RESUMO
Medieval combat sport is a form of mixed martial art in which combatants engage in fighting using offensive and defensive equipment while dressed in full armor. The sport is considered extremely taxing, making it nearly impossible to maintain the same level of performance. However, this form of sport has not been thoroughly analyzed, and its impact on human physical response is largely unknown. To address this gap, the study reported here aimed to introduce and test a procedure for analyzing human physical responses within the framework of the sport. To accomplish this, two experienced combatants were asked to engage in a series of strikes, performed in the form of a set duel simulating a professional fight competition. The kinematic aspect of the procedure was examined using motion analysis with the help of an IMU suit, while the physiological aspect was evaluated based on blood lactate levels and heart rate measurements. Furthermore, an ergometer test conducted in a laboratory setting aimed to determine the lactate threshold. The duel results showed noticeable decreases in the kinematic aspects of the strikes, such as the velocity of impact, and a dramatic rise in physiological aspects, such as heart rate and blood lactate levels. During the duel sets, the blood lactate surpassed the threshold level, and at the end, the heart rate exceeded the maximum age-related level. Practicing medieval combat sport has been shown to impose an extreme physical load on the bodies of combatants, noticeably affecting their performance levels.
Assuntos
Frequência Cardíaca , Ácido Láctico , Artes Marciais , Humanos , Artes Marciais/fisiologia , Frequência Cardíaca/fisiologia , Fenômenos Biomecânicos/fisiologia , Ácido Láctico/sangue , Masculino , Adulto , Monitorização Fisiológica/métodos , Monitorização Fisiológica/instrumentaçãoRESUMO
The estimation of the parameters of a simulation model such that the model's behaviour matches closely with reality can be a cumbersome task. This is due to the fact that a number of model parameters cannot be directly measured, and such parameters might change during the course of operation in a real system. Friction between different machine components is one example of these parameters. This can be due to a number of reasons, such as wear. Nevertheless, if one is able to accurately define all necessary parameters, essential information about the performance of the system machinery can be acquired. This information can be, in turn, utilised for product-specific tuning or predictive maintenance. To estimate parameters, the augmented discrete extended Kalman filter with a curve fitting method can be used, as demonstrated in this paper. In this study, the proposed estimation algorithm is applied to estimate the characteristic curves of a directional control valve in a four-bar mechanism actuated by a fluid power system. The mechanism is modelled by using the double-step semi-recursive multibody formulation, whereas the fluid power system under study is modelled by employing the lumped fluid theory. In practise, the characteristic curves of a directional control valve is described by three to six data control points of a third-order B-spline curve in the augmented discrete extended Kalman filter. The results demonstrate that the highly non-linear unknown characteristic curves can be estimated by using the proposed parameter estimation algorithm. It is also demonstrated that the root mean square error associated with the estimation of the characteristic curve is 0.08% with respect to the real model. In addition, all the errors in the estimated states and parameters of the system are within the 95% confidence interval. The estimation of the characteristic curve in a hydraulic valve can provide essential information for performance monitoring and maintenance applications.
RESUMO
This work utilizes a simplified, streamlined approach to study the mechanical cost of transport in human walking. Utilizing the kinematic motion data of the center of mass, velocities and accelerations are determined using kinematic analysis; the applied force is then obtained using inverse dynamics. We calculate the mechanical cost of transport per step from both synthetic and measured data, using a very simple mechanical model of walking. The approach studied can serve as an informative gait characteristic to monitor rehabilitation in human walking.
