Gender difference in bowing of the sagittal femoral morphology measurement using magnetic resonance imaging.

The importance of femoral sagittal bowing on total knee arthroplasty (TKA) has not been actively discussed. Femoral sagittal bowing can lead to cortex damage, fractures, or femoral malalignment. Therefore, the purpose of this study was to evaluate femoral sagittal bowing at different segments of the femur in the Korean population, and to discuss the implications on total knee arthroplasty. Differences in the morphology of femoral sagittal bowing for 978 patients-829 women and 148 men-were evaluated using magnetic resonance imaging. The angle between the femoral mechanical axis and the anterior cortex line was measured for all the patients. In addition, the gender difference in femoral sagittal bowing was investigated. The angle of femoral sagittal bowing with the mechanical axis was 2.8˚ ± 2.2˚. The angles for femoral sagittal bowing were 2.9˚ ± 2.2˚ and 2.3˚ ± 2.6˚ for females and males, respectively. Thus, a gender difference was found in the femoral sagittal bowing (p < 0.05). Excessive sagittal bowing of the femur can affect the final sagittal position of the femoral component, and this has implications for implant design selection. We recommend that surgeons accurately perform pre-operative evaluation of femoral bowing to prevent potential malalignment, rotation, and abnormal stresses between the femur and implant.

Finite element analysis of the influence of the posterior tibial slope on mobile-bearing unicompartmental knee arthroplasty.

BACKGROUND: The most common modes of failure reported in unicompartmental knee arthroplasty (UKA) in its first two decades were wear on the polyethylene (PE) insert, component loosening, and progressive osteoarthritis in the other compartment. The rates of implant failure due to poor component positioning in patients who have undergone UKA have been reported. However, the effect of the posterior tibial slope on the biomechanical behavior of mobile-bearing Oxford medial UKA remains unknown. METHODS: We applied finite element (FE) analysis to evaluate the effects of the posterior tibial slope in mobile-bearing UKA on the contact stresses in the superior and inferior surfaces of PE inserts and articular cartilage as well as the forces exerted on the anterior cruciate ligament (ACL). Seven FE models for posterior tibial slopes of -1°, 1°, 3°, 5°, 7°, 9°, and 11° were developed and analyzed under normal-level walking conditions based on this approach. RESULTS: The maximum contact stresses on both the superior and inferior surfaces of the PE insert decreased as the posterior tibial slope increased. However, the maximum contact stress on the lateral articular cartilage and the force exerted on the ACL increased as the posterior tibial slope increased. CONCLUSIONS: Increasing the tibial slope led to a reduction in the contact stress on the PE insert. However, a high contact stress on the other compartment and increased ACL force can cause progressive osteoarthritis in the other compartment and failure of the ACL.

The posterior cortical axis as an alternative reference for femoral component placement in total knee arthroplasty.

BACKGROUND: Although several reference axes have been established for determining femoral rotational alignment during total knee arthroplasty (TKA), the most accurate axis is undetermined. This study determines the relationship between the posterior cortical axis (PCA) and the trochlear anterior line (TAL) of the femur in relation to the epicondylar axis. METHODS: A total of 341 patients who underwent TKA for osteoarthritis were enrolled. Patients who had undergone previous bony surgery or replacement that might have changed the femoral geometry were excluded. Finally, 336 patients (200 females and 136 males) were included in the study. The angles between the transepicondylar axis (TEA) and TAL and TEA and the femoral PCA (FPCA) were evaluated. We also assessed whether there was any significant differences in variance and gender in these two angles. Student's t tests were used to determine the significance of coronal alignment and any gender-based differences. The variances between the TAL/TEA and FPCA/TEA angles were compared using F tests. RESULTS: The FPCA was externally rotated by 2.6° ± 3.6°, and the trochlear anterior line was internally rotated by 5.2° ± 5.5°, relative to the TEA. Gender-based differences were observed in the comparisons between anatomical references and TEA. CONCLUSIONS: The FPCA is a more conservative landmark than the TAL for intraoperative or postoperative approximation of the TEA. When conventional reference axes, such as the posterior condylar axis and the anteroposterior axis, are inaccurate, surgeons can refer to this alternative reference. These findings demonstrate that the FPCA may be useful for determining the rotational alignment of the femoral component before and during TKA.

The femoral trochlear anterior line is a better alternative intra-operative reference compared to femoral anterior tangent line for femoral rotation in both genders in total knee arthroplasty.

