Double resonant absorption measurement of acetylene symmetric vibrational states probed with cavity ring down spectroscopy.

A novel mid-infrared/near-infrared double resonant absorption setup for studying infrared-inactive vibrational states is presented. A strong vibrational transition in the mid-infrared region is excited using an idler beam from a singly resonant continuous-wave optical parametric oscillator, to populate an intermediate vibrational state. High output power of the optical parametric oscillator and the strength of the mid-infrared transition result in efficient population transfer to the intermediate state, which allows measuring secondary transitions from this state with a high signal-to-noise ratio. A secondary, near-infrared transition from the intermediate state is probed using cavity ring-down spectroscopy, which provides high sensitivity in this wavelength region. Due to the narrow linewidths of the excitation sources, the rovibrational lines of the secondary transition are measured with sub-Doppler resolution. The setup is used to access a previously unreported symmetric vibrational state of acetylene, ν1+ν2+ν3+ν4 (1)+ν5 (-1) in the normal mode notation. Single-photon transitions to this state from the vibrational ground state are forbidden. Ten lines of the newly measured state are observed and fitted with the linear least-squares method to extract the band parameters. The vibrational term value was measured to be at 9775.0018(45) cm(-1), the rotational parameter B was 1.162 222(37) cm(-1), and the quartic centrifugal distortion parameter D was 3.998(62) × 10(-6) cm(-1), where the numbers in the parenthesis are one-standard errors in the least significant digits.

Optical techniques for breath analysis: from single to multi-species detection.

Optical spectroscopy can be used for trace-level gas analysis in different applications, including exhaled breath research. A common approach is the targeted on-line, real-time analysis of small molecules (two to five atoms). Currently, the methodology is normally used for the detection of single analytes at trace levels, or two to three species at most at the same time. The main limitation preventing sensitive multi-species detection has been the limited fast scanning range of the lasers used as light sources. This limitation is currently being eliminated by the availability of optical frequency combs (OFC) which offer wide spectral bandwidths and the benefits of a laser-type light source. Recent advances in mid-infrared OFC technology allow measurements in the so-called molecular fingerprint region of the electromagnetic spectrum, where many molecules have strong fundamental vibrational transitions that enable sensitive detection. Several technical hurdles remain to be overcome, but if these problems can be solved laser absorption spectroscopy has the potential to challenge mass spectrometry in on-line multi-species trace gas analysis.

Biochemical pathways of breath ammonia (NH3) generation in patients with end-stage renal disease undergoing hemodialysis.

Breath ammonia (NH3) has been proposed as a potential biomarker in monitoring hemodialysis (HD) adequacy, since a strong correlation between blood urea and mouth-exhaled breath NH3 has been observed in patients with end-stage renal disease (ESRD) undergoing HD. However, the biochemical pathways for breath NH3 generation from blood urea have not been demonstrated. In this study, we show a strong correlation (r s = 0.77, p < 0.001) between blood and salivary urea, indicating that salivary urea levels reflect blood urea levels. Salivary urea is in turn strongly correlated to salivary ammonia ([Formula: see text] + NH3) in most of the patients. This confirms that the hydrolysis of urea by urease generates ammonia in the oral cavity. A further strong correlation between salivary ammonia and breath NH3 indicates that salivary ammonia evaporates into gas phase and turns to breath NH3. Therefore, blood urea is a major biochemical source of breath NH3. Since breath NH3 is generated predominantly in the oral cavity, the levels of breath NH3 are influenced significantly by the patient's oral condition including urease activity and salivary pH. Our results agree with previous studies that have shown a connection between salivary urea and breath NH3.

Hydrogen cyanide in the headspace of oral fluid and in mouth-exhaled breath.

Mouth-exhaled hydrogen cyanide (HCN) concentrations have previously been reported to originate from the oral cavity. However, a direct correlation between the HCN concentration in oral fluid and in mouth-exhaled breath has not been explicitly shown. In this study, we set up a new methodology to simultaneously measure HCN in the headspace of oral fluid and in mouth-exhaled breath. Our results show that there is a statistically significant correlation between stimulated oral fluid HCN and mouth-exhaled HCN (rs = 0.76, p < 0.001). This confirms that oral fluid is the main contributor to mouth-exhaled HCN. Furthermore, we observe that after the application of an oral disinfectant, both the stimulated oral fluid and mouth-exhaled HCN concentrations decrease. This implies that HCN production in the oral cavity is related to the bacterial and/or enzymatic activity.

