Ultrafast thin-disk multipass amplifier with 720 mJ operating at kilohertz repetition rate for applications in atmospheric research.

We present an ultrafast thin-disk based multipass amplifier operating at a wavelength of 1030 nm, designed for atmospheric research in the framework of the Laser Lightning Rod project. The CPA system delivers a pulse energy of 720 mJ and a pulse duration of 920 fs at a repetition rate of 1 kHz. The 240 mJ seed pulses generated by a regenerative amplifier are amplified to the final energy in a multipass amplifier via four industrial thin-disk laser heads. The beam quality factor remains ∼ 2.1 at the output. First results on horizontal long-range filament generation are presented.

HV discharges triggered by dual- and triple-frequency laser filaments.

We study the use of frequency upconversion schemes of near-IR picosecond laser pulses and compare their ability to guide and trigger electric discharges through filamentation in air. Upconversion, such as Second Harmonic Generation, is favorable for triggering electric discharges for given amount of available laser energy, even taking into account the losses inherent to frequency conversion. We focus on the practical question of optimizing the use of energy from a given available laser system and the potential advantage to use frequency conversion schemes.

Active pump-seed-pulse synchronization for OPCPA with sub-2-fs residual timing jitter: erratum.

In the original manuscript, a residual RMS timing jitter below 2 fs between pump and seed pulses in the stabilized case was claimed. Following a reevaluation of the data, this was underestimated. Due to a rounding error in the calibration routine, a miscalculated calibration factor was extracted. By using a higher precision, the updated residual timing jitter amounts to 2.76 fs, or sub-3 fs. In this erratum, the calibration routine is briefly reviewed and Fig. 4, which presents the timing jitter in the stabilized and unstabilized case, is updated. All other results remain unaffected.

Thin-disk pumped optical parametric chirped pulse amplifier delivering CEP-stable multi-mJ few-cycle pulses at 6 kHz.

We present an optical parametric chirped pulse amplifier (OPCPA) delivering CEP-stable ultrashort pulses with 7 fs, high energies of more than 1.8 mJ and high average output power exceeding 10 W at a repetition rate of 6 kHz. The system is pumped by a picosecond regenerative thin-disk amplifier and exhibits an excellent long-term stability. In a proof-of-principle experiment, high harmonic generation is demonstrated in neon up to the 61st order.

CEP-stable, sub-6 fs, 300-kHz OPCPA system with more than 15 W of average power.

We report on a CEP-stable OPCPA system reaching multi-GW peak powers at 300 kHz repetition rate. It delivers 15 W of average power, over 50 µJ of compressed pulse energy and a pulse duration below 6 fs. By implementing an additional pump-seed-synchronization, the output parameters are stabilized over hours with power fluctuations of less than 1.5%.

Active pump-seed-pulse synchronization for OPCPA with sub-2-fs residual timing jitter.

Short-pulse-pumped optical parametric chirped pulse amplification (OPCPA) requires a precise temporal overlap of the interacting pulses in the nonlinear crystal to achieve stable performance. We present active synchronization of the ps-pump pulses and the broadband seed pulses used in an OPCPA system with a residual timing jitter below 2 fs. This unprecedented stability was achieved utilizing optical parametric amplification to generate the error signal, requiring less than 4 pJ of seed- and 10 µJ of pump-pulse-energy in the optical setup. The synchronization system shows excellent long-term performance and can be easily implemented in almost any OPCPA system.

Laser-guided lightning.

Lightning discharges between charged clouds and the Earth's surface are responsible for considerable damages and casualties. It is therefore important to develop better protection methods in addition to the traditional Franklin rod. Here we present the first demonstration that laser-induced filaments-formed in the sky by short and intense laser pulses-can guide lightning discharges over considerable distances. We believe that this experimental breakthrough will lead to progress in lightning protection and lightning physics. An experimental campaign was conducted on the Säntis mountain in north-eastern Switzerland during the summer of 2021 with a high-repetition-rate terawatt laser. The guiding of an upward negative lightning leader over a distance of 50 m was recorded by two separate high-speed cameras. The guiding of negative lightning leaders by laser filaments was corroborated in three other instances by very-high-frequency interferometric measurements, and the number of X-ray bursts detected during guided lightning events greatly increased. Although this research field has been very active for more than 20 years, this is the first field-result that experimentally demonstrates lightning guided by lasers. This work paves the way for new atmospheric applications of ultrashort lasers and represents an important step forward in the development of a laser based lightning protection for airports, launchpads or large infrastructures.