Synthesis and Applications of III-V Nanowires.

Low-dimensional semiconductor materials structures, where nanowires are needle-like one-dimensional examples, have developed into one of the most intensely studied fields of science and technology. The subarea described in this review is compound semiconductor nanowires, with the materials covered limited to III-V materials (like GaAs, InAs, GaP, InP,...) and III-nitride materials (GaN, InGaN, AlGaN,...). We review the way in which several innovative synthesis methods constitute the basis for the realization of highly controlled nanowires, and we combine this perspective with one of how the different families of nanowires can contribute to applications. One reason for the very intense research in this field is motivated by what they can offer to main-stream semiconductors, by which ultrahigh performing electronic (e.g., transistors) and photonic (e.g., photovoltaics, photodetectors or LEDs) technologies can be merged with silicon and CMOS. Other important aspects, also covered in the review, deals with synthesis methods that can lead to dramatic reduction of cost of fabrication and opportunities for up-scaling to mass production methods.

InGaN Platelets: Synthesis and Applications toward Green and Red Light-Emitting Diodes.

In this work, we present a method to synthesize arrays of hexagonal InGaN submicrometer platelets with a top c-plane area having an extension of a few hundred nanometers by selective area metal-organic vapor-phase epitaxy. The InGaN platelets were made by in situ annealing of InGaN pyramids, whereby InGaN from the pyramid apex was thermally etched away, leaving a c-plane surface, while the inclined {101̅1} planes of the pyramids were intact. The as-formed c-planes, which are rough with islands of a few tens of nanometers, can be flattened with InGaN regrowth, showing single bilayer steps and high-quality optical properties (full width at half-maximum of photoluminescence at room temperature: 107 meV for In0.09Ga0.91N and 151 meV for In0.18Ga0.82N). Such platelets offer surfaces having relaxed lattice constants, thus enabling shifting the quantum well emission from blue (as when grown on GaN) to green and red. For single InGaN quantum wells grown on the c-plane of such InGaN platelets, a sharp interface between the quantum well and the barriers was observed. The emission energy from the quantum well, grown under the same conditions, was shifted from 2.17 eV on In0.09Ga0.91N platelets to 1.95 eV on In0.18Ga0.82N platelets as a result of a thicker quantum well and a reduced indium pulling effect on In0.18Ga0.82N platelets. On the basis of this method, prototype light-emitting diodes were demonstrated with green emission on In0.09Ga0.91N platelets and red emission on In0.18Ga0.82N platelets.

Dependence of resonance energy transfer on exciton dimensionality.

We investigate the dependence of resonance energy transfer from Wannier-Mott excitons to an organic overlayer on exciton dimensionality. We exploit the excitonic potential disorder in a single quantum well to tune the balance between localized and free excitons by scaling the Boltzmann distribution of excitons through temperature. Theoretical calculations predict the experimentally observed temperature dependence of resonance energy transfer and allow us to quantify the contribution of localized and free excitons. We show that free excitons can undergo resonance energy transfer with an order of magnitude higher rate compared to localized excitons, emphasizing the potential of hybrid optoelectronic devices utilizing resonance energy transfer as a means to overcome charge transfer related limitations.

Growth of GaN nanotubes by halide vapor phase epitaxy.

We have investigated low temperature growth of GaN nanostructures using halide vapor phase epitaxy on c-oriented Al(2)O(3) and Au coated Al(2)O(3) substrates. Depending on the III/V ratio and the growth temperature, the shape and density of the structures could be controlled. By increasing the GaCl partial pressure, the structure changed from dot-like to nanotubes. The nanotubes, which could be open or closed, were about 1 µm long with a diameter of typically 200 nm. In addition, it was observed that the nanostructures were spontaneously nucleated at droplets of Ga or, when using Au coated Al(2)O(3), on droplets of Au/Ga alloy. By varying the growth temperature, the inner diameter of the nanotubes could be controlled. The experimental results suggest that this approach with pre-patterned Au coated Al(2)O(3)substrates has the potential for fabrication of well-organized nanotubes with a high density.

Realization of Ultrahigh Quality InGaN Platelets to be Used as Relaxed Templates for Red Micro-LEDs.

In this work, arrays of predominantly relaxed InGaN platelets with indium contents of up to 18%, free from dislocations and offering a smooth top c-plane, are presented. The InGaN platelets are grown by metal-organic vapor phase epitaxy on a dome-like InGaN surface formed by chemical mechanical polishing of InGaN pyramids defined by 6 equivalent {101̅1} planes. The dome-like surface is flattened during growth, through the formation of bunched steps, which are terminated when reaching the inclined {101̅1} planes. The continued growth takes place on the flattened top c-plane with single bilayer surface steps initiated at the six corners between the c-plane and the inclined {101̅1} planes, leading to the formation of high-quality InGaN layers. The top c-plane of the as-formed InGaN platelets can be used as a high-quality template for red micro light-emitting diodes.

Spatially resolved Hall effect measurement in a single semiconductor nanowire.

Efficient light-emitting diodes and photovoltaic energy-harvesting devices are expected to play an important role in the continued efforts towards sustainable global power consumption. Semiconductor nanowires are promising candidates as the active components of both light-emitting diodes and photovoltaic cells, primarily due to the added freedom in device design offered by the nanowire geometry. However, for nanowire-based components to move past the proof-of-concept stage and be implemented in production-grade devices, it is necessary to precisely quantify and control fundamental material properties such as doping and carrier mobility. Unfortunately, the nanoscale geometry that makes nanowires interesting for applications also makes them inherently difficult to characterize. Here, we report a method to carry out Hall measurements on single core-shell nanowires. Our technique allows spatially resolved and quantitative determination of the carrier concentration and mobility of the nanowire shell. As Hall measurements have previously been completely unavailable for nanowires, the experimental platform presented here should facilitate the implementation of nanowires in advanced practical devices.

Enhancement of the luminescence intensity of InAs/GaAs quantum dots induced by an external electric field.

InAs/GaAs quantum dots have been subjected to a lateral external electric field in low-temperature microphotoluminescence measurements. It is demonstrated that the dot PL signal could be increased several times depending on the magnitude of the external field and the strength of the internal (built-in) electric field, which could be altered by an additional infrared illumination of the sample. The observed effects are explained by a model that accounts for the essentially faster lateral transport of the photoexcited carriers achieved in an electric field.

Effects of separate carrier generation on the emission properties of InAs/GaAs quantum dots.

Individual quantum dots have been studied by means of microphotoluminescence with dual-laser excitation. The additional infrared laser influences the dot charge configuration and increases the dot luminescence intensity. This is explained in terms of separate generation of excess electrons and holes into the dot from the two lasers. With increasing dot density and/or sample temperature, the increase of the luminescence intensity vanishes progressively, while the possibility to control the dot charge remains.