High Thermal Stability and Low Thermal Resistance of Large Area GaN/3C-SiC/Diamond Junctions for Practical Device Processes.

Thermal management is critical in contemporary electronic systems, and integrating diamond with semiconductors offers the most promising solution to improve heat dissipation. However, developing a technique that can fully exploit the high thermal conductivity of diamond, withstand high-temperature annealing processes, and enable mass production is a significant challenge. In this study, the successful transfer of AlGaN/GaN/3C-SiC layers grown on Si to a large-size diamond substrate is demonstrated, followed by the fabrication of GaN high electron mobility transistors (HEMTs) on the diamond. Notably, no exfoliation of 3C-SiC/diamond bonding interfaces is observed even after annealing at 1100 °C, which is essential for high-quality GaN crystal growth on the diamond. The thermal boundary conductance of the 3C-SiC-diamond interface reaches ≈55 MW m-2 K-1, which is efficient for device cooling. GaN HEMTs fabricated on the diamond substrate exhibit the highest maximum drain current and the lowest surface temperature compared to those on Si and SiC substrates. Furthermore, the device thermal resistance of GaN HEMTs on the diamond substrate is significantly reduced compared to those on SiC substrates. These results indicate that the GaN/3C-SiC on diamond technique has the potential to revolutionize the development of power and radio-frequency electronics with improved thermal management capabilities.

Comparative evaluation of calcium-sensitizing agents, pimobendan and SCH00013, on the myocardial function of canine pacing-induced model of heart failure.

Pimobendan and SCH00013 are calcium sensitizers that possess dual action of calcium sensitization and phosphodiesterase-III inhibition. This study was conducted to comparatively evaluate the effect of these medications on the myocardial function of the canine pacing-induced heart failure model using echocardiography. Heart failure was induced in 20 dogs, to which pimobendan and two different doses of SCH00013 were administered orally to 15 dogs for 3 weeks, and the remaining 5 dogs served as the control. Cardiac evaluations were performed at baseline, week 1, week 2, and week 3. Significant thinning and dilation of the left ventricles, with systolic dysfunction, indicated by reduction of fractional shortening (FS) and strain values, were observed with a low dose of SCH00013. Whereas, although systolic dysfunction was observed with reduction of FS and radial strain, significant dilation and thinning of the left ventricles and reduction of circumferential strain were not observed with pimobendan. Pimobendan had a potent positive inotropic effect, with little effect on synchronicity, while low-dose SCH00013 had a weaker positive inotropic effect but was able to sustain synchronicity. Although, it failed to show significant statistical differences, the results of this study allow speculations that administration of pimobendan and SCH00013 may have differing effect on the myocardial function in the canine pacinginduced heart failure model.

Tetraarylphosphonium salt-catalyzed formal [3+2] cycloaddition between epoxides and trichloroacetonitrile for the synthesis of ß-amino alcohol derivatives.

Efficient regioselective synthesis of ß-amino alcohol derivatives, including enantioenriched ones, by a tetraarylphosphonium salt-catalyzed coupling reaction of epoxides with trichloroacetonitrile is described. Formal [3+2] cycloaddition, followed by hydrolysis, proceeded smoothly to afford N-protected ß-amino alcohols in good yields.

High thermal conductivity in wafer-scale cubic silicon carbide crystals.

High thermal conductivity electronic materials are critical components for high-performance electronic and photonic devices as both active functional materials and thermal management materials. We report an isotropic high thermal conductivity exceeding 500 W m-1K-1 at room temperature in high-quality wafer-scale cubic silicon carbide (3C-SiC) crystals, which is the second highest among large crystals (only surpassed by diamond). Furthermore, the corresponding 3C-SiC thin films are found to have record-high in-plane and cross-plane thermal conductivity, even higher than diamond thin films with equivalent thicknesses. Our results resolve a long-standing puzzle that the literature values of thermal conductivity for 3C-SiC are lower than the structurally more complex 6H-SiC. We show that the observed high thermal conductivity in this work arises from the high purity and high crystal quality of 3C-SiC crystals which avoids the exceptionally strong defect-phonon scatterings. Moreover, 3C-SiC is a SiC polytype which can be epitaxially grown on Si. We show that the measured 3C-SiC-Si thermal boundary conductance is among the highest for semiconductor interfaces. These findings provide insights for fundamental phonon transport mechanisms, and suggest that 3C-SiC is an excellent wide-bandgap semiconductor for applications of next-generation power electronics as both active components and substrates.

Evaluation of changes in left ventricular myocardial function observed in canine myocardial dysfunction model using a two-dimensional tissue tracking technique.

This study was conducted to assess the ability of two-dimensional tissue tracking (2DTT) to evaluate changes in left ventricular (LV) myocardial function associated with sustained high electrical pacing. Pacemakers were implanted at the right ventricular (RV) apex of five female Beagles, and sustained high electrical pacing of 250 beats per minute (bpm) was performed for three consecutive weeks. Conventional echocardiography and 2DTT were performed at baseline, and at every week for three weeks with pacing. The baseline parameters were then compared to those of weeks 1, 2, and 3. Three weeks of pacing resulted in significant reduction of radial and circumferential global strains (p < 0.001). Regional analysis revealed reduction of segmental strains in both radial and circumferential directions, as well as increased dyssynchrony after three weeks of pacing in the radial direction (p = 0.0007). The results of this study revealed the ability of 2DTT to measure radial and circumferential strains in dogs with sustained high-electrical pacing, and allowed assessment of global and regional myocardial function and the degree of dyssynchrony.