Alamouti-coded DSP algorithm with a simplified PTBC decoder for next-generation optical access networks.

The use of Alamouti-coded polarization-time block code (A-PTBC) in combination with a simple single polarization coherent receiver enables phase-diverse coherent detection without any optical polarization tracking. However, applying this technique to high-speed single-carrier systems is not straightforward, as it requires specialized digital signal processing (DSP) algorithms for data recovery, which increases DSP complexity. In this paper, we propose a novel Alamouti-coded coherent algorithm designed to significantly reduce the complexity of the receiver DSP for data recovery. The proposed algorithm achieves the comparable performance to the conventional algorithm but requires only half the number of necessary equalizers for data recovery. We validate its performance through simulations and also experimentally demonstrate a 100 Gb/s 16-quadrature amplitude modulation (QAM) single-carrier coherent system employed the single-polarization coherent receiver over 20 km of standard single-mode fiber (SMF). Through the performance verification, the coherent system with the proposed algorithm exhibits performance comparable to that of the conventional Alamouti-coded coherent system and achieves a power budget of 34 dB when the transmit launch power is set to 7 dBm at a Bit Error Rate (BER) of 1 × 10-2 for 0-20 km fiber transmission.

106.25-Gbps PAM-4 bidirectional optical sub-assembly module with in-line arrangement of optical and electrical interfaces.

We successfully demonstrate a 106.25-Gbps PAM-4 bidirectional optical sub-assembly for optical access networks, including a driver amplifier and an electro-absorption modulated laser for a transmitter, a photodiode and transimpedance amplifier for a receiver, and an optical filter block. For its implementation, we propose design strategies providing an in-line arrangement of optical and electrical interfaces while ensuring optical alignment tolerance for easy assembly and reducing electrical crosstalk between the transmitter and receiver. Measured receiver sensitivity was <-11.4 dBm for the KP4 forward error correction limit during transmitter operation, and measured power penalty of 10-km single-mode fiber transmission was <0.9 dB.

RoF-based indoor distributed antenna system that can simultaneously support 5G mmWave and 6G terahertz services.

The telecommunication society is paving the way toward ultra-high frequency regions, including the millimeter wave (mmWave) and sub-terahertz (sub-THz) bands. Such high-frequency electromagnetic waves induce a variety of physical constraints when they are used in wireless communications. Inevitably, the fiber-optic network is deeply embedded in the mobile network to resolve such challenges. In particular, the radio-over-fiber (RoF)-based distributed antenna system (DAS) can enhance the accessibility of next-generation mobile networks. The inherent benefits of RoF technology enhance the DAS network in terms of practicality and transmission performance by enabling it to support the 5G mmWave and 6G THz services simultaneously in a single optical transport link. Furthermore, the RoF allows the indoor network to be built based on the cascade architecture; thus, a service zone can be easily added on request. This study presents an RoF-based multi-service DAS network and experimentally investigates the feasibility of the proposed system.

Coherent terahertz wireless communication using dual-parallel MZM-based silicon photonic integrated circuits.

Coherent terahertz (THz) wireless communication using silicon photonics technology provides critical solutions for achieving high-capacity wireless transmission beyond 5G and 6G networks and seamless connectivity with fiber-based backbone networks. However, high-quality THz signal generation and noise-robust signal detection remain challenging owing to the presence of inter-channel crosstalk and additive noise in THz wireless environments. Here, we report coherent THz wireless communication using a silicon photonic integrated circuit that includes a dual-parallel Mach-Zehnder modulator (MZM) and advanced digital signal processing (DSP). The structure and fabrication of the dual-parallel MZM-based silicon photonic integrated circuit are systematically optimized using the figure of merit (FOM) method to improve the modulation efficiency while reducing the overall optical loss. The advanced DSP compensates for in-phase and quadrature (IQ) imbalance as well as phase noise by orthogonally decoupling the IQ components in the frequency domain after adaptive signal equalization and carrier phase estimation. The experimental results show a reduction in phase noise that induces degradation of transmission performance, successfully demonstrating error-free 1-m THz wireless transmission with bit-error rates of 10-6 or less at a data rate of 50 Gbps.

Realization of real-time DSP for C-band PAM-4 transmission in inter-datacenter network.

We designed and realized real-time pulse amplitude modulation-4 (PAM-4) digital signal processing (DSP) including forward error correction (FEC) for a C-band inter-datacenter network. The PAM-4 DSP is intended to compensate for chromatic dispersion and provide dispersion tolerance. A decision feedback equalizer (DFE) and maximum likelihood sequence equalizer (MLSE) were employed for the dispersion compensation. A low-density parity check (LDPC) code was used to increase coding gain. The soft-decision Viterbi algorithm (SOVA) was adopted to provide probabilistic information to the LDPC code. For implementation in a real-time field programmable gate arrays (FPGAs), we employed fully parallelized structures. In the design, three LDPC cores were operated in parallel, and the equalizers were also operated with 128 PAM-4 symbols. With the DSP, we empirically proved the feasibility of 25 km transmission without error-floor sign, corresponding to a dispersion compensation capacity of 425 ps/nm. We confirmed 35 km ∼ 85 km error-free transmission for inter-datacenter network.

