Evaluation of fluorous affinity using fluoroalkyl-modified silica gel and selective separation of poly-fluoroalkyl substances in organic solvents.

In this study, we focused on the fluorous affinity acting among fluorine compounds, and then developed a new separation medium and evaluated their performance. We prepared the stationary phases for a column using silica gel-modified alkyl fluoride and investigated the characteristics of fluorous affinity by comparing them with a typical stationary phase, which does not contain fluorine, using high-performance liquid chromatography (HPLC). In HPLC measurements, we confirmed that while all non-fluorine compounds were not retained, retention of fluorine compounds increased as the number of fluorine increased with the stationary phase. It also revealed that the strength of fluorous affinity changes depending on the types of the organic solvent; the more polar the solvent, the stronger the effect. Additionally, the stationary phase was employed to compare the efficiency of our column with that of a commercially available column, Fluofix-II. The retention selectivity was almost the same, but the absolute retention strength was slightly higher on our column, indicating that the column is available for practical use.

Enhanced molecular recognition with longer chain crosslinkers in molecularly imprinted polymers for an efficient separation of TR active substances.

Molecular imprinting technology has been widely studied as a technique to obtain molecular recognition by artificial means. Selecting functional monomers or polymerization conditions plays a key role to optimize molecularly imprinted polymer (MIP) synthesis. To date, there have been few reports well exploiting the effect of crosslinkers. Here, in this study, we synthesized the MIPs using poly(ethyleneglycol) dimethacrylate with different units of ethylene oxide (n = 1 to 23) as crosslinkers to observe the molecular recognition abilities. The MIPs were attached to the surface of mono-dispersed polymer beads. The obtained spherical MIPs and non-imprinted polymers were filled in a column for high performance liquid chromatography. Then the retention selectivity toward TR active substances was evaluated. The result revealed that the recognition ability did not improve regardless of the amount of ethylene oxide. With the crosslinker (n = 9), extremely high retention selectivity was observed, which provides at most around ten times as large imprinting factors in comparison with other MIPs. Interestingly, we obtained the highest recognition ability at around polymerization temperature from the evaluation of the recognition ability toward temperature shift using the MIP (n = 9). In general, hydrogen bonding based on MIPs provides high recognition ability at low temperature, whereas, this study indicates that the use of flexible crosslinkers may enable the synthesis of MIPs that precisely memorize the conditions of polymerization. Lastly, we simultaneously analyzed the TR active substances using the column filled with MIPs (n = 9). The result showed relatively linear correlation between the retention strength of each substance and phycological activity toward TR obtained by yeast assay. Therefore, we can conclude that an induced fit like the receptor emerged by constructing the flexible molecular recognition field.