RESUMO
BACKGROUND: Cardiovascular disease (CVD)-related death rates have been escalating in emerging economies such as India. A strategy to initiate prophylactic medical intervention by direct identification of subclinical atherosclerotic burden may be appropriate in rural populations where assessment based on traditional risk factors is not available. OBJECTIVES: This study sought to investigate the feasibility of performing rapid automated carotid ultrasound studies in a rural setting and to measure the prevalence of carotid plaques and age-specific distribution of carotid intima-media thickness (IMT) as an index of subclinical atherosclerosis. METHODS: Screening of the extracranial carotid system with automated B-mode ultrasound was performed along with health questionnaire assessments in 771 asymptomatic volunteers (ages 40 ± 14 years; 626 men and 145 women) with no known CVD. Measurements of IMT were recorded as the mean of 24 spatial measurements performed over a 1-cm region in the far wall of the common carotid artery at end diastole; the prevalence of the plaque (focal IMT >1.5 mm) was determined. RESULTS: A total of 69 (8.9%) subjects had atherosclerotic plaques. Of these, 16 (2.1%) exhibited bilateral plaques, 28 (3.6%) left carotid plaque only, and 25 (3.2%) had right carotid plaques. Patients even under 50 years showed a high prevalence of carotid plaques (7%), which increased with age (25% and 35% for 51 to 70 and >70 years, respectively). Only 3 (4.3%) participants with plaques were former smokers. Global mean IMT was 0.55 ± 0.13 mm and correlated with age for both left and right carotid arteries (r = 0.61 and 0.60, p < 0.001 for both) in male as well as female subjects (r = 0.70 and 0.67, p < 0.001 for both), respectively. CONCLUSIONS: Rapid community screening for subclinical atherosclerosis is feasible with automated carotid ultrasound examination and may be beneficial in rural communities of industrializing nations where traditional CVD risk factor data are not yet readily available.
RESUMO
The noninvasive measurement of peripheral vascular reactivity, as an indicator of vascular function, provides a valuable tool for cardiovascular screening of at-risk populations. Practical and economical considerations demand that such a test be low-cost and simple to use. To this end, it is advantageous to substitute digital thermal monitoring (DTM) for the more costly and complex Doppler system commonly used for this measurement. A signal processing model was developed to establish the basis for the relationship between finger temperature reactivity and blood flow reactivity following a transient brachial artery occlusion and reperfusion protocol (reactive hyperemia). Flow velocity signals were acquired from the radial artery of human subjects via an 8 MHz Doppler probe while simultaneous DTM signals were acquired from a distal fingertip via DTM sensors. The model transforms the DTM temperature signals into normalized flow signals via a deconvolution method which employs an exponential impulse function. The DTM normalized flow signals were compared to simultaneous, low-frequency, normalized flow signals computed from Doppler sensors. The normalized flow signals, derived from DTM and Doppler sensors, were found to yield similar reactivity responses during reperfusion. The reactivity areas derived from DTM and Doppler sensors, indicative of hyperemic volumes, were found to be within +/- 15%. In conclusion, this signal processing model provides a means to measure vascular reactivity using DTM sensors, that is equivalent to that obtained by more complex Doppler systems.