RESUMO
The helmet plays an important role in protection of pilot's head and enhances the pilot's capabilities and performance significantly with the use of mounted devices such as the Night Vision Goggle (NVG). However, the use of helmet-mounted devices might increase the risk of injury due to the increased helmet weight and change in the centre of gravity of head. In this study, four helmets with different combinations of mounted devices were modelled in a validated human head-neck multi-body model to analyse their effects on the pilot's neck injury during simulated ejection. The probability of neck injury was evaluated and predicted using the Nij neck injury criteria and human injury risk curves, considering the tolerance of injury for upper and lower cervical segment. It was demonstrated that the helmet-mounted devices would increase the compression force and bending moment on cervical spine, especially for the lower cervical segments with higher Nij. In the cases with Night Vision Goggle, Nij of the lower cervical segment reached 0.54, which exceeded the requirement in aviation filed. For the cases with Visor, excessive extension occurred, resulting in a high Nij. The simulation results of this study could provide a reference for helmet and mounted devices design and offer a proposal for the protection of pilots during ejection.
Assuntos
Aviação , Lesões do Pescoço , Humanos , Dispositivos de Proteção da Cabeça , Lesões do Pescoço/prevenção & controle , Simulação por Computador , Vértebras CervicaisRESUMO
Irreversible electroporation (IRE) by high-strength electric pulses is a biomedical technique that has been effectively used for minimally invasive tumor therapy while maintaining the functionality of adjacent important tissues, such as blood vessels and nerves. In general, pulse delivery using needle electrodes can create a reversible electroporation region beyond both the ablation area and the vicinity of the needle electrodes, limiting enlargement of the ablation area. Electrochemical therapy (EChT) can also be used to ablate a tumor near electrodes by electrolysis using a direct field with a constant current or voltage (DC field). Recently, reversible electroporated cells have been shown to be susceptible to electrolysis at relatively low doses. Reversible electroporation can also be combined with electrolysis for tissue ablation. Therefore, the objective of this study is to use electrolysis to remove the reversible electroporation area and thereby enlarge the ablation area in potato slices in vitro using a pulsed field with a bias DC field (constant voltage). We call this protocol electrolytic irreversible electroporation (E-IRE). The area over which the electrolytic effect induced a pH change was also measured. The results show that decreasing the pulse frequency using IRE alone is found to enlarge the ablation area. The ablation area generated by E-IRE is significantly larger than that generated by using IRE or EChT alone. The ablation area generated by E-IRE at 1 Hz is 109.5% larger than that generated by IRE, showing that the reversible electroporation region is transformed into an ablation region by electrolysis. The area with a pH change produced by E-IRE is larger than that produced by EChT alone. Decreasing the pulse frequency in the E-IRE protocol can further enlarge the ablation area. The results of this study are a preliminary indication that the E-IRE protocol can effectively enlarge the ablation area and enhance the efficacy of traditional IRE for use in ablating large tumors.
Assuntos
Técnicas de Ablação , Eletroporação , Eletroporação/métodos , Eletrólise/métodos , Eletricidade , EletrodosRESUMO
In this study, a novel air-ring flow regulating valve was proposed to reduce the flow resistance caused by valve structural pressure drop in fluid transportation pipeline system. The regulating characteristics at different valve openings were analyzed by numerical method and the results were compared with the center butterfly valve which is most widely applied in fluid transportation pipeline system. Besides, an experimental system was designed to validate the numerical model in the present study. The results indicated that the simulation results agree well with experimental data. The resistance coefficient of the air-ring flow regulating valve is smaller than that of the center butterfly valve when the valve opening is greater than 67%, and the resistance coefficient is reduced by up to 100% as the valve is fully opened. Both valves maintain approximately equal percentage flow characteristics, the deviation in relative flow coefficient is small. In addition, the wall shear stress of the air-ring flow regulating valve is much smaller than that of the center butterfly valve at the same valve opening, and the maximum velocity in the pipeline system is always smaller than that of the center butterfly valve, which significantly reduces valve surface abrasive erosion and thus prolongs its service life.
Assuntos
Resistência à Flexão , Hidrodinâmica , Manufaturas , Modelos Teóricos , Aço , Estresse Mecânico , Simulação por Computador , Pressão HidrostáticaRESUMO
This study aimed to determine whether heart rate variability (HRV) can express the thermal comfort of mine workers. Eight subjects ran on a treadmill (5.5 km/h) to simulate heavy labor in three kinds of mining environments (22 °C/90%, 26 °C/90%, 30 °C/90%), respectively. Based on the measured electrocardiogram (ECG) data, the HRV of the subjects was calculated. The results showed that the HRV indices changed obviously under different temperature environments. In the neutral and hot environment, except for the LF, TP and LF/HF, there were significant differences in each index. However, there was no significant difference between the cold and neutral environments. The R-R intervals, the very low-frequency power (VLF), pNN20 and SampEN had strong negative correlation with the thermal sensation of people from sitting to work (ρ < -0.700). These indices may be used as thermal comfort predictive biomarkers of mine workers.
Assuntos
Mineradores , Biomarcadores , Eletrocardiografia , Frequência Cardíaca , Humanos , Sensação TérmicaRESUMO
Movable refuge chambers are a new kind of rescue device for underground mining, which is believed to have a potential positive impact on reducing the rate of fatalities. It is likely to be hot and humid inside a movable refuge chamber due to the metabolism of trapped miners, heat generated by equipment and heat transferred from outside. To investigate the heat stress experienced by miners trapped in a movable refuge chamber, the predicted heat strain (PHS) model was used to simulate the heat transfer process between the person and the thermal environment. The variations of heat stress with the temperature and humidity inside the refuge chamber were analyzed. The effects of air temperature outside the refuge chamber and the overall heat transfer coefficient of the refuge chamber shell on the heat stress inside the refuge chamber was also investigated. The relationship between the limit of exposure duration and the air temperature and humidity was numerically analyzed to determine the upper limits of temperature and humidity inside a refuge chamber. Air temperature of 32 °C and relative humidity of 70% are recommended as the design standard for internal thermal environment control of movable refuge chambers.
Assuntos
Ar Condicionado , Transtornos de Estresse por Calor/prevenção & controle , Temperatura Alta/efeitos adversos , Temperatura Corporal , Regulação da Temperatura Corporal , Ambiente Controlado , Humanos , Umidade , Mineração , Modelos Biológicos , Segurança , TemperaturaRESUMO
OBJECTIVE: To study the effects of wearing extravehicular activity (EVA) gloves on grip strength and fatigue in low temperature, low pressure and mixing of two factors (low temperature and low pressure). METHODS: The maximum grip strength and fatigue tests were performed with 10 healthy male subjects wearing gloves in a variety of simulated environments. The data was analysed using the normalization method. RESULTS: The results showed that wearing gloves significantly affected the maximum grip strength and fatigue. Pressure (29.6, 39.2 kPa) had more influence on the maximum grip compared with control group while low temperatures (-50, -90, -110 °C) had no influence on grip but affected fatigue dramatically. The results also showed that the maximum grip strength and fatigue were influenced significantly in a compound environment. CONCLUSIONS: Space environment remarkably reduced strength and endurance of the astronauts. However, the effects brought by the compound environment cannot be understood as the superimposition of low temperature and pressure effects.