Assuntos
Marcha , Caminhada , Humanos , Fenômenos Biomecânicos , Movimento (Física)RESUMO
In multibody system dynamics, the equations of motion are often coupled with systems of other physical nature, such as hydraulics. To infer the real dynamical state of such a coupled multibody system at any instant of time, information fusing techniques, such as state estimators, can be followed. In this procedure, data is combined from the coupled multibody model and the physical sensors installed on the actual machine. This paper proposes a novel state estimator developed by combining a multibody model with an indirect Kalman filter in the framework of hydraulically driven systems. An indirect Kalman filter that utilizes the exact Jacobian matrix of the plant at position and velocity level is extended for hydraulically actuated systems. The structures of the covariance matrices of the plant and measurement noise are also studied. The multibody system, described using a semi-recursive formulation, and the hydraulic subsystem, described using lumped fluid theory, are coupled using a monolithic approach. As a case study, the state estimator is applied to a hydraulically actuated four-bar mechanism. The state estimator considers modeling errors in the force model because of its uncertainty in modeling. The measurements are obtained from a dynamic model which is considered as the ground truth, with an addition of white Gaussian noise to represent the noise properties of the actual sensors. The state estimator uses four sensor configurations with different sampling rates. For the presented case study, the state estimator can accurately estimate the work cycle and hydraulic pressures of the coupled multibody system. The results demonstrate the efficacy of the proposed state estimator.
RESUMO
Age-related reduction in muscle force generation capacity is similarly evident across different lower limb muscle groups, yet decline in locomotor performance with age has been shown to depend primarily on reduced ankle extensor muscle function. To better understand why ageing has the largest detrimental effect on ankle joint function during locomotion, we examined maximal ankle and knee extensor force development during a two-leg hopping test in older and young men, and used these forces as a reference to calculate relative operating efforts for the knee and ankle extensors as participants walked, ran and sprinted. We found that, across locomotion modes in both age groups, ankle extensors operated at a greater relative effort compared to knee extensors; however, slightly less pronounced differences between ankle and knee extensor muscle efforts were present among older men, mainly due to a reduction in the ankle extensor force generation during locomotion modes. We consider these findings as evidence that reduced ankle push-off function in older age is driven by a tendency to keep ankle extensor effort during locomotion lower than it would otherwise be, which, in turn, may be an important self-optimisation strategy to prevent locomotor-induced fatigue of ankle extensor muscles.
Assuntos
Envelhecimento , Tornozelo/fisiologia , Desempenho Atlético , Locomoção , Músculo Esquelético/fisiologia , Adulto , Idoso , Atletas , Voluntários Saudáveis , Humanos , Pessoa de Meia-Idade , Adulto JovemRESUMO
Interest in producing heat and power using municipal wastewater sewage sludge as a fuel is increasing worldwide. Since its water content is initially high, sludge must be dewatered and further dried if it is to serve as an effective fuel for combustion. However, to maximize net energy production, the drying processes must use as little energy as possible. The water content in sewage sludge comprises both unbound and bound water. Unbound water content is typically extracted using a number of mechanical dewatering techniques. In terms of total solids content (TS), dewatering processes can take sludge from an initial 3-5% to a more solid 25-45% TS with minimal energy expenditure. However, this level of dryness is not sufficient for effective combustion. To produce an effective fuel, TS levels must be increased. Achieving high level of dryness involves removing any remaining unbound water and substantial bound water content as well. Heat is normally applied to accomplish this by changing the phase of the water from liquid to vapor. Although dewatering is energy-efficient, thermal drying is not. The energy used to thermally dry sludge can be two orders of magnitude greater than the energy used for dewatering. Therefore, to expend as little energy as possible to achieve the needed dryness, conventional dewatering processes clearly must be improved. This paper describes work carried out to identify promising ways to efficiently enhance the dewatering and drying of sewage sludge. Available dewatering approaches were reviewed and experiments were carried out to examine the relative effects of temperature, atmospheric pressure, and high-power ultrasound. The high-power ultrasound approach seemed to be particularly effective. The mechanisms involved include atomization, microstructural effects, cavitation, and the sponge effect, which work to reduce both internal and external resistances. Applied in the right way, ultrasound could become a very effective way to enhance mechanical dewatering.
