A stepwise, 'test-all-positives' methodology to assess gluten-kernel contamination at the serving-size level in gluten-free (GF) oat production.

A step-wise, 'test-all-positive-gluten' analytical methodology has been developed and verified to assess kernel-based gluten contamination (i.e., wheat, barley and rye kernels) during gluten-free (GF) oat production. It targets GF claim compliance at the serving-size level (of a pouch or approximately 40-50g). Oat groats are collected from GF oat production following a robust attribute-based sampling plan then split into 75-g subsamples, and ground. R-Biopharm R5 sandwich ELISA R7001 is used for analysis of all the first15-g portions of the ground sample. A >20-ppm result disqualifies the production lot, while a >5 to <20-ppm result triggers complete analysis of the remaining 60-g of ground sample, analyzed in 15-g portions. If all five 15-g test results are <20ppm, and their average is <10.67ppm (since a 20-ppm contaminant in 40g of oats would dilute to 10.67ppm in 75-g), the lot is passed.

In vitro assessment of oat ß-glucans nutritional properties: An inter-laboratory methodology evaluation.

The purpose of this inter-laboratory study was to test the repeatability and reproducibility of an in vitro method aimed at analyzing the physicochemical properties under physiological conditions of ß-glucans from foods. After evaluating ß-glucans molar mass and quantification methods using five ß-glucan controls, four laboratories ran six oat-based products through in vitro digestion, measured ß-glucans solubility and viscosity and molar mass of solubilized ß-glucans. The determination of the molar mass of ß-glucan controls, their viscosity in solution and ß-glucans content in food samples exhibited relative standard reproducibility of 20.9-40.9%, 10.2-40.9% and 2.3-14.8%, respectively. After in vitro digestion, relative standard reproducibility ranged 12.1-60.0%, 12.2-64.3% and 9.7-36.3% for molar mass of extracted ß-glucans, their viscosity and their solubility, respectively. Although the characterization methods were satisfactory within the limits of current technology, the in vitro extraction contributed significantly to the uncertainty of final characterization.

Toward a more standardised and accurate evaluation of glycemic response to foods: recommendations for portion size calculation.

This study aimed at evaluating the adequacy of calculation methods for portions to be provided to subjects in clinical trials evaluating glycemic response to foods. Portion sizes were calculated for 140 food samples, based on Nutrition Facts labels (current practice) and actual available carbohydrate content (current recommendation), and compared against the amount of monosaccharides yielded by the digestive breakdown of their actual available carbohydrate content (basis for glycemic response to food). The current practice can result in significant under- or over-feeding of carbohydrates in 10% of tested cases, as compared to the targeted reference dosage. The method currently recommended can result in significantly inadequate yields of monosaccharides in 24% of tested cases. The current and recommended calculation methods do not seem adequate for a standardised evaluation of glycemic response to foods. It is thus recommended to account for the amount of absorbable monosaccharides of foods for portion size calculation.