Non-aqueous selective synthesis of orthosilicic acid and its oligomers.

Orthosilicic acid (Si(OH)4) and its small condensation compounds are among the most important silicon compounds but have never been isolated, due to their instability. These compounds would be highly useful building blocks for advanced materials if they became available at high purity. Here we show a simple procedure to selectively synthesize orthosilicic acid and its dimer, cyclic trimer and tetramer in organic solvents. Isolation of orthosilicic acid, the dimer and the cyclic tetramer as hydrogen-bonded crystals with tetrabutylammonium halides and the cyclic trimer as solvent-containing crystals is also described. The solid-state structures of these compounds are unambiguously clarified by single crystal X-ray and neutron diffraction studies. The usefulness of orthosilicic acid and its oligomers prepared by the new procedure is demonstrated by the synthesis of functionalized oligosiloxanes.Orthosilicic acid is essential to many natural and synthetic materials but notoriously difficult to isolate, limiting its use in materials synthesis. Here, the authors successfully synthesize and stabilize orthosilicic acid and its oligomers, making available a new family of building blocks for silicon oxide-based materials.

Time-of-Flight Three Dimensional Neutron Diffraction in Transmission Mode for Mapping Crystal Grain Structures.

The physical properties of polycrystalline materials depend on their microstructure, which is the nano- to centimeter scale arrangement of phases and defects in their interior. Such microstructure depends on the shape, crystallographic phase and orientation, and interfacing of the grains constituting the material. This article presents a new non-destructive 3D technique to study centimeter-sized bulk samples with a spatial resolution of hundred micrometers: time-of-flight three-dimensional neutron diffraction (ToF 3DND). Compared to existing analogous X-ray diffraction techniques, ToF 3DND enables studies of samples that can be both larger in size and made of heavier elements. Moreover, ToF 3DND facilitates the use of complicated sample environments. The basic ToF 3DND setup, utilizing an imaging detector with high spatial and temporal resolution, can easily be implemented at a time-of-flight neutron beamline. The technique was developed and tested with data collected at the Materials and Life Science Experimental Facility of the Japan Proton Accelerator Complex (J-PARC) for an iron sample. We successfully reconstructed the shape of 108 grains and developed an indexing procedure. The reconstruction algorithms have been validated by reconstructing two stacked Co-Ni-Ga single crystals, and by comparison with a grain map obtained by post-mortem electron backscatter diffraction (EBSD).

SENJU: a new time-of-flight single-crystal neutron diffractometer at J-PARC.

SENJU is a new single-crystal time-of-flight neutron diffractometer installed at BL18 at the Materials and Life Science Experimental Facility of the Japan Accelerator Research Complex (J-PARC). The diffractometer was designed for precise crystal and magnetic structure analyses under multiple extreme sample environments such as low temperature, high pressure and high magnetic field, and for diffraction measurements of small single crystals down to 0.1 mm3 in volume. SENJU comprises three choppers, an elliptical shape straight supermirror guide, a vacuum sample chamber and 37 scintillator area detectors. The moderator-to-sample distance is 34.8 m, and the sample-to-detector distance is 800 mm. The wavelength of incident neutrons is 0.4-4.4 Š(first frame). Because short-wavelength neutrons are available and the large solid angle around the sample position is covered by the area detectors, a large reciprocal space can be simultaneously measured. Furthermore, the vacuum sample chamber and collimator have been designed to produce a very low background level. Thus, the measurement of a small single crystal is possible. As sample environment devices, a newly developed cryostat with a two-axis (ω and φ axes) goniometer and some extreme environment devices, e.g. a vertical-field magnet, high-temperature furnace and high-pressure cell, are available. The structure analysis of a sub-millimetre size (0.1 mm3) single organic crystal, taurine, and a magnetic structure analysis of the antiferromagnetic phase of MnF2 have been performed. These results demonstrate that SENJU can be a powerful tool to promote materials science research.