Demonstration of photonics-aided terahertz wireless transmission system with using silicon photonics circuit.

We experimentally demonstrate the use of silicon photonics circuit (SPC) in the simple and cost-effective photonics-aided Terahertz (THz) wireless transmission system. We perform theoretical investigation (with experimental confirmation) to understand that the system performance is more sensitive to the free space path loss (FSPL) at the THz wireless link than the SPC's insertion loss. The SPC, we design and fabricate, combines two incident optical carriers at different wavelengths and modulates one of two optical carriers with data to transfer, consequently reducing the system footprint that is indeed one of the key challenges that must be tackled for better practicability of the THz communication system. We perform experimental verification to show the feasibility of 40 Gb/s non-return-to-zero (NRZ) on-off-keying (OOK) signal transmission over 1.4 m wireless link for possibly its application in short-reach indoor wireless communication systems utilizing (sub-)THz frequency band such as, e.g., indoor WiFi, distributed antenna/radio systems, rack-to-rack data delivery, etc. The SPC could be further integrated with various photonic elements such as semiconductor optical amplifiers, laser diodes, and photo-mixers, which will enable the path towards all-photonic THz-wave synthesizers.

Demonstration of photonics-aided terahertz wireless transmission system with using silicon photonics circuit: erratum.

We present an erratum for our recent paper [Opt. Express 28, 23397 (2020)] to include funding information in the funding section.

All-fiber 6-mode multiplexers based on fiber mode selective couplers.

All-fiber 6-mode multiplexer composed of two consecutive LP11-mode selective couplers (MSC), two LP21-MSCs and an LP02-MSC is fully characterized by wavelength-swept interferometer technique. The MSCs are fabricated by polished-type fiber couplers coupling LP01 mode of a single mode fiber into a higher-order mode of a few mode fiber. A pair of the mode multiplexers has minimum mode dependent loss of 4 dB and high mode group selectivity of over 15 dB. Mode division multiplexed transmission enabled by the all-fiber mode multiplexers is demonstrated over fiber spans of 117 km employing an in-line multi-mode optical amplifier. 6 modes of 120 Gb/s dual polarization quadrature phase shift keying signals combined with 30 wavelength channels are successfully transmitted.

Reduction of mode partition noise of FP-LD by using Mach-Zehnder interferometer for RSOA-based DWDM applications.

We investigate reduction of mode partition noise of a spectrally sliced Fabry-Perot laser diode (FP-LD) for application to seeded DWDM systems. The proposed scheme for the noise reduction incorporates a fiber-based Mach-Zehnder interferometer (MZI) and a reflective semiconductor optical amplifier (RSOA). The MZI enables to reduce a relative intensity noise (RIN) more than 3 dB with better noise distributions. Experimental results of 10-Gb/s signal transmission exhibit a considerable bit-error-rate (BER) reduction by three orders of magnitude at the given received power. After the noise reduction, the FP-LD is applied to a 10-Gb/s DWDM system as a seed-light-source. In a local-seeding scheme, return-to-zero (RZ) and carrier-suppressed (CS)-RZ signal formats are compared as a function of transmission distance. Furthermore, a back-reflection induced impairment is evaluated in a remote-seeding scheme. We also count the number of useable channels to show the feasibility of DWDM transmission.

800 Gb/s (80 × 10 Gb/s) capacity WDM-PON based on ASE injection seeding.

We demonstrate and characterize 800 Gb/s capacity WDM-PON with an ASE injection seeding. Required total seed power at central office to feeder fiber is 16 dBm for 20 km upstream transmission of 80 channels. We investigate the maximum transmission length according to channels. The transmission length is limited to 39.7 km by intra-channel crosstalk induced by Rayleigh back-scattering, provided that the dispersion is compensated. Also, we investigate the allowable differential path length to evaluate the flexibility of the system.

Pulsed-ASE-seeded DWDM optical system with interferometric noise suppression.

We propose and demonstrate a 10-Gb/s dense wavelength-division-multiplexing (DWDM) optical system based on a pulsed-seed-light source employing a fiber-based Mach-Zehnder interferometer (F-MZI) as an intensity noise suppressor. The transmission results show that the required injection power into a reflective modulator was as low as -18 dBm. The F-MZI can accommodate the polarized seed-light with superior noise characteristics so that the supported DWDM systems double using a single conventional unpolarized seed-light. In addition, an allowable length of the drop fiber is investigated to show the system flexibility.

DWDM-PON at 25 GHz channel spacing based on ASE injection seeding.

We demonstrate a 25 GHz-channel-spaced DWDM-PON based on ASE injection seeding. A 60 km transmission at 1.25 Gb/s per channel is available with a 2nd generation FEC. The major limiting factor is the optical back reflection induced penalty. Thus a high gain reflective modulator and/or relocation of the seed light increase the transmission length. We demonstrated 90 km transmission with relocated seed light to remote node.