The extracellular matrix of the oleolytic biofilms of Marinobacter hydrocarbonoclasticus comprises cytoplasmic proteins and T2SS effectors that promote growth on hydrocarbons and lipids.

The assimilation of the nearly water insoluble substrates hydrocarbons and lipids by bacteria entails specific adaptations such as the formation of oleolytic biofilms. The present article reports that the extracellular matrix of an oleolytic biofilm formed by Marinobacter hydrocarbonoclasticus at n-hexadecane-water interfaces is largely composed of proteins typically cytoplasmic such as translation factors and chaperones, and a lesser amount of proteins of unknown function that are predicted extra-cytoplasmic. Matrix proteins appear to form a structured film on hydrophobic interfaces and were found mandatory for the development of biofilms on lipids, alkanes and polystyrene. Exo-proteins secreted through the type-2 secretion system (T2SS) were shown to be essential for the formation of oleolytic biofilms on both alkanes and triglycerides. The T2SS effector involved in biofilm formation on triglycerides was identified as a lipase. In the case of biofilm formation on n-hexadecane, the T2SS effector is likely involved in the mass transfer, capture or transport of alkanes. We propose that M. hydrocarbonoclasticus uses cytoplasmic proteins released by cell lysis to form a proteinaceous matrix and dedicated proteins secreted through the T2SS to act specifically in the assimilation pathways of hydrophobic substrates.

Impact of temperature on Marinobacter hydrocarbonoclasticus SP17 morphology and biofilm structure during growth on alkanes.

Alkanes are widespread pollutants found in soil, freshwater and marine environments. Marinobacter hydrocarbonoclasticus (Mh) strain SP17 is a marine bacterium able to use many hydrophobic organic compounds, including alkanes, through the production of biofilms that allow their poor solubility to be overcome. This study pointed out that temperature is an environmental factor that strongly affects the biofilm formation and morphology of Mh on the model alkanes, hexadecane and paraffin. We showed that Mh biofilm formation and accumulation of intracytoplasmic inclusions are higher on solid alkanes (hexadecane at 10 °C and paraffin at 10 °C and 30 °C) than on liquid alkane (hexadecane at 30 °C) or soluble substrate (lactate at both temperatures). We also found that Mh produces more extracellular polymeric substances at 30 °C than at 10 °C on alkanes and none on lactate. We observed that bacterial length is significantly higher at 10 °C than at 30 °C on lactate and hexadecane. On paraffin, at 30 °C, the cell morphology is markedly altered by large rounded or irregularly shaped cytoplasmic inclusions. Altogether, the results showed that Mh is able to adapt and use alkanes as a carbon source, even at low temperature.

Induction of fatty acid composition modifications and tolerance to biocides in Salmonella enterica serovar Typhimurium by plant-derived terpenes.

To enhance food safety and stability, the food industry tends to use natural antimicrobials such as plant-derived compounds as an attractive alternative to chemical preservatives. Nonetheless, caution must be exercised in light of the potential for bacterial adaptation to these molecules, a phenomenon previously observed with other antimicrobials. The aim of this study was to characterize the adaptation of Salmonella enterica serovar Typhimurium to sublethal concentrations of four terpenes extracted from aromatic plants: thymol, carvacrol, citral, and eugenol, or combinations thereof. Bacterial adaptation in these conditions was demonstrated by changes in membrane fatty acid composition showing (i) limitation of the cyclization of unsaturated fatty acids to cyclopropane fatty acids when cells entered the stationary phase and (ii) bacterial membrane saturation. Furthermore, we demonstrated an increased cell resistance to the bactericidal activity of two biocides (peracetic acid and didecyl dimethyl ammonium bromide). The implications of membrane modifications in terms of hindering the penetration of antimicrobials through the bacterial membrane are discussed.

Combined effects of long-living chemical species during microbial inactivation using atmospheric plasma-treated water.

Electrical discharges in humid air at atmospheric pressure (nonthermal quenched plasma) generate long-lived chemical species in water that are efficient for microbial decontamination. The major role of nitrites was evidenced together with a synergistic effect of nitrates and H(2)O(2) and matching acidification. Other possible active compounds are considered, e.g., peroxynitrous acid.

Impact on disinfection efficiency of cell load and of planktonic/adherent/detached state: case of Hafnia alvei inactivation by plasma activated water.

This paper describes the effects of initial microbial concentration and planktonic/adherent/detached states on the efficiency of plasma-activated water. This disinfecting solution was obtained by treating distilled water with an atmospheric pressure plasma produced by gliding electric discharges in humid air. The inactivation kinetics of planktonic cells of Hafnia alvei (selected as a bacterial model) were found to be of the first order. They were influenced by the initial microbial concentration. Efficiency decreased when the initial viable population N(0) increased, and the inactivation rate k(max) was linearly modified as a function of Log(10) (N(0)). This relation was used to compare planktonic, adherent, and detached cells independently from the level of population. Bacteria adhering to stainless steel and high-density polyethylene were also sensitive to treatment, but at a lower rate than their free-living counterparts. Moreover, cells detached from these solid substrates exhibited an inactivation rate lower than that of planktonic cells but similar to adherent bacteria. This strongly suggests the induction of a physiological modification to bacteria during the adhesion step, rendering adherent--and further detached--bacteria less susceptible to the treatment, when compared to planktonic bacteria.

Effects of pH and oil-in-water emulsions on growth and physicochemical cell surface properties of Listeria monocytogenes: Impact on tolerance to the bactericidal activity of disinfectants.

This study characterizes the effects of an acidic pH and an emulsified oil-in-water phase in a culture medium on the behavior of Listeria monocytogenes. Two strains were tested, Scott A and CIP 78.39, and exhibited similar responses to growth media. First of all, the results showed that the emulsified oil phase had no effect on growth kinetics, whereas acidification of the initial pH (from 7.2 to 5.2) reduced both growth rates and growth yields. Secondly, physicochemical cell surface properties were evaluated. Growth in an emulsion resulted in a more marked increase in hydrophobicity in neutral than in acidic media, whereas the electrical charge remained unchanged. Furthermore, growth in acidic media - emulsified or not - induced a reduction in hydrophobicity as well as in the negative charge of cell surfaces. Thirdly, the results showed that tolerance to the bactericidal activity of didecyl dimethyl ammonium bromide (DDAB) and sodium dichloroisocyanuric acid (NaDCC) was strongly dependent on the pH of the growth phase. Acidic stress during growth increased tolerance to both disinfectants, but to a greater extent with DDAB than with NaDCC. Moreover, the presence of an emulsion during growth at an acidic pH had no effect on subsequent strain tolerance to disinfectants. By contrast, when the pH of the emulsion was neutral, the oil phase induced a more marked reduction in the tolerance of both strains to DDAB, but the reverse applied with NaDCC. Taken together, these results indicate a clear link between modifications to cell surface properties and tolerance to disinfectants, related to the hydrophobicity and electrical charges of both bacterial cells and disinfectants.

Evidence of temporal postdischarge decontamination of bacteria by gliding electric discharges: application to Hafnia alvei.

This study aimed to characterize the bacterium-destroying properties of a gliding arc plasma device during electric discharges and also under temporal postdischarge conditions (i.e., when the discharge was switched off). This phenomenon was reported for the first time in the literature in the case of the plasma destruction of microorganisms. When cells of a model bacterium, Hafnia alvei, were exposed to electric discharges, followed or not followed by temporal postdischarges, the survival curves exhibited a shoulder and then log-linear decay. These destruction kinetics were modeled using GinaFiT, a freeware tool to assess microbial survival curves, and adjustment parameters were determined. The efficiency of postdischarge treatments was clearly affected by the discharge time (t*); both the shoulder length and the inactivation rate k(max) were linearly modified as a function of t*. Nevertheless, all conditions tested (t* ranging from 2 to 5 min) made it possible to achieve an abatement of at least 7 decimal logarithm units. Postdischarge treatment was also efficient against bacteria not subjected to direct discharge, and the disinfecting properties of "plasma-activated water" were dependent on the treatment time for the solution. Water treated with plasma for 2 min achieved a 3.7-decimal-logarithm-unit reduction in 20 min after application to cells, and abatement greater than 7 decimal logarithm units resulted from the same contact time with water activated with plasma for 10 min. These disinfecting properties were maintained during storage of activated water for 30 min. After that, they declined as the storage time increased.

Relation between bacterial strain resistance to solvents and biodesulfurization activity in organic medium.

Microorganisms used in biodesulfurization of petroleum products have to withstand high concentrations of hydrocarbons. The capacities of seven desulfurizing strains of Rhodococcus to be active in the presence of solvents were evaluated. Octanol and toluene (log P=2.9) were selected as toxic solvents. The effect of the solvents was determined by measuring either inhibition of growth or the decrease in respiratory activity of the cells. Differences among strains in their resistance to solvent responses were observed, but these variations were dependent on the test used. Resistance to solvents was then compared to the capacity of the different strains to retain biodesulfurization activity in the presence of hexadecane. Inhibition of desulfurization by high concentrations of hexadecane was found to be well correlated to the sensitivity of the strains to respiration inhibition by toluene, but not to growth inhibition. This result also showed that the respirometric test was a rapid and reliable test to select solvent-resistant strains for use as resting cells in biocatalysis processes, such as biodesulfurization, in organic media.