Degeneration of the Olfactory System in a Murid Rodent that Evolved Diurnalism.

In mammalian research, it has been debated what can initiate an evolutionary tradeoff between different senses, and the phenomenon of sensory tradeoff in rodents, the most abundant mammalian clade, is not evident. The Nile rat (Arvicanthis niloticus), a murid rodent, recently adapted to a diurnal niche through an evolutionary acquisition of daylight vision with enhanced visual acuity. As such, this model provides an opportunity for a cross-species investigation where comparative morphological and multi-omic analyses of the Nile rat are made with its closely related nocturnal species, e.g. the mouse (Mus musculus) and the rat (Rattus norvegicus). Thus, morphological examinations were performed, and evolutionary reductions in relative sizes of turbinal bone surfaces, the cribriform plate, and the olfactory bulb were discovered in Nile rats. Subsequently, we compared multiple murid genomes, and profiled olfactory epithelium transcriptomes of mice and Nile rats at various ages with RNA sequencing. The results further demonstrate that, in comparison with mouse olfactory receptor (OR) genes, Nile rat OR genes have experienced less frequent gain, more frequent loss, and more frequent expression reduction during their evolution. Furthermore, functional degeneration of coding sequences in the Nile rat lineage was found in OR genes, yet not in other genes. Taken together, these results suggest that acquisition of improved vision in the Nile rat has been accompanied by degeneration of both olfaction-related anatomical structures and OR gene repertoires, consistent with the hypothesis of an olfaction-vision tradeoff initiated by the switch from a nocturnal to a diurnal lifestyle in mammals.

Local Charge Transfer Unveils Antideactivation of Ru at High Potentials for the Alkaline Hydrogen Oxidation Reaction.

The activity of Ru-based alkaline hydrogen oxidation reaction (HOR) electrocatalysts usually decreases rapidly at potentials higher than 0.1 V (vs a reversible hydrogen electrode (RHE)), which significantly limits the lifetime of fuel cells. It is found that this phenomenon is caused by the overadsorption of the O species due to the overcharging of Ru nanoparticles at high potentials. Here, Mn1Ox(OH)y clusters-modified Ru nanoparticles (Mn1Ox(OH)y@Ru/C) were prepared to promote charge transfer from overcharged Ru nanoparticles to Mn1Ox(OH)y clusters. Mn1Ox(OH)y@Ru/C exhibits high HOR activity and stability over a wide potential range of 0-1.0 V. Moreover, a hydroxide exchange membrane fuel cell with a Mn1Ox(OH)y@Ru/C anode delivers a high peak power density of 1.731 W cm-2, much superior to that of a Pt/C anode. In situ X-ray absorption fine structure (XAFS) analysis and density functional theory (DFT) calculations reveal that Mn in Mn1Ox(OH)y clusters could receive more electrons from overcharged Ru at higher potentials and significantly decrease the overadsorption of the O species on Ru, thus permitting the HOR on Ru to proceed at high potentials. This study provides guidance for the design of alkaline HOR catalysts without activity decay at high potentials.

Ultralow-Loading Ruthenium-Iridium Fuel Cell Catalysts Dispersed on Zn-N Species-Doped Carbon.

Developing low-loading platinum-group-metal (PGM) catalysts is one of the key challenges in commercializing anion-exchange-membrane-fuel-cells (AEMFCs), especially for hydrogen oxidation reaction (HOR). Here, ruthenium-iridium nanoparticles being deposited on a Zn-N species-doped carbon carrier (Ru6Ir/Zn-N-C) are synthesized and used as an anodic catalyst for AEMFCs. Ru6Ir/Zn-N-C shows extremely high mass activity (5.87 A mgPGM -1) and exchange current density (0.92 mA cm-2), which is 15.1 and 3.9 times that of commercial Pt/C, respectively. Based on the Ru6Ir/Zn-N-C AEMFCs achieve a peak power density of 1.50 W cm-2, surpassing the state-of-the-art commercial PtRu catalysts and the power ratio of the normalized loading is 14.01 W mgPGM anode -1 or 5.89 W mgPGM -1 after decreasing the anode loading (87.49 µg cm-2) or the total PGM loading (0.111 mg cm-2), satisfying the US Department of Energy's PGM loading target. Moreover, the solvent and solute isotope separation method is used for the first time to reveal the kinetic process of HOR, which shows the reaction is influenced by the adsorption of H2O and OH-. The improvement of the hydrogen bond network connectivity of the electric double layer by adjusting the interfacial H2O structure together with the optimized HBE and OHBE is proposed to be responsible for the high HOR activity of Ru6Ir/Zn-N-C.