RESUMO
The aim of this study was to investigate the effect of different types of natural cellulose-based fillers on the properties of Xanthan gum (XG) in order to develop novel bio-based soil conditioners (SCs) that could be used in forestry and agricultural applications. Rheological measurements highlighted that SCs with cellulose fillers characterized by a high aspect ratio and low oxide ash content exhibited an average increase of 21% in yield stress compared to neat Xanthan gum. The presence of cellulose fillers in the composites resulted in a slower water release than that of neat XG, limiting the volumetric shrinkage during the drying process. Furthermore, an analysis of the water absorption and water retention capacity of soils treated with the different SCs was carried out, demonstrating that the addition of 1.8 wt.% of SC with optimized composition to the soil led to an increase in water absorption capacity from 34% up to 69%. From the soil water retention curves, it was observed that the addition of SCs significantly increased the amount of water effectively available for plants in the area between field capacity and permanent wilting point (100-1000 kPa). From practical experiments on grass growth, it was observed that these SCs improved the water regulation of the soil, thus increasing the probability of plant survival under drought conditions.
RESUMO
During construction of the Sentvid tunnel a unique opportunity arose to measure the 3D displacements ahead of the motorway tunnel excavation face, since the exploratory tunnel was already constructed in the axis of the main tunnel. According to reviewed literature such measurements had not been performed yet and several problems regarding equipment and complete scheme of the experiment needed to be overcome. The paper gives a brief description of the Sentvid tunnel project, presents significant factors that affected the choice of the geodetic equipment and describes the scheme of the experiment. A special attention is focused on the problems relating to the operation of the instrument in demanding environmental conditions (water, dust).