RESUMO
Local chemotherapy using polymer drug delivery systems has the potential to treat some cancers, including intraocular retinoblastoma, which is difficult to treat with systemically delivered drugs. Well-designed carriers can provide the required drug concentration at the target site over a prolonged time, reduce the overall drug dose needed, and suppress severe side effects. Herein, nanofibrous carriers of the anticancer agent topotecan (TPT) with a multilayered structure composed of a TPT-loaded inner layer of poly(vinyl alcohol) (PVA) and outer covering layers of polyurethane (PUR) are proposed. Scanning electron microscopy showed homogeneous incorporation of TPT into the PVA nanofibers. HPLC-FLD proved the good loading efficiency of TPT (≥85%) with a content of the pharmacologically active lactone TPT of more than 97%. In vitro release experiments demonstrated that the PUR cover layers effectively reduced the initial burst release of hydrophilic TPT. In a 3-round experiment with human retinoblastoma cells (Y-79), TPT showed prolonged release from the sandwich-structured nanofibers compared with that from a PVA monolayer, with significantly enhanced cytotoxic effects as a result of an increase in the PUR layer thickness. The presented PUR-PVA/TPT-PUR nanofibers appear to be promising carriers of active TPT lactone that could be useful for local cancer therapy.
RESUMO
Electrospun gelatin and poly-ε-caprolactone (PCL) nanofibers were prepared using needleless technology and their biocompatibility and therapeutic efficacy have been characterized in vitro in cell cultures and in an experimental model of a skin wound. Human dermal fibroblasts, keratinocytes and mesenchymal stem cells seeded on the nanofibers revealed that both nanofibers promoted cell adhesion and proliferation. The effect of nanofibers on wound healing was examined using a full thickness wound model in rats and compared with a standard control treatment with gauze. Significantly faster wound closure was found with gelatin after 5 and 10 days of treatment, but no enhancement with PCL nanofibers was observed. Histological analysis revealed enhanced epithelialisation, increased depth of granulation tissue and increased density of myofibroblasts in the wound area with gelatin nanofibers. The results show that gelatin nanofibers produced by needleless technology accelerate wound healing and may be suitable as a scaffold for cell transfer and skin regeneration.
Assuntos
Materiais Biocompatíveis , Nanofibras , Cicatrização , HumanosRESUMO
Increasing microbial safety and prolonging the shelf life of products is one of the major challenges in the food industry. Active food packaging made from nanofibrous materials enhanced with antimicrobial substances is considered a promising way. In this study, electrospun polyamide (PA) nanofibrous materials functionalized with 2.0 wt% natamycin (NAT), rosemary extract (RE), and green tea extract (GTE), respectively, were prepared as active packaging and tested for the food pathogens Escherichia coli, Listeria monocytogenes, Salmonella enterica, and Staphylococcus aureus. The PAs exhibited: (i) complete retention of bacterial cells reaching 6.0-6.4 log10removal, (ii) antimicrobial activity with 1.6-3.0 log10suppression, and (iii) antibiofilm activity with 1.7-3.0 log10suppression. The PAs prolonged the shelf life of chicken breast; up to 1.9 log10(CFU/g) suppression of total viable colonies and 2.1 log10(CFU/g) suppression of L. monocytogenes were observed after 7 days of storage at 7°C. A beneficial effect on pH and sensory quality was verified. The results confirm microbiological safety and benefits of PA/NAT, PA/RE, and PA/GTE and their potential in developing functional and ecological packaging.
RESUMO
Stable antimicrobial nanofibrous membrane for air filtration based on polyamide 6 (hereafter PA6) modified by 1-dodecyltrimethylammonium bromide (DTAB) has been prepared by electrospinning using one-step technology, i.e. with modifying antimicrobial agent dissolved in spinning solution. Stability of antibacterial membrane function has been tested by air-blowing test to prove the permanency of chemical composition and antibacterial activity. X-ray diffraction, high-resolution scanning electron microscopy (HRSEM) revealed the effect of modifying agent on structure and morphology of PA6 nanofibres. X-ray photoelectron spectroscopy, electrokinetic analysis and antibacterial tests proved the stability of chemical composition and antibacterial activity after air-blowing tests. Special air-blowing device has been constructed for this purpose. The results prove the applicability so prepared membrane for a long-term air-conditioning.
Assuntos
Filtros de Ar , Anti-Infecciosos/química , Caprolactama/análogos & derivados , Membranas Artificiais , Nanofibras/química , Polímeros/química , Caprolactama/químicaRESUMO
Nanofibers were prepared from polycaprolactone, polylactide and polyvinyl alcohol using Nanospider(TM) technology. Polyethylene glycols with molecular weights of 2 000, 6 000, 10 000 and 20 000 g/mol, which can be used to moderate the release profile of incorporated pharmacologically active compounds, served as model molecules. They were terminated by aromatic isocyanate and incorporated into the nanofibers. The release of these molecules into an aqueous environment was investigated. The influences of the molecular length and chemical composition of the nanofibers on the release rate and the amount of released polyethylene glycols were evaluated. Longer molecules released faster, as evidenced by a significantly higher amount of released molecules after 72 hours. However, the influence of the chemical composition of nanofibers was even more distinct - the highest amount of polyethylene glycol molecules released from polyvinyl alcohol nanofibers, the lowest amount from polylactide nanofibers.
