RESUMO
Wastewater treatment plants (WWTPs) are one of the largest sources of greenhouse gas (GHG) emissions, and they are also one of the largest energy consumption industries in urban systems. With the progression of upgrading and standard-rising, WWTPs both directly and indirectly increase carbon emissions from the increased investments in facilities and usages in electricity as well as chemical agents. Here, we collected operational data from 15 WWTPs in the key control areas of the Ziya River Basin in North China and accounted for the changes in carbon performance at different technical upgrade methods. Results showed that the average carbon emission performance increased by 0.487 kg CO2/m3 after the upgrade. Carbon emissions from electricity consumption, chemical usage, biochemical process and sludge treatment accounted for 42%, 17%, 24%, and 17% of the total improvement in carbon emission performance, respectively. Reducing energy consumption, regulating chemical use and sludge comprehensive utilization are the key to carbon emission reduction. It further proposes that the development of wastewater treatment discharge standards should fully consider the comprehensive utilization of water quality classification. Regions with favorable natural conditions should make full use of their advantages by adopting economically feasible, low-energy-consuming technologies such as constructed wetlands, which offer carbon sequestration and landscaping benefits. This study provides guidance on the selection of technological pathways for pollution reduction and carbon mitigation in the wastewater treatment industry and on achieving sustainable water resource utilization.
Assuntos
Carbono , Rios , Águas Residuárias , China , Rios/química , Águas Residuárias/química , Carbono/análise , Eliminação de Resíduos Líquidos/métodos , Gases de Efeito Estufa/análise , Purificação da Água/métodosRESUMO
The development of non-cytotoxic hydrogels that can allow for the controlled release of molecules has important clinical and therapeutic applications. In this paper, we developed a series of in situ hydrogels by combining N,O-carboxymethyl chitosan and oxidized alginate without additional crosslinking agents. The rheological properties of these hydrogels as well as their gelling time, swelling ratio, and in vitro degradation behavior were investigated. We observed that although gelation was rapid at physiological temperature, it was even faster in the presence of higher oxidization degree of alginate. In vitro cytotoxicity study showed that the developed hydrogels were not cytotoxic after 24 h of culturing with NIH-3T3 cells. Additionally, bovine serum albumin was released from the hydrogels initially by diffusion at early stages followed by a degradation-dependent mechanism at later stages. In conclusion, the developed hydrogel might have potential application in the drug delivery system and tissue engineering.
Assuntos
Reagentes de Ligações Cruzadas/química , Sistemas de Liberação de Medicamentos , Hidrogéis/química , Polissacarídeos/química , Engenharia Tecidual/métodos , Alginatos/química , Animais , Bovinos , Quitosana/química , Difusão , Ácido Glucurônico/química , Ácidos Hexurônicos/química , Camundongos , Microscopia Eletrônica de Varredura/métodos , Células NIH 3T3 , Soroalbumina Bovina/química , Temperatura , Sais de Tetrazólio/farmacologia , Tiazóis/farmacologia , Fatores de TempoRESUMO
A biodegradable sponge, composed of chitosan (CS) and sodium alginate (SA), was successfully obtained in this work. The sponge was ethereal and pliable. The chemical structure and morphology of the sponges was characterized by FTIR and SEM. The swelling ability, in vitro drug release and degradation behaviors, and an in vivo animal test were employed to confirm the applicability of this sponge as a wound dressing material. As the chitosan content in the sponge decreased, the swelling ability decreased. All types of the sponges exhibited biodegradable properties. The release of curcumin from the sponges could be controlled by the crosslinking degree. Curcumin could be released from the sponges in an extended period for up to 20 days. An in vivo animal test using SD rat showed that sponge had better effect than cotton gauze, and adding curcumin into the sponge enhanced the therapeutic healing effect.