The origin of mouth-exhaled ammonia.

It is known that the oral cavity is a production site for mouth-exhaled NH3. However, the mechanism of NH3 production in the oral cavity has been unclear. Since bacterial urease in the oral cavity has been found to produce ammonia from oral fluid urea, we hypothesize that oral fluid urea is the origin of mouth-exhaled NH3. Our results show that under certain conditions a strong correlation exists between oral fluid urea and oral fluid ammonia (NH4(+)+NH3) (rs = 0.77, p < 0.001). We also observe a strong correlation between oral fluid NH3 and mouth-exhaled NH3 (rs = 0.81, p < 0.001). We conclude that three main factors affect the mouth-exhaled NH3 concentration: urea concentration, urease activity and oral fluid pH. Bacterial urease catalyses the hydrolysis of oral fluid urea to ammonia (NH4(+)+NH3). Oral fluid ammonia (NH4(+)+NH3) and pH determine the concentration of oral fluid NH3, which evaporates from oral fluid into gas phase and turns to mouth-exhaled NH3.

Ammonia in breath and emitted from skin.

Ammonia concentrations in exhaled breath (eNH3) and skin gas of 20 healthy subjects were measured on-line with a commercial cavity ring-down spectrometer and compared to saliva pH and plasma ammonium ion (NH(+)4), urea and creatinine concentrations. Special attention was given to mouth, nose and skin sampling procedures and the accurate quantification of ammonia in humid gas samples. The obtained median concentrations were 688 parts per billion by volume (ppbv) for mouth-eNH3, 34 ppbv for nose-eNH3, and 21 ppbv for both mouth- and nose-eNH3 after an acidic mouth wash (MW). The median ammonia emission rate from the lower forearm was 0.3 ng cm(-2) min(-1). Statistically significant (p < 0.05) correlations between the breath, skin and plasma ammonia/ammonium concentrations were not found. However, mouth-eNH3 strongly (p < 0.001) correlated with saliva pH. This dependence was also observed in detailed measurements of the diurnal variation and the response of eNH3 to the acidic MW. It is concluded that eNH3 as such does not reflect plasma but saliva and airway mucus NH(+)4 concentrations and is affected by saliva and airway mucus pH. After normalization with saliva pH using the Henderson-Hasselbalch equation, mouth-eNH3 correlated with plasma NH(+)4, which points to saliva and plasma NH(+)4 being linked via hydrolysis of salivary urea.

Background levels and diurnal variations of hydrogen cyanide in breath and emitted from skin.

The hydrogen cyanide (HCN) concentration in exhaled human breath and skin gas samples collected with different sampling techniques was measured using near-infrared cavity ring-down spectroscopy. The median baseline HCN concentrations in samples provided by 19 healthy volunteers 2-4 h after the last meal depended on the employed sampling technique: 6.5 parts per billion by volume (ppbv) in mixed (dead space and end-tidal) mouth-exhaled breath collected to a gas sampling bag, 3.9 ppbv in end-tidal mouth-exhaled breath, 1.3 ppbv in end-tidal nose-exhaled breath, 1.0 ppbv in unwashed skin and 0.6 ppbv in washed skin samples. Diurnal measurements showed that elevated HCN levels are to be expected in mouth-exhaled breath samples after food and drink intake, which suggests HCN generation in the oral cavity. The HCN concentrations in end-tidal nose-exhaled breath and skin gas samples were correlated, and it is concluded that these concentrations best reflect systemic HCN levels.

Acetylene in breath: background levels and real-time elimination kinetics after smoking.

We have measured the acetylene concentration in the exhaled breath of 40 volunteers (31 non-smokers, nine smokers) using near-infrared cavity ring-down spectroscopy. The acetylene levels were found to be the same as in ambient air for non-smokers, whereas elevated levels were observed for smokers. Real-time measurements with sub-second time resolution have been applied to measure the elimination kinetics of acetylene in breath after exposure to tobacco smoke. Three exponential time constants can be distinguished from the data and these can be used to define the residence times for different compartments, according to the multi-compartment model of the human body.