RESUMO
Q fever (caused by Coxiella burnetii) is thought to have an almost world-wide distribution, but few countries have conducted national serosurveys. We measured Q fever seroprevalence using residual sera from diagnostic laboratories across Australia. Individuals aged 1-79 years in 2012-2013 were sampled to be proportional to the population distribution by region, distance from metropolitan areas and gender. A 1/50 serum dilution was tested for the Phase II IgG antibody against C. burnetii by indirect immunofluorescence. We calculated crude seroprevalence estimates by age group and gender, as well as age standardised national and metropolitan/non-metropolitan seroprevalence estimates. Of 2785 sera, 99 tested positive. Age standardised seroprevalence was 5.6% (95% confidence interval (CI 4.5%-6.8%), and similar in metropolitan (5.5%; 95% CI 4.1%-6.9%) and non-metropolitan regions (6.0%; 95%CI 4.0%-8.0%). More males were seropositive (6.9%; 95% CI 5.2%-8.6%) than females (4.2%; 95% CI 2.9%-5.5%) with peak seroprevalence at 50-59 years (9.2%; 95% CI 5.2%-13.3%). Q fever seroprevalence for Australia was higher than expected (especially in metropolitan regions) and higher than estimates from the Netherlands (2.4%; pre-outbreak) and US (3.1%), but lower than for Northern Ireland (12.8%). Robust country-specific seroprevalence estimates, with detailed exposure data, are required to better understand who is at risk and the need for preventive measures.
Assuntos
Anticorpos Antibacterianos/sangue , Coxiella burnetii/imunologia , Febre Q/epidemiologia , Adolescente , Adulto , Fatores Etários , Idoso , Austrália/epidemiologia , Criança , Pré-Escolar , Feminino , Humanos , Imunoglobulina G/sangue , Lactente , Masculino , Pessoa de Meia-Idade , Grupos Populacionais , Estudos Soroepidemiológicos , Inquéritos e Questionários , Adulto JovemRESUMO
Objective: To assess the association between the concentration of the air pollutant PM2.5 and daily outpatient visits for respiratory disease. Methods: All records of daily outpatient visits to three hospitals in Shenzhen from January 1 to December 31, 2013 were collected. Daily air pollution monitoring and meteorology data from the same period were also collected in Shenzhen. The data were analyzed using a semiparametric generalized additive model with Poisson distribution of time series analysis controlling for long-term and seasonal trends, flu, DOW, public holidays, and meteorological factors. The excess risk(ER)of respiratory disease and its 95% CI value were calculated, along with the incremental increase of 10 µg/m3 in PM2.5 concentration. Results: Number of outpatient visits for respiratory diseases totaled 1 428 672(daily range: 1 790-5 228). The annual average PM2.5 concentration was 40.2 µg/m3(daily range: 7.2-137.1 µg/m3). The lag1 factor had the most significant impact on the lag effect. We estimated that a 10 µ g/m3 increase in day-before PM2.5 concentration was associated with a 1.809%(95% CI: 1.709%-1.909%)ER of visits for respiratory disease. After controlling for other pollutants(NO2, CO, and O3), the effect remained stable. When NO2, CO, and O3 were introduced separately, for every 10 µg/m3 rise in PM2.5 concentration, the excess risk of daily outpatient visits for respiratory disease was 1.814%(95% CI: 1.706%-1.923%), 2.780%(95% CI: 2.668%-2.892%), and 1.513%(95% CI: 1.403%-1.624%), respectively. With simultaneous control of NO2 and O3, NO2 and CO, and CO and O3, for every 10 µg/m3 rise in PM2.5 concentration, the excess risk of respiratory disease was 1.369%(95% CI: 1.242%-1.497%), 2.709%(95% CI: 2.590%-2.828%), and 2.577%(95% CI: 2.452%-2.702%), respectively. With simultaneous control of NO2, CO, and O3, for every 10 µg/m3 rise in PM2.5 concentration, the excess risk of respiratory disease was 2.370%(95% CI: 2.231%-2.509%). Conclusions: PM2.5 can increase the risk of outpatient visits for respiratory disease in Shenzhen.