Assuntos
Alginatos/farmacologia , Quitosana/farmacologia , Curcumina/administração & dosagem , Curcumina/farmacologia , Derme/efeitos dos fármacos , Sistemas de Liberação de Medicamentos/métodos , Cicatrização/efeitos dos fármacos , Animais , Colágeno/metabolismo , Derme/patologia , Ácido Glucurônico/farmacologia , Ácidos Hexurônicos/farmacologia , Microscopia Eletrônica de Varredura , Muramidase/metabolismo , Poríferos , Ratos , Ratos Sprague-Dawley , Soluções , Espectroscopia de Infravermelho com Transformada de Fourier , Coloração e Rotulagem , Fatores de Tempo , Água/químicaRESUMO
BACKGROUND: Absorption of antigens onto chitosan microparticles via electrostatic interaction is a common and relatively mild process suitable for mucosal vaccine. In order to increase the stability of antigens and prevent an immediate desorption of antigens from chitosan carriers in gastrointestinal tract, coating onto BSA loaded chitosan microparticles with sodium alginate was performed by layer-by-layer technology to meet the requirement of mucosal vaccine. RESULTS: The prepared alginate coated BSA loaded chitosan microparticles had loading efficiency (LE) of 60% and loading capacity (LC) of 6% with mean diameter of about 1 mum. When the weight ratio of alginate/chitosan microparticles was greater than 2, the stable system could be obtained. The rapid charge inversion of BSA loaded chitosan microparticles (from +27 mv to -27.8 mv) was observed during the coating procedure which indicated the presence of alginate layer on the chitosan microparticles surfaces. According to the results obtained by scanning electron microscopy (SEM), the core-shell structure of BSA loaded chitosan microparticles was observed. Meanwhile, in vitro release study indicated that the initial burst release of BSA from alginate coated chitosan microparticles was lower than that observed from uncoated chitosan microparticles (40% in 8 h vs. about 84% in 0.5 h). SDS-polyacrylamide gel electrophoresis (SDS-PAGE) assay showed that alginate coating onto chitosan microparticles could effectively protect the BSA from degradation or hydrolysis in acidic condition for at least 2 h. The structural integrity of alginate modified chitosan microparticles incubated in PBS for 24 h was investigated by FTIR. CONCLUSION: The prepared alginate coated chitosan microparticles, with mean diameter of about 1 mum, was suitable for oral mucosal vaccine. Moreover, alginate coating onto the surface of chitosan microparticles could modulate the release behavior of BSA from alginate coated chitosan microparticles and could effectively protect model protein (BSA) from degradation in acidic medium in vitro for at least 2 h. In all, the prepared alginate coated chitosan microparticles might be an effective vehicle for oral administration of antigens.
Assuntos
Alginatos/química , Quitosana/química , Sistemas de Liberação de Medicamentos/métodos , Nanopartículas/química , Vacinas/administração & dosagem , Animais , Bovinos , Eletroforese em Gel de Poliacrilamida , Ácido Glucurônico/química , Ácidos Hexurônicos/química , Nanopartículas/ultraestrutura , Tamanho da Partícula , Processamento de Proteína Pós-Traducional , Soroalbumina Bovina , Espectroscopia de Infravermelho com Transformada de FourierRESUMO
Regioselective enzymatic acylation of proanthocyanidin is proposed and investigated as a method by which to improve the solubility of proanthocyanidins in the oil phase and maintain its oxidation resistance. Experimental results indicate that butanol functions as the best solvent in the studied reaction, in which Lipase Novozym435 is used as biological catalyst enzyme and the molar ratio of lauric acid to proanthocyanidins is 4:1. To increase the esterification conversion, we propose the addition of molecular sieve at 5 h. The product was separated by TLC, and results indicate an optimal solvent ratio of ethyl acetate: petroleum ether: acetic acid = 2:3:0.5. This condition can effectively separate the ester and proanthocyanidins, achieving an esterification yield of 60.9%.
Assuntos
Proantocianidinas/química , Ácido Acético/química , Alcanos/química , Butanóis/química , Enzimas Imobilizadas/metabolismo , Esterificação , Concentração de Íons de Hidrogênio , Ácidos Láuricos/química , Lipase/metabolismo , Solubilidade , Solventes/químicaRESUMO
In this paper, covalently cross-linked hydrogel composed of N,O-carboxymethyl chitosan and oxidized alginate was developed intending for drug delivery application. In vitro/vivo cytocompatibility and biocompatibility of the developed hydrogel were preliminary evaluated. In vitro cytocompatibility test showed that the developed hydrogel exhibited good cytocompatibility against NH3T3 cells after 3-day incubation. According to the results of acute toxicity test, there was no obvious cytotoxicity for major organs during the period of 21-day intraperitoneal administration. Meanwhile, the developed hydrogel did not induce any cutaneous reaction within 72 h of subcutaneous injection followed by slow degradation and adsorption with the time evolution. Moreover, the extraction of developed hydrogel had nearly 0% of hemolysis ratio, which indicated the good hemocompatibility of hydrogel. Based on the above results, it may be concluded that the developed N,O-carboxymethyl chitosan/oxidized alginate hydrogel with non-cytotoxicity and good biocompatibility might suitable for the various drug delivery applications.
