RESUMO
We experiment the interaction between a liquid puddle and a spherical probe by Atomic Force Microscopy (AFM) for a probe radius R ranging from 10 nm to 30 µm. We have developed a new experimental setup by coupling an AFM with a high-speed camera and an inverted optical microscope. Interaction force-distance curves (in contact mode) and frequency shift-distance curves (in frequency modulation mode) are measured for different bulk model liquids for which the probe-liquid Hamaker constant H_{pl} is known. The experimental results, analyzed in the frame of the theoretical model developed in Phys. Rev. Lett. 108, 106104 (2012)PRLTAO0031-900710.1103/PhysRevLett.108.106104 and Phys. Rev. E 85, 061602 (2012)PLEEE81539-375510.1103/PhysRevE.85.061602, allow to determine the "jump-to-contact" critical distance d_{min} below which the liquid jumps and wets the probe. Comparison between theory and experiments shows that the probe-liquid interaction at nanoscale is controlled by the liquid interface deformation. This work shows a very good agreement between the theoretical model and the experiments and paves the way to experimental studies of liquids at the nanoscale.
RESUMO
This paper describes a fast and one-step technique to grow single gold filaments at the apex of commercial conductive AFM tips. It is implemented with an atomic force microscope in air with a high relative humidity at room temperature and is based on a bias-assisted electro-reduction of gold ions directly at the tip apex. The technique requires only ad hoc substrates made of a mesoporous silica layer loaded with gold salt deposited on a conductive electrode. It leads to the growth, at the tip apex, of filaments whose length can be monitored and controlled during the growth between tens and hundreds of nanometers and whose radius of curvature can be as low as 3 nm. Made of polycrystalline gold nanostructures, the filaments are chemically and mechanically stable and conductive.
RESUMO
During the observation of glassy cholesteric liquid crystals in transmission electron microscopy (TEM), a new contrast is created or enhanced by electron radiation which has a direct relationship with the periodic microstructure of the specimen. In this paper, we investigate the variations of the sample thickness and mass density as possible causes of this irradiation contrast. By means of observations in atomic force microscopy (AFM) coupled to TEM, we compared the surface corrugations of non-irradiated and irradiated specimens. It is shown that the final contrast is the result of several processes. including fracture during ultramicrotomy and mass loss during irradiation. Mass loss acts as an etching, and hence results in a decrease of the sample thickness. The etching depends on the initial molecular orientation, thus evidencing the latent structure. An electron channelling mechanism is suggested to explain this behaviour.
RESUMO
A superconducting quantum interference device (SQUID) with single-walled carbon nanotube (CNT) Josephson junctions is presented. Quantum confinement in each junction induces a discrete quantum dot (QD) energy level structure, which can be controlled with two lateral electrostatic gates. In addition, a backgate electrode can vary the transparency of the QD barriers, thus permitting change in the hybridization of the QD states with the superconducting contacts. The gates are also used to directly tune the quantum phase interference of the Cooper pairs circulating in the SQUID ring. Optimal modulation of the switching current with magnetic flux is achieved when both QD junctions are in the 'on' or 'off' state. In particular, the SQUID design establishes that these CNT Josephson junctions can be used as gate-controlled pi-junctions; that is, the sign of the current-phase relation across the CNT junctions can be tuned with a gate voltage. The CNT-SQUIDs are sensitive local magnetometers, which are very promising for the study of magnetization reversal of an individual magnetic particle or molecule placed on one of the two CNT Josephson junctions.