Ultrafine, fine, and black carbon particle concentrations in California child-care facilities.

Although many U.S. children spend time in child care, little information exists on exposures to airborne particulate matter (PM) in this environment, even though PM may be associated with asthma and other respiratory illness, which is a key concern for young children. To address this data gap, we measured ultrafine particles (UFP), PM2.5 , PM10 , and black carbon in 40 California child-care facilities and examined associations with potential determinants. We also tested a low-cost optical particle measuring device (Dylos monitor). Median (interquartile range) concentrations for indoor UFP, gravimetric PM2.5 , real-time PM2.5 , gravimetric PM10 , and black carbon over the course of a child-care day were 14 000 (11 000-29 000) particles/cm3 , 15 (9.6-21) µg/m3 , 15 (11-23) µg/m3 , 48 (33-73) µg/m3 , and 0.43 (0.25-0.65) ng/m3 , respectively. Indoor black carbon concentrations were inversely associated with air exchange rate (Spearman's rho = -.36) and positively associated with the sum of all Gaussian-adjusted traffic volume within a one-kilometer radius (Spearman's rho = .45) (P-values <.05). Finally, the Dylos may be a valid low-cost alternative to monitor PM levels indoors in future studies. Overall, results indicate the need for additional studies examining particle levels, potential health risks, and mitigation strategies in child-care facilities.

Formaldehyde and acetaldehyde exposure and risk characterization in California early childhood education environments.

Little information is available about air quality in early childhood education (ECE) facilities. We collected single-day air samples in 2010-2011 from 40 ECE facilities serving children ≤6 years old in California and applied new methods to evaluate cancer risk in young children. Formaldehyde and acetaldehyde were detected in 100% of samples. The median (max) indoor formaldehyde and acetaldehyde levels (µg/m3 ) were 17.8 (48.8) and 7.5 (23.3), respectively, and were comparable to other California schools and homes. Formaldehyde and acetaldehyde concentrations were inversely associated with air exchange rates (Pearson r = -0.54 and -0.63, respectively; P < 0.001). The buildings and furnishings were generally >5 years old, suggesting other indoor sources. Formaldehyde levels exceeded California 8-h and chronic Reference Exposure Levels (both 9 µg/m3 ) for non-cancer effects in 87.5% of facilities. Acetaldehyde levels exceeded the U.S. EPA Reference Concentration in 30% of facilities. If reflective of long-term averages, estimated exposures would exceed age-adjusted 'safe harbor levels' based on California's Proposition 65 guidelines (10-5 lifetime cancer risk). Additional research is needed to identify sources of formaldehyde and acetaldehyde and strategies to reduce indoor air levels. The impact of recent California and proposed U.S. EPA regulations to reduce formaldehyde levels in future construction should be assessed.

VOC exposures in California early childhood education environments.

Little information exists about exposures to volatile organic compounds (VOCs) in early childhood education (ECE) environments. We measured 38 VOCs in single-day air samples collected in 2010-2011 from 34 ECE facilities serving California children and evaluated potential health risks. We also examined unknown peaks in the GC/MS chromatographs for indoor samples and identified 119 of these compounds using mass spectral libraries. VOCs found in cleaning and personal care products had the highest indoor concentrations (d-limonene and decamethylcyclopentasiloxane [D5] medians: 33.1 and 51.4 µg/m³, respectively). If reflective of long-term averages, child exposures to benzene, chloroform, ethylbenzene, and naphthalene exceeded age-adjusted "safe harbor levels" based on California's Proposition 65 guidelines (10-5 lifetime cancer risk) in 71%, 38%, 56%, and 97% of facilities, respectively. For VOCs without health benchmarks, we used information from toxicological databases and quantitative structure-activity relationship models to assess potential health concerns and identified 12 VOCs that warrant additional evaluation, including a number of terpenes and fragrance compounds. While VOC levels in ECE facilities resemble those in school and home environments, mitigation strategies are warranted to reduce exposures. More research is needed to identify sources and health risks of many VOCs and to support outreach to improve air quality in ECE facilities.