RESUMO
Various types of nanofibers are increasingly used in tissue engineering, mainly for their ability to mimic the architecture of tissue at the nanoscale. We evaluated the adhesion, growth, viability, and differentiation of human osteoblast-like MG 63 cells on polylactide (PLA) nanofibers prepared by needle-less electrospinning and loaded with 5 or 15 wt % of hydroxyapatite (HA) nanoparticles. On day 7 after seeding, the cell number was the highest on samples with 15 wt % of HA. This result was confirmed by the XTT test, especially after dynamic cultivation, when the number of metabolically active cells on these samples was even higher than on control polystyrene. Staining with a live/dead kit showed that the viability of cells on all nanofibrous scaffolds was very high and comparable to that on control polystyrene dishes. An enzyme-linked immunosorbent assay revealed that the concentration of osteocalcin was also higher in cells on samples with 15 wt % of HA. There was no immune activation of cells (measured by production of TNF-alpha), associated with the incorporation of HA. Moreover, the addition of HA suppressed the creep behavior of the scaffolds in their dry state. Thus, nanofibrous PLA scaffolds have potential for bone tissue engineering, particularly those with 15 wt % of HA.
Assuntos
Diferenciação Celular , Durapatita/química , Nanofibras/química , Osteoblastos/metabolismo , Poliésteres/química , Substitutos Ósseos , Adesão Celular , Linhagem Celular , Sobrevivência Celular , Humanos , Osteoblastos/citologia , Osteocalcina/biossíntese , Engenharia Tecidual/métodosRESUMO
Cyclosporine A (CsA), a potent immunosuppressive drug with low water solubility, was dissolved in poly(L-lactic acid) (PLA) solution, and nanofibers were fabricated from this mixture by electrospinning technology. The addition of CsA into the PLA solution and the conditions of the electrospinning process did not influence the structure of the nanofibers nor affect the pharmacological activity of CsA. Study of the CsA release behavior in culture medium showed a release for at least 96 h. After the topical application of CsA-loaded nanofibers on skin allografts in vivo, the release was significantly slower and about 35% of the drug was still retained in the nanofibers on day 8. The addition of CsA-loaded nanofibers into cultures of mouse spleen cells stimulated with Concanavalin A selectively inhibited T cell functions; the activity of stimulated macrophages or the growth of non-T-cell populations was not suppressed in the presence of CsA-loaded nanofibers. The covering of skin allografts with CsA-loaded nanofibers significantly attenuated the local production of the proinflammatory cytokines IL-2, IFN-γ and IL-17. These results suggest that CsA-loaded electrospun nanofibers can serve as effective drug carriers for the local/topical suppression of an inflammatory reaction and simultaneously could be used as scaffolds for cell-based therapy.
Assuntos
Ciclosporina/administração & dosagem , Portadores de Fármacos/química , Imunossupressores/administração & dosagem , Ácido Láctico/química , Nanofibras/química , Polímeros/química , Animais , Proliferação de Células/efeitos dos fármacos , Células Cultivadas , Ciclosporina/farmacocinética , Ciclosporina/farmacologia , Citocinas/imunologia , Imunossupressores/farmacocinética , Imunossupressores/farmacologia , Camundongos , Camundongos Endogâmicos BALB C , Camundongos Endogâmicos C57BL , Nanofibras/ultraestrutura , Poliésteres , Transplante de Pele , Linfócitos T/efeitos dos fármacos , Linfócitos T/imunologiaRESUMO
Stem cell (SC) therapy represents a promising approach to treat a wide variety of injuries, inherited diseases, or acquired SC deficiencies. One of the major problems associated with SC therapy remains the absence of a suitable matrix for SC growth and transfer. We describe here the growth and metabolic characteristics of mouse limbal stem cells (LSCs) and mesenchymal stem cells (MSCs) growing on 3D nanofiber scaffolds fabricated from polyamide 6/12 (PA6/12). The nanofibers were prepared by the original needleless electrospun Nanospider technology, which enables to create nanofibers of defined diameter, porosity, and a basis weight. Copolymer PA6/12 was selected on the basis of the stability of its nanofibers in aqueous solutions, its biocompatibility, and its superior properties as a matrix for the growth of LSCs, MSCs, and corneal epithelial and endothelial cell lines. The morphology, growth properties, and viability of cells grown on PA6/12 nanofibers were comparable with those grown on plastic. LSCs labeled with the fluorescent dye PKH26 and grown on PA6/12 nanofibers were transferred onto the damaged ocular surface, where their seeding and survival were monitored. Cotransfer of LSCs with MSCs, which have immunosuppressive properties, significantly inhibited local inflammatory reactions and supported the healing process. The results thus show that nanofibers prepared from copolymer PA6/12 represent a convenient scaffold for growth of LSCs and MSCs and transfer to treat SC deficiencies and various ocular surface injuries.