Assuntos
Alginatos/química , Quitosana/química , Sistemas de Liberação de Medicamentos , Hidrogel de Polietilenoglicol-Dimetacrilato/química , Hidrogel de Polietilenoglicol-Dimetacrilato/toxicidade , Animais , Materiais Biocompatíveis/administração & dosagem , Materiais Biocompatíveis/química , Materiais Biocompatíveis/toxicidade , Feminino , Hemólise/efeitos dos fármacos , Hidrogel de Polietilenoglicol-Dimetacrilato/administração & dosagem , Masculino , Camundongos , Camundongos Endogâmicos BALB C , Células NIH 3T3 , Coelhos , Testes de Irritação da PeleRESUMO
In attempt to overcome the problem of low water solubility and severe toxicity of camptothecin (CPT) after intravenous administration, a novel drug carrier system based on chitosan (CS) and dibasic sodium phosphate (DSP) has been developed in this paper to encapsulate CPT intending for local administration. Nanocolloids of CPT with size about 500 nm were first prepared, followed by encapsulation in the chitosan/dibasic sodium phosphate (CS/DSP) formulation. The formulation was sol state below 37°C and transformed to nonflowing gel state at 37°C. Encapsulation of CPT nanocolloids had greatly effect on the gelling time as well as the micro-structure of hydrogel. In vitro and in vivo degradation studies revealed that the developed CS/DSP hydrogel was biodegradable and biocompatible. In vitro release study revealed that CPT released from CS/DSP hydrogel in an extended period with about 70% of total CPT released from hydrogel after 18 days. Furthermore, nearly 90% of CPT in the chitosan hydrogels could be preserved in the lactone form (active form) even after 7 days's storage at 37°C. Furthermore, in vitro cytotoxicity of CPT nanocolloids on SKOV3 human ovarian cancer cells suggested the well anti-tumor cell efficiency could be gained at a lower concentration.
Assuntos
Antineoplásicos Fitogênicos/administração & dosagem , Camptotecina/administração & dosagem , Quitosana/química , Portadores de Fármacos/administração & dosagem , Sistemas de Liberação de Medicamentos/métodos , Nanoestruturas/química , Fosfatos/química , Animais , Antineoplásicos Fitogênicos/farmacologia , Camptotecina/farmacologia , Linhagem Celular Tumoral , Fenômenos Químicos , Química Farmacêutica , Quitosana/toxicidade , Coloides , Preparações de Ação Retardada/administração & dosagem , Preparações de Ação Retardada/farmacologia , Portadores de Fármacos/farmacologia , Estabilidade de Medicamentos , Feminino , Humanos , Hidrogéis , Cinética , Camundongos , Camundongos Endogâmicos BALB C , Nanoestruturas/toxicidade , Nanoestruturas/ultraestrutura , Neoplasias Ovarianas/tratamento farmacológico , Fosfatos/toxicidadeRESUMO
In present study, the feasibility of developing a novel thermo-sensitive hydrogel suitable for injectable formulations based on chitosan and inorganic phosphate was demonstrated. The physicochemical and rheological changes of chitosan/dibasic sodium phosphate solutions as in function with temperature were investigated in order to gain a better understanding of gelation process. According to the result of rheological study, there are two phase transition points as in function with temperature, corresponding to 30 degrees C and 43 degrees C. The system is gel state at approximately 4 degrees C. With the temperature increased to 30 degrees C, the gel-sol transition as well as the decrease in turbidity was observed. The sol-gel transition as well as the increase in turbidity was observed again as the temperature was above 43 degrees C. And the gel obtained at approximately 4 degrees C is reversible, but the gel obtained at approximately 43 degrees C is irreversible.
Assuntos
Quitosana/química , Hidrogéis , Fosfatos/química , Concentração de Íons de Hidrogênio , Nefelometria e Turbidimetria , Concentração Osmolar , Reologia , Soluções , TemperaturaRESUMO
It has been demonstrated that spray-drying is a powerful method to prepare dry powders for pulmonary delivery. This paper prepared dispersible dry powders based on chitosan and mannitol containing honokiol nanoparticles as model drug. The results showed that the prepared microparticles are almost spherical and have appropriate aerodynamic properties for pulmonary delivery (aerodynamic diameters was between 2.8-3.3 microm and tapped density ranging from 0.14-0. 18 g/cm(3)). Moreover, surface morphology and aerodynamic properties of the powders were strongly affected by the content of mannitol. Fourier transform infra-red (FTIR) spectrum of powders indicated that the honokiol nanoparticles were successfully incorporated into microparticles. In vitro drug release profile was also observed. The content of mannitol in powders significantly influenced the release rate of honokiol from matrices.