PURPOSE: To determine the most reliable reference axis for the femoral component rotation in TKA patients by comparing the trochlear anterior line (TAL) and the femoral anterior tangent line (FAT). To evaluate the variability of each anatomic parameter in a Korean population. METHODS: Magnetic resonance images (MRIs) were taken for 500 patients (400 females and 100 males) with knee joint osteoarthritis who had Kellgren and Lawrence grade 3 and 4 prior to TKA in our institution between February 2016 and September 2017. It was investigated that whether significant differences in variance and gender exist for TAL and FAT. RESULTS: TAL and the FAT were internally rotated by 5.1° ± 3.1° and 6.8° ± 6.1°, respectively, about the Transepicondylar axis (TEA). Although no gender-related differences were found for the TAL, they were found for the FAT. The variance of the TAL with respect to the TEA was significantly smaller compared with that for the FAT and thus exhibited a more consistent distribution. In addition, such a trend was found for both genders. CONCLUSIONS: The results show that the TAL is a favorable index for appropriate rotational alignment of the femoral component in TKA.

Effects of the material properties of a focal knee articular prosthetic on the human knee joint using computational simulation.

BACKGROUND: Localized cartilage defects are related to joint pain and reduced function to the development of osteoarthritis. The mechanical properties of the implant for treatment do influence its longevity. Therefore, we aimed to evaluate the effect of material properties' variations of anatomically shaped focal knee implants in the knee joint using numerical finite element analysis. METHODS: Computational simulations were performed for different cases including an intact knee, a knee with a focal cartilage defect, and a knee fitted with a focal articular prosthetic having three distinct mechanical properties: cobalt-chromium, pyrolytic carbon, and polyethylene. Femoral cartilage, tibial cartilage, and menisci contact pressures were evaluated under the load. In addition, bone stress was evaluated to investigate the stress shielding effect. RESULTS: Compared with the intact model, the contact stress of the focal implant model was increased; on the femoral lateral cartilage by 14%, on medial and lateral tibial cartilages by nine percent and 10%, on medial and lateral menisci by 23% and 20%. In contrast, the focal implant model had no effect on the menisci but contact stress on the tibial cartilage increased compared with the intact model. The BioPoly model showed the lowest contact stress on femoral and tibial cartilages. Additionally, the cobalt-chromium model showed the lowest bone stress that improved the load-sharing effect. CONCLUSIONS: The results suggested that implant material properties are an important parameter in the design of a focal implant. The polyethylene model potentially restored the intact knee contact mechanics and it reduced the risk of physiological damage to the articular cartilage.

[High risk groups in health behavior defined by clustering of smoking, alcohol, and exercise habits: National Heath and Nutrition Examination Survey].

OBJECTIVES: We investigated the clustering of selected lifestyle factors (cigarette smoking, heavy alcohol consumption, lack of physical exercise) and identified the population characteristics associated with increasing lifestyle risks. METHODS: Data on lifestyle risk factors, sociodemographic characteristics, and history of chronic diseases were obtained from 7,694 individuals >/=20 years of age who participated in the 2005 Korea National Health and Nutrition Examination Survey (KNHANES). Clustering of lifestyle risks involved the observed prevalence of multiple risks and those expected from marginal exposure prevalence of the three selected risk factors. Prevalence odds ratio was adopted as a measurement of clustering. Multiple correspondence analysis, Kendall tau correlation, Man-Whitney analysis, and ordinal logistic regression analysis were conducted to identify variables increasing lifestyle risks. RESULTS: In both men and women, increased lifestyle risks were associated with clustering of: (1) cigarette smoking and excessive alcohol consumption, and (2) smoking, excessive alcohol consumption, and lack of physical exercise. Patterns of clustering for physical exercise were different from those for cigarette smoking and alcohol consumption. The increased unhealthy clustering was found among men 20-64 years of age with mild or moderate stress, and among women 35-49 years of age who were never-married, with mild stress, and increased body mass index (>30 kg/m(2)). CONCLUSIONS: Addressing a lack of physical exercise considering individual characteristics including gender, age, employment activity, and stress levels should be a focus of health promotion efforts.

[Assessment of applicability of standardized rates for health state comparison among areas: 2008 Community Health Survey].

OBJECTIVES: This study shows the issues that should be considered when applying standardized rates using Community Health Survey(CHS) data. METHODS: We analyzed 2008 CHS data. In order to obtain the reliability of standardized rates, we calculated z-score and rank correlation coefficients between direct standardized rate and indirect standardized rate for 31 major indices. Especially, we assessed the change of correlations according to population composition (age and sex), and characteristics of the index. We used Mantel-Haenszel chi-square to quantify the difference of population composition. RESULTS: Among 31 major indices, 29 indices' z-score and rank correlation coefficients were over 0.9. However, regions with larger differences in population composition showed lower reliability. Low reliability was also observed for the indices specific to subgroups with small denominator such as 'permanent lesion from stroke', and the index with large regional variations in age-related differences such as 'obtaining health examinations'. CONCLUSIONS: Standardized rates may have low reliability, if comparison is made between areas with extremely large differences in population composition, or for indicies with large regional variations in age-related differences. Therefore, the special features of standardized rates should be considered when health state are compared among areas.