Surgical Treatment of Late Developmental Dysplasia of the Hip in Bladder Exstrophy: A Case Report.

CASE: We present a case of an 8-year-old boy with classical bladder exstrophy and a neglected right hip dislocation, exemplifying the risk of missed developmental dysplasia of the hip (DDH) in patients with exstrophy requiring careful orthopaedic oversight. CONCLUSIONS: When treating patients with bladder exstrophy, physicians and surgeons should be vigilant not to miss associated DDH. If this condition requires surgical treatment, preoperative planning with computed tomography scans is vital to uncovering the complexities arising from abnormal pelvic and acetabular anatomy and ensuring successful treatment outcomes.

Numerical study and experimental validation of the size effect of smooth and mode I cracked semi-circular bend specimens.

The edge-cracked semi-circular bend (SCB) specimen subjected to three-point bending loading is used in many applications to measure the fracture behavior of quasi-brittle materials. The main objective of the present work was to study the effect of the crack length to SCB specimen radius ratio (a/R), span to specimen diameter ratio (S/D), and specimen size on its flexural and mode I crack growth behavior. The contour integral method was implemented using the 3-D finite element method to determine the mode I stress intensity factor. In addition, high-strength concrete specimens were experimentally studied to validate the numerical results. The results show that the maximum compression stress is not sensitive to the S/D value, while the tensile stress is very sensitive. The value of S/D is the main parameter controlling the crack driving force (i.e., the crack mouth opening displacement (CMOD) and the normalized stress intensity factor, YI). For the same S/D, the SCB specimen diameter value change has a marginal effect on CMOD and YI. The specimen with S/D = 0.8 showed that it is the most compatible specimen with three-point bending test conditions, regardless of the SCB specimen size. A good agreement between the numerical and experimental results was achieved.

Mechanical and Tribological Behavior of Functionally Graded Unidirectional Glass Fiber-Reinforced Epoxy Composites.

This paper aims to assess experimentally the mechanical and tribological behavior of conventional and functionally graded (FG) polymeric matrix composites reinforced with continuous glass fibers. The small punch test (SPT) and a pin-on-disc device were used in the present work to examine the mechanical and wear behavior, respectively. The hand lay-up technique was used in the present investigation to manufacture the conventional and FG composites. Various wooden looms with different nailed spacing were employed to manufacture the FG composites. According to test type, the FG composite is composed of four and ten layers, with a different glass fiber volume of fraction (Vf%) for each layer. In addition, the finite element simulation based on Hashin's failure criterion and cohesive zone modeling was used to show the progressive failure and give more explanation regarding the flexural behavior of such composites. The present results indicate that the wear rate of an FG composite could be affected by many factors, including the disk speed, applied load, the composite layers number, and average glass fiber volume fraction. On the other hand, the arrangement of layers in the composite materials by variation of Vf% for each layer can improve the wear rate and value of the ultimate load before the fracture of the composite material when subjected to SPT. The experimental and numerical results for all SPT specimens showed that the fracture of the SPT specimens began beneath the punch tip and grew along the fiber direction. The ultimate flexural capacity of FG composites increased by 30% compared with the conventional composites.