RESUMO
A fairly clean ice cover can form over a contaminated water pond when the air-cooled surface of water freezes and impurities are efficiently expelled to the remaining water underneath. Natural freeze crystallization has recently been studied as a potential wastewater purification method with aqueous solutions on a laboratory scale. The effect of impurity inclusions on ice strength has been researched in model ice basins over the past few decades. It is of interest to discover how efficiently natural freeze separation works under real weather conditions before freezing can be utilized for wastewater treatment application. Herein, understanding the mechanical strength properties of naturally frozen wastewater (ice) is important when planning ice breaking and harvesting devices. This research implemented in-situ measurements of the flexural and compressive strength of ice in natural ice-covered environments of a freshwater lake, two peatlands and three mining site basins, and compares the determined strength with analyzed impurities of the ice. The results showed that despite varying ice growth conditions and initial water constituents, it was possible to deduce an evident yet simple relationship between mean ice strength and ice impurities: the more impure the ice is, the lower the value of strength is Based on this exploration, it was concluded that separation efficiencies, i.e. the impurity removal ratio between basin water and ice, from 65% up to 90% can be achieved by natural freezing.
Assuntos
Gelo , Águas Residuárias , Cristalização , Congelamento , ÁguaRESUMO
INTRODUCTION: The knee and ankle extensors as human primary antigravity muscle groups are of utmost importance in a wide range of locomotor activities. Yet, we know surprisingly little about how these muscle groups work, and specifically, how close to their maximal capacities they function across different modes and intensity of locomotion. Therefore, to advance our understanding of locomotor constraints, we determined and compared relative operating efforts of the knee and ankle extensors during walking, running, and sprinting. METHODS: Using an inverse dynamics biomechanical analysis, the muscle forces of the knee and ankle extensors during walking (1.6 m·s), running (4.1 m·s), and sprinting (9.3 m·s) were quantified and then related to maximum forces of the same muscle groups obtained from a reference hopping test that permitted natural elastic limb behavior. RESULTS: During walking, the relative effort of the ankle extensors was almost two times greater compared with the knee extensors (35% ± 6% vs 19% ± 5%, P < 0.001). Changing walking to running decreased the difference in the relative effort between the extensor muscle groups, but still, the ankle extensors operated at a 25% greater level than the knee extensors (84% ± 12% vs 63% ± 17%, P < 0.05). At top speed sprinting, the ankle extensors reached their maximum operating level, whereas the knee extensors still worked well below their limits, showing a 25% lower relative effort compared with the ankle extensors (96% ± 11% vs 72% ± 19%, P < 0.01). CONCLUSIONS: Regardless of the mode of locomotion, humans operate at a much greater relative effort at the ankle than knee extensor muscles. As a consequence, the great demand on ankle extensors may be a key biomechanical factor limiting our locomotor ability and influencing the way we locomote and adapt to accommodate compromised neuromuscular system function.
Assuntos
Tornozelo/fisiologia , Joelho/fisiologia , Músculo Esquelético/fisiologia , Corrida/fisiologia , Caminhada/fisiologia , Adulto , Fenômenos Biomecânicos , Humanos , Locomoção/fisiologia , Masculino , Contração Muscular/fisiologiaRESUMO
Ageing leads to a progressive decline in human locomotor performance. However, it is not known whether this decline results from reduced joint moment and power generation of all lower limb muscle groups or just some of them. To further our understanding of age-related locomotor decline, we compare the amounts of joint moments and powers generated by lower limb muscles during walking (self-selected), running (4 m s(-1)) and sprinting (maximal speed) among young, middle-aged and old adults. We find that age-related deficit in ankle plantarflexor moment and power generation becomes more severe as locomotion change from walking to running to sprinting. As a result, old adults generate more power at the knee and hip extensors than their younger counterparts when walking and running at the same speed. During maximal sprinting, young adults with faster top speeds demonstrate greater moments and powers from the ankle and hip joints, but interestingly, not from the knee joint when compared with the middle-aged and old adults. These findings indicate that propulsive deficit of ankle contributes most to the age-related locomotor decline. In addition, reduced muscular output from the hip rather than from knee limits the sprinting performance in older age.