Assuntos
Poluentes Atmosféricos/efeitos adversos , Poluição do Ar/efeitos adversos , Modelos Teóricos , Pacientes Ambulatoriais/estatística & dados numéricos , Material Particulado/efeitos adversos , Doenças Respiratórias/induzido quimicamente , Poluentes Atmosféricos/análise , Poluição do Ar/análise , China/epidemiologia , Exposição Ambiental , Humanos , Conceitos Meteorológicos , Material Particulado/análise , Doenças Respiratórias/epidemiologia , Estações do AnoRESUMO
Objectives: This study aimed to evaluate the effect of the strategies on COVID-19 outbreak control in Shenzhen, and to clarify the feasibility of these strategies in metropolitans that have high population density and strong mobility. Methods: The epidemic feature of COVID-19 was described by different phases and was used to observe the effectiveness of intervention. Hierarchical spot map was drawn to clarify the distribution and transmission risk of infection sources at different time points. The Susceptible-Exposed-Infectious-Asymptomatic-Recovered model was established to estimate case numbers without intervention and compare with the actual number of cases to determine the effect of intervention. The positive rate of the nucleic acid test was used to reflect the risk of human exposure. A survey on COVID-19 related knowledge, attitude and behaviors were used to estimate the abilities of personal protection and emergency response. Results: The epidemic of COVID-19 in Shenzhen experienced the rising, plateau and decline stage. The case number increased rapidly at the beginning, with short duration of peak period. Although the epidemic curve showed human-to-human transmission, the "trailing" was not obvious. From the spot map, during the intervention period, the source of infection was widely distributed. More cases and higher transmission risk were observed in areas with higher population density. After the effective intervention measures, both infection sources and the risk of transmission decreased. After compared with the estimated case numbers without intervention, actual number proved the COVID-19 control strategies were effective. The positive rate of nucleic acid test for high risk populations decreased and no new cases reported since February 16. Shenzhen citizens had high knowledge, attitude and behavior level, and high protection ability and emergency response. Conclusions: Although the response initiated by the health administration department played a key role at the early stage of the epidemic, it was not enough to contain the outbreak of COVID-19. The first-level emergency response initiated by provincial and municipal government was effective and ensured the start of work resumption after the Spring Festival. Metropolitans like Shenzhen can also achieve the goals of strategies and measures for containment and mitigation of COVID-19.
Assuntos
Betacoronavirus , Controle de Doenças Transmissíveis/métodos , Infecções por Coronavirus/epidemiologia , Planejamento em Desastres , Transmissão de Doença Infecciosa/prevenção & controle , Serviços Médicos de Emergência/organização & administração , Pandemias , Pneumonia Viral/epidemiologia , COVID-19 , China/epidemiologia , Socorristas , Humanos , Pneumonia Viral/prevenção & controle , SARS-CoV-2RESUMO
A new salt-free approach was developed for fabricating conductive paper by layer-by-layer (LBL) assembly of conductive indium tin oxide (ITO) nanoparticles and polyelectrolytes onto wood fibers. Subsequent to the coating procedure, the fibers were manufactured into conductive paper using traditional paper making methods. The wood fibers were first coated with polyethyleneimine (PEI) and then LBL assembled with poly(sodium 4-styrenesulfonate) (PSS) and ITO for several bilayers. The surface charge intensity of both the ITO nanoparticles and the coated wood fibers were evaluated by measuring the zeta-potential of the nanoparticles and short fibers, respectively. The ITO nanoparticles were found to preferentially aggregate on defects on the fiber surfaces and formed interconnected paths, which led to the formation of conductive percolation paths throughout the whole paper. With ten bilayer coatings, the as-made paper was made DC conductive, and its sigma(dc) was measured to be 5.2 x 10(-6) S cm(-1) in the in-plane (IP) direction, while the conductivity was 1.9 x 10(-8) S cm(-1) in the through-the-thickness (TT) direction. The percolation phenomena in these LBL-assembled ITO-coated paper fibers was evaluated using scanning electron microscopy (SEM), current atomic force microscopy (I-AFM), and impedance measurements. The AC electrical properties are reported for frequencies ranging from 0.01 Hz to 1 MHz. A clear transition from insulating to conducting behavior is observed in the AC conductivity.