Restoring the femoral offset prevent early migration of the stem in total hip arthroplasty: an EBRA-FCA study.

The use of modular stems is still debated and controversial. Some authors have highlighted a number of disadvantages of modular prostheses including high costs, the tendency to fracture, the fretting and corrosion and the increased production of debris. Other authors have emphasized several advantages to adapt the prosthesis to the morphometric differences of patients, to allow better accuracy in restoring the anatomy and biomechanics of hip joint. The advantages of the modular devices appear to be more evident in patients with developmental dysplasia of the hip (DDH). In our study we compared 96 patients, operated for arthritis of the hip with 55 modular neck prostheses (PROFEMUR®, Wright® Arlington, Tennesse, USA) and 41 standard femoral stems (SYMAX®, Striker® Kalamazoo, Michigan, USA). The precision of restoring the natural offset during surgery was correlated with the clinical outcome and the radiological early migration of each stem measured using the computer-assisted EBRA-FCA method. The average preoperative HHS (Harris Hip Score) was 44 (23-66); the postoperative 86.56 in the 55 patients operated with modular prostheses and 81.70 in the 41 patients with monoblock stem. The worst HH Scores were seen in patients in whom the offset was not restored properly. On the contrary, the best scores have been reached in patients in which that value is closer to the “target” value (offset value of the contralateral hip). Restoring the proper offset seems to determine an appropriate tension of the abductor muscles of the hip and implies a better functioning of the joint and a better primary stability of the implant, with less early migration. This has to be a primary objective of THA surgery.

Effects of ventilation rate per person and per floor area on perceived air quality, sick building syndrome symptoms, and decision-making.

UNLABELLED: Ventilation rates (VRs) in buildings must adequately control indoor levels of pollutants; however, VRs are constrained by the energy costs. Experiments in a simulated office assessed the effects of VR per occupant on perceived air quality (PAQ), Sick Building Syndrome (SBS) symptoms, and decision-making performance. A parallel set of experiments assessed the effects of VR per unit floor area on the same outcomes. Sixteen blinded healthy young adult subjects participated in each study. Each exposure lasted four hours and each subject experienced two conditions in a within-subject study design. The order of presentation of test conditions, day of testing, and gender were balanced. Temperature, relative humidity, VRs, and concentrations of pollutants were monitored. Online surveys assessed PAQ and SBS symptoms and a validated computer-based tool measured decision-making performance. Neither changing the VR per person nor changing the VR per floor area, had consistent statistically significant effects on PAQ or SBS symptoms. However, reductions in either occupant-based VR or floor-area-based VR had a significant and independent negative impact on most decision-making measures. These results indicate that the changes in VR employed in the study influence performance of healthy young adults even when PAQ and SBS symptoms are unaffected. PRACTICAL IMPLICATIONS: The study results indicate the importance of avoiding low VRs per person and low VRs per floor area to minimize decrements in cognitive performance.

Impact of artificial accelerated ageing of PVC surfaces and surface degradation on disinfectant efficacy.

BACKGROUND: Standardized efficacy surface tests for disinfectants are performed on pristine surfaces. There is a growing interest in understanding the impact of surface ageing on disinfectant activity, owing for example to the increased usage of ultraviolet (UV) radiation and oxidative chemistries for surface decontamination. This acknowledges that general surface 'wear and tear' following UV radiation and oxidative biocide exposure may impact biocidal product efficacy. METHODS: PVC surfaces were aged through thermal and UV-A radiation (340 nm wavelength) following the use of standard ageing surface protocols to simulate natural surface degradation. Surface roughness, contact angle and scanning electron microscopy were performed to evaluate physical changes in PVC surfaces before and after artificial ageing. The efficacy of five pre-impregnated disinfectant wipes were evaluated using the ASTM E2967-15 on stainless-steel (control) and PVC surfaces (aged and non-aged). RESULTS: The type of formulation and the organism tested remained the most significant factors impacting disinfectant efficacy, compared with surface type. Both thermal ageing and UV-A exposure of PVC surfaces clearly showed signs of surface degradation, notably an increase in surface roughness. Physical changes were observed in the roughness of PVC after artificial ageing. A difference in disinfectant efficacy dependent on aged PVC surfaces was observed for some, but not all formulations. CONCLUSION: We showed that surface type and surface ageing can affect biocidal product efficacy, although in a non-predictable manner. More research is needed in this field to ascertain whether surface types and aged surfaces should be used in standardized efficacy testing.

