Electrical contact tunable direct printing route for a ZnO nanowire Schottky diode.

Although writing was the first human process for communication, it may now become the main process in the electronics industry, because in the industry the programmability as an inherent property is a necessary requirement for next-generation electronics. As an effort to open the era of writing electronics, here we show the feasibility of the direct printing of a high-performance inorganic single crystalline semiconductor nanowire (NW) Schottky diode (SD), including Schottky and Ohmic contacts in series, using premetallization and wrapping with metallic nanofoil. To verify the feasibility of our process, SDs made of Al-premetalized ZnO NWs and plain ZnO NWs were compared with each other. Even with cold direct printing, the Al-premetalized ZnO NW SD showed higher performance, specifically 1.52 in the ideality factor and 1.58 x 10(5) in its rectification ratio.

One-dimensional semiconductor nanostructure based thin-film partial composite formed by transfer implantation for high-performance flexible and printable electronics at low temperature.

Having high bending stability and effective gate coupling, the one-dimensional semiconductor nanostructures (ODSNs)-based thin-film partial composite was demonstrated, and its feasibility was confirmed through fabricating the Si NW thin-film partial composite on the poly(4-vinylphenol) (PVP) layer, obtaining uniform and high-performance flexible field-effect transistors (FETs). With the thin-film partial composite optimized by controlling the key steps consisting of the two-dimensional random dispersion on the hydrophilic substrate of ODSNs and the pressure-induced transfer implantation of them into the uncured thin dielectric polymer layer, the multinanowire (NW) FET devices were simply fabricated. As the NW density increases, the on-current of NW FETs increases linearly, implying that uniform NW distribution can be obtained with random directions over the entire region of the substrate despite the simplicity of the drop-casting method. The implantation of NWs by mechanical transfer printing onto the PVP layer enhanced the gate coupling and bending stability. As a result, the enhancements of the field-effect mobility and subthreshold swing and the stable device operation up to a 2.5 mm radius bending situation were achieved without an additional top passivation.

Direct electrical junction formation of highly vertical aligned zinc oxide nanorods.

A two dimensionally assembled monolayer of hexagonal convexo-convex ß-cobalt hydroxide nanoplates as a self-disposable sacrificial epi-template leads to a highly vertical alignment of zinc oxide nanorods array having a good electrical contact with metal or semiconductor layer on a substrate in a hydrothermal process.