RESUMO
Four-wave mixing is investigated when chirped pump and signal pulses are injected in a photonic crystal fiber. The shot-to-shot stability of the amplified coherent signal was measured by using the dispersive Fourier transform method and compared with numerical simulations. We highlight that the signal-to-noise ratio (SNR) of the pulsed signal increases with the injected power and show that it is not deteriorated through the amplification when the fiber optical parametric amplifier is strongly saturated. The SNR of the signal remains nearly constant after the amplifier.
RESUMO
Temporally coherent supercontinuum sources constitute an attractive alternative to bulk crystal-based sources of few-cycle light pulses. We present a monolithic fiber-optic configuration for generating transform-limited temporally coherent supercontinuum pulses with central wavelength at 1.06 µm and duration as short as 13.0 fs (3.7 optical cycles). The supercontinuum is generated by the action of self-phase modulation and optical wave breaking when pumping an all-normal dispersion photonic crystal fiber with pulses of hundreds of fs duration produced by all-fiber chirped pulsed amplification. Avoidance of free-space propagation between stages confers unequalled robustness, efficiency and cost-effectiveness to this novel configuration. Collectively, the features of all-fiber few-cycle pulsed sources make them powerful tools for applications benefitting from the ultrabroadband spectra and ultrashort pulse durations. Here we exploit these features and the deep penetration of light in biological tissues at the spectral region of 1 µm, to demonstrate their successful performance in ultrabroadband multispectral and multimodal nonlinear microscopy.
RESUMO
A fiber laser system emitting ultrashort femtosecond pulses at 1550 nm with configurable properties has been developed as an excitation source for the two-photon absorption transient current technique (TPA-TCT). The modules of the system are designed to provide the optical specifications required at the output for localized characterization of semiconductor radiation detectors: variation of pulse energy between 10 nJ and 10p J, variation of the pulse repetition rate from 8.2 MHz to single shot, and variation of pulse duration between 300 and 600 fs. The validity of the system as an excitation source in the TPA-TCT is demonstrated by measuring spatially resolved excited charge carriers in a silicon detector.
RESUMO
We report the spectral distribution of the parametric process generated in a photonic crystal fiber pumped by a chirped pulse. The spectral correlation of four-wave mixing has been measured using the dispersive Fourier transform method. From statistical analysis of multiple shot-to-shot spectral measurements, the spectral correlation between the signal and idler photons reveals physical insights into the particular portion of the pump spectrum responsible for generating the four-wave mixing. Therefore, the shape of the correlation map indicates directly the temporal and spectral links between the signal and the pump, which are highly important to design a four-wave mixing based amplifier.
RESUMO
In this paper, we present a theoretical model based on the nonlinear Schrödinger equation to characterize GHz-range passively mode-locked fiber lasers. The modeled cavities of the lasers are configured by a highly doped and polarization-maintaining single fiber of a single type. For different pulse repetition rates, ranging from 1.0 to 10.0 GHz, gain parameters and pump threshold for a stable mode-locked laser emission are studied. Pulse time width, spectral width, and semiconductor saturable absorber mirror (SESAM) properties are defined to achieve stable emission. To experimentally validate our theoretical model, 1.0 and 2.2 GHz laser cavities have been built up and amplified. A stable and robust operation for both frequencies was obtained, and the experimental measurements have been found to match the theoretical predictions. Finally, enhanced environmental stability has been achieved using a cavity temperature control system and an antivibration enclosure.
RESUMO
An intracavity polarizing fiber is proposed to control the emission regime of a passively mode-locked fiber laser. Stable operation in self-starting high and low dispersion soliton mode-locking and 100 GHz multiwavelength regimes is demonstrated through numerical simulations and experimental validation. Mode-locking stability is ensured by a saturable absorber in the ring cavity. The effective selection of operation regime is dynamically carried out by controlling the intracavity polarization state.
Assuntos
Lasers , Modelos Teóricos , Fibras Ópticas , Reprodutibilidade dos Testes , Fatores de TempoRESUMO
Single-wall carbon nanotube deposition on the cladding of optical fibers has been carried out to fabricate an all-fiber nonlinear device. Two different nanotube deposition techniques were studied. The first consisted of repeatedly immersing the optical fiber into a nanotube supension, increasing the thickness of the coating in each step. The second deposition involved wrapping a thin film of nanotubes around the optical fiber. For both cases, interaction of transmitted light through the fiber core with the external coating was assisted by the cladding mode resonances of a tilted fiber Bragg grating. Ultrafast nonlinear effects of the nanotube-coated fiber were measured by means of a pump-probe pulses experiment.
RESUMO
We use self-calibrating dispersion scan to experimentally detect and quantify the presence of pulse train instabilities in ultrashort laser pulse trains. We numerically test our approach against two different types of pulse instability, namely second-order phase fluctuations and random phase instability, where the introduction of an adequate metric enables univocally quantifying the amount of instability. The approach is experimentally demonstrated with a supercontinuum fibre laser, where we observe and identify pulse train instabilities due to nonlinear propagation effects under anomalous dispersion conditions in the photonic crystal fibre used for spectral broadening. By replacing the latter with an all-normal dispersion fibre, we effectively correct the pulse train instability and increase the bandwidth of the generated coherent spectrum. This is further confirmed by temporal compression and measurement of the output pulses down to 15 fs using dispersion scan.
RESUMO
We present a temperature sensor based on two chirped gratings made in optical fibers tapered by fusion. One of the gratings has a metallic shielding and acts as sensor element, whereas the second grating provides a reference signal. The sensor is interrogated by measuring the power reflected by the two gratings, and the system has an accuracy of 0.05 degrees C over a linear operation range of more than 10 degrees C that can be adjusted in the fabrication process.