Outburst of Jupiter's synchrotron radiation after the impact of comet Shoemaker-Levy 9.

Jupiter's nonthermal microwave emission, as measured by a global network of 11 radio telescopes, increased dramatically during the Shoemaker-Levy 9 impacts. The increase was wavelength-dependent, varying from approximately 10 percent at 70 to 90 centimeters to approximately 45 percent at 6 and 36 centimeters. The radio spectrum hardened (flattened toward shorter wavelengths) considerably during the week of impacts and continued to harden afterward. After the week of cometary impacts, the flux density began to subside at all wavelengths and was still declining 3 months later. Very Large Array and Australia Telescope images of the brightness distribution showed the enhancement to be localized in longitude and concentrated near the magnetic equator. The evidence therefore suggests that the increase in flux density was caused by a change in the resident particle population, for example, through an energization or spatial redistribution of the emitting particles.

Comparison of multi-media transport and transformation models: regional fugacity model vs. CalTOX.

Two multimedia environmental transport and transformation computer models are summarized and compared. The regional fugacity model published by Mackay and Paterson (1991), termed Fug3ONT, is a four compartment steady-state model designed to simulate the relative distribution of nonionic organic chemicals in a multimedia system. CalTOX is a seven compartment multimedia total exposure model for hazardous waste sites. Both models are based on the principles of fugacity. CalTOX, however, separates the soil into three layers (surface, root, and vadose) and uses a different approach to estimate the diffusive mass transfer rate in soil. These differences result in lower estimates of the steady-state contaminant concentrations of six environmentally relevant chemicals in the root soil of CalTOX as compared to the bulk soil of Fug3ONT. The difference is greatest for compounds with low mobility in soil such as 2,3,7,8-Tetrachlorodibenzo-p-dioxin and Benzo(a)pyrene where estimates from CalTOX and Fug3ONT differ by more than 3 orders of magnitude. Otherwise, the models provide similar estimates for the distribution of the six chemicals among the air, water, sediment and surface soil.

BETR North America: a regionally segmented multimedia contaminant fate model for North America.

We present the Berkeley-Trent North American contaminant fate model (BETR North America), a regionally segmented multimedia contaminant fate model based on the fugacity concept. The model is built on a framework that links contaminant fate models of individual regions, and is generally applicable to large, spatially heterogeneous areas. The North American environment is modeled as 24 ecological regions, within each region contaminant fate is described using a 7 compartment multimedia fugacity model including a vertically segmented atmosphere, freshwater, freshwater sediment, soil, coastal water and vegetation compartments. Inter-regional transport of contaminants in the atmosphere, freshwater and coastal water is described using a database of hydrological and meteorological data compiled with Geographical Information Systems (GIS) techniques. Steady-state and dynamic solutions to the 168 mass balance equations that make up the linked model for North America are discussed, and an illustrative case study of toxaphene transport from the southern United States to the Great Lakes Basin is presented. Regionally segmented models such as BETR North America can provide a critical link between evaluative models of long-range transport potential and contaminant concentrations observed in remote regions. The continent-scale mass balance calculated by the model provides a sound basis for evaluating long-range transport potential of organic pollutants, and formulation of continent-scale management and regulatory strategies for chemicals.

[A method for the fluorimetric determination of usnic acid in pharmaceutical preparations]. / Su un metodo di determinazione fluorimetrica dell'acido usnico nei preparati farmaceutici.

A new, rapid, sensitive and reproducible micromethod for the fluorometric determination of usnic acid in pharmaceutical formulations has been developed. The method makes use of the quenching of the fluorescence produced by usnic acid in the solution of anthranilic acid in TRIS. The possibility of extending the method to cosmetic finished products is demonstrated.