygenated tropanes, and that the rate of acetoxylation contributes to control of hyoscyamine production. Overall, this study shows that the biosynthesis of tropane alkaloids may be far more complex and finely controlled than previously expected.