RESUMO
The work of adhesion is an interfacial materials property that is often extracted from atomic force microscope (AFM) measurements of the pull-off force for tips in contact with flat substrates. Such measurements rely on the use of continuum contact mechanics models, which ignore the atomic structure and contain other assumptions that can be challenging to justify from experiments alone. In this work, molecular dynamics is used to examine work of adhesion values obtained from simulations that mimic such AFM experiments and to examine variables that influence the calculated work of adhesion. Ultrastrong carbon-based materials, which are relevant to high-performance AFM and nano- and micromanufacturing applications, are considered. The three tips used in the simulations were composed of amorphous carbon terminated with hydrogen (a-C-H), and ultrananocrystalline diamond with and without hydrogen (UNCD-H and UNCD, respectively). The model substrate materials used were amorphous carbon with hydrogen termination (a-C-H) and without hydrogen (a-C); ultrananocrystalline diamond with (UNCD-H) and without hydrogen (UNCD); and the (111) face of single crystal diamond with (C(111)-H) and without a monolayer of hydrogen (C(111)). The a-C-H tip was found to have the lowest work of adhesion on all substrates examined, followed by the UNCD-H and then the UNCD tips. This trend is attributable to a combination of roughness on both the tip and sample, the degree of alignment of tip and substrate atoms, and the surface termination. Continuum estimates of the pull-off forces were approximately 2-5 times larger than the MD value for all but one tip-sample pair.
RESUMO
In this study, we explore the wear behavior of amplitude modulation atomic force microscopy (AM-AFM, an intermittent-contact AFM mode) tips coated with a common type of diamond-like carbon, amorphous hydrogenated carbon (a-C:H), when scanned against an ultra-nanocrystalline diamond (UNCD) sample both experimentally and through molecular dynamics (MD) simulations. Finite element analysis is utilized in a unique way to create a representative geometry of the tip to be simulated in MD. To conduct consistent and quantitative experiments, we apply a protocol that involves determining the tip-sample interaction geometry, calculating the tip-sample force and normal contact stress over the course of the wear test, and precisely quantifying the wear volume using high-resolution transmission electron microscopy imaging. The results reveal gradual wear of a-C:H with no sign of fracture or plastic deformation. The wear rate of a-C:H is consistent with a reaction-rate-based wear theory, which predicts an exponential dependence of the rate of atom removal on the average normal contact stress. From this, kinetic parameters governing the wear process are estimated. MD simulations of an a-C:H tip, whose radius is comparable to the tip radii used in experiments, making contact with a UNCD sample multiple times exhibit an atomic-level removal process. The atomistic wear events observed in the simulations are correlated with under-coordinated atomic species at the contacting surfaces.