RESUMO
BACKGROUND: Alloplastic chin augmentation is the most common esthetic surgical treatment to reshape the chin. However, factory-made chin implants are typically standardized rather than custom-made and have potential to cause complications. Although the fabrication of custom-made implants by using computer-assisted planning and 3D-printing technology has become widespread, the process has several disadvantages, including long preoperative prosthesis preparation times, high costs, and unsuitability for patients with asymmetric chins or those who undergo combined mandibuloplasty before implant placement. The present study developed an innovative chin augmentation technique involving stacked expanded polytetrafluoroethylene (e-PTFE) sheets that is suitable for most patients and has minimal side effects. MATERIALS AND METHODS: A retrospective review of a single surgeon's experience was performed over a 2 year period for patients who underwent a procedure involving piled-up e-PTFE sheets for alloplastic chin augmentation. This study analyzed the outcomes, complications (temporary nerve numbness, wound infection, hematoma formation, and implant displacement), and patient satisfaction during follow-up. RESULTS: Between January 2018 and December 2020, 38 patients underwent the procedure involving piled-up e-PTFE sheets for alloplastic chin augmentation. Six patients (15.8%) experienced nerve-related temporary numbness, and one (2.6%) experienced wound infection. None had developed major complications such as implant displacement or wound infection at follow-up. Moreover, the patients demonstrated a high level of satisfaction with the surgical results. CONCLUSION: Piled-up e-PTFE sheets can be used to produce custom-fit porous polyethylene chin implants that result in minimal complications and a very high satisfaction rate. LEVEL OF EVIDENCE IV: This journal requires that authors assign a level of evidence to each article. For a full description of these Evidence-Based Medicine ratings, please refer to the Table of Contents or the online Instructions to Authors www.springer.com/00266 .
Assuntos
Politetrafluoretileno , Desenho de Prótese , Humanos , Estudos Retrospectivos , Feminino , Adulto , Masculino , Queixo/cirurgia , Pessoa de Meia-Idade , Estética , Satisfação do Paciente , Próteses e Implantes , Adulto Jovem , Resultado do TratamentoRESUMO
RATIONALE: Currently, there is no consensus regarding the best treatment for patients with thromboangiitis obliterans (TAO). Regenerative medicine, such as bone marrow stem cells or adipose-derived stem cell (ASC) transplantation, have proven efficacy in improving tissue perfusion and wound healing in clinical trials. In this case, we used nanofat grafting to treat severe conditions in a patient with TAO, with promising outcomes. PATIENT CONCERNS: This is a case of a 48-year-old smoker who presented with cyanosis in both hands and the right foot, with gangrenous changes. Investigative angiography showed severe vasospasm in the radial and ulnar arteries of the patient's left hand. Progressive cyanosis of the patient's left hand was noted which may eventually require amputation if left untreated. DIAGNOSES: He was diagnosed with TAO under the Shionoya diagnostic criteria. INTERVENTIONS: Fasciotomy and necrotic tissue debridement were performed, followed by centrifuged nanofat grafting. The nanofat graft was prepared using Pallua method and deployed with a MAFT-GUN (Dermato Plastica Beauty Co., Ltd., Kaohsiung, Taiwan). OUTCOMES: Three months later, computed tomography angiography revealed a radial artery patency. The patient's wrist function was preserved with uneventful wound healing. LESSONS: The regenerative ability of centrifuged nanofat grafts not only helps wound healing but also helps reverse vasospasm and preserve remnant